Search NASA⌕ Search

Engineering topics

Okinaka, Norihiro

Publications and source records attributed to Okinaka, Norihiro.

Methane Hydrates in Alaska

This paper was prepared for the National Petroleum Council's Study on Natural Gas GHG Emissions. Natural gas is the largest primary energy produced in the United States and its use is growing. Yet getting this gas to homes and businesses creates greenhouse gas emissions. That’s why reducing emissions from America’s natural gas is an urgent priority that requires collaborative solutions. The National Petroleum Council brought together a diverse group of stakeholders with the expertise to analyze this complex issue and identify ways to reduce natural gas GHG emissions for all future supply and demand scenarios. The result: actionable consensus on ensuring a lower-emission natural gas system. The study’s research charts a course forward to meaningfully reduce emissions from the natural gas system, contributing significantly to the United States’ ability to achieve its climate goals. The report concludes that through the implementation of existing policies, voluntary commitments, technologies, and market mechanisms, a 63% reduction in methane emissions can be achieved by 2030. The report went further to identify an additional pathway that methane emissions decrease by 70% and carbon dioxide emissions reduce by 33% through 2050.

03 NATURAL GAS↗

Petrophysical and geomechanical properties of gas hydrate-bearing sediments recovered from Alaska North Slope 2018 Hydrate-01 Stratigraphic Test Well

Knowledge of petrophysical and geomechanical properties of gas hydrate-bearing sediments are essential for predicting reservoir response due to gas production from gas hydrate reservoirs. That information will be critical parameters for designing production well completion such as specification of depressurization pump, water storage tank, and mesh size of sand screen. In December 2018, Stratigraphic Test Well Hydrate-01 was drilled in the western part of the Prudhoe Bay Unit, Alaska North Slope as part of the technical planning effort for a future long-term production test by collaborative team of DOE/NETL, USGS, and MH21-S (Boswell et al., 2020, Collett et al., 2020, Okinaka et al., 2020). Data set of logging-while-drilling (LWD) were acquired (Haines et al., 2020, Suzuki et al., 2019) and core sampling depth was determined on-site.Side-wall pressure coring was conducted to recover gas hydrate-bearing sediments from two reservoir sections named Unit-B and Unit-D. A total of 34 cores were successfully recovered by 5 runs of a wire-line deployed pressure corer (CoreVault® System - Halliburton). Core analysis scheme of this project are shown in Figure 1. All cores were quenched in liquid nitrogen while at high pressure in the laboratory of Stratum Reservoir, LLC. at Anchorage (Figure 1, a)). And the cores were removed from the pressure corer autoclave with temperature support of dry ice and stored under liquid nitrogen at atmospheric pressure. 19 damaged cores were processed to index property measurements directly such as grain size, grain density. 4 of another 17 cores were depressurized and trimmed for making a plug to analyze petrophysical properties of host sediments. Unsteady-state permeability test was conducted to obtain relative water permeability to gas and core scale NMR T2 distribution measurement was performed for evaluating pore size distribution at Houston (Figure 1, b)). Remained high quality 13 cores were preserved with gas hydrate for advanced laboratory analysis. National Institute of Advanced Industrial Science and Technology, as a part of the Japanese National Hydrate Research Program (MH21-S, funded by Ministry of Economy, Trade and Industry), received the samples at Sapporo, Japan for advanced core analysis. High-resolution X-ray CT was used to analyze the quality of the samples, which showed undisturbed lithological layers. Cores were lathed into cylindrical shape and distributed for multi property measurements (Figure 1, c)).<p>As a result, sediment from Unit-D is categorized as silty sand at ~37% porosity with ~80% gas hydrate saturation. An average hydration number n = 6.16 was measured by Raman spectroscopy. An average intrinsic permeability of ~400 mD and in situ effective permeability (with hydrate) on the order of ~10 mD. The Unit B recovered cores consisted of well sorted sand at ~40% porosity with ~95% gas hydrate saturation. An average intrinsic permeability of ~1 Darcy and in situ effective permeability on the order of ~30 mD was measured for the Unit B cores. There was a small permeability reduction due to porosity loss with increasing effective stress that simulated consolidation behavior along with depressurization in the highly permeable sandy sediment. The apparent minimum change in porosity and permeability may be caused by the low compressibility of quartz sand grains in the recovered cores. XRD and thermal conductivity analysis also suggested high quartz content. Triaxial compression tests established internal friction angles based on the Mohr-Coulomb's failure criterion, which are 40° for hydrate-bearing sediment and 29.8° for hydrate free sediment.</p>

Yoneda, Jun↗

Alaska North Slope 2018 Hydrate-01 Stratigraphic Test Well: Technical Results

The Hydrate-01 Stratigraphic Test Well was drilled in December 2018 to confirm that a seismically-identified location within the western Prudhoe Bay Unit might be suitable for extended-duration scientific production testing. The well featured the acquisition of a full suite of logging-while-drilling data, collection of side-wall pressure cores, and installation of distributed temperature and distributed acoustic sensor (DTS, DAS) fiber-optic cables. Evaluation of the logging-while-drilling data confirms gas hydrate is present at high saturation in two target sands of high reservoir quality. Acquired logs and samples enable critical petrophysical information to be compiled for input into production models. The well tested two primary targets: the deeper Unit B is highly favorable due to optimal reservoir temperature and minimal observed risk for direct communication with permeable, hydrate-free water-bearing zones. The shallower Unit D provides a secondary target and opportunity to

Boswell, Ray↗

Gas Hydrate Saturation Estimation Form Acoustic Log Data in the 2018 Alaska North Slope Hydrate-01 Stratigraphic Test

Completed in December 2018, the Alaska North Slope Hydrate 01 stratigraphic test well provides a wealth of logging-while-drilling (LWD) data for strata to below the base of gas hydrate stability (BGHS). This well is intended to be the first of three wells drilled for a comprehensive long-term gas hydrate production test conducted by the National Energy Technology Laboratory, the Japan Oil, Gas and Metals National Corporation, and the U.S. Geological Survey (USGS). The Hydrate 01 stratigraphic test well confirmed the presence of gas hydrate in two sand reservoirs within the hydrate stability zone, indicating the suitability of this location for a long-term gas hydrate production test.<p>The USGS, using an effective-medium-theory rock-physics approach, has estimated gas hydrate saturations from compressional (P) and shear (S) wave log data acquired in the Hydrate 01 well. We assume that gas hydrate occurs as pore-filling load-bearing material (i.e., part of the grain matrix). For Unit D, approximately 500 feet above the BGHS, both P-wave and S-wave acoustic logs indicate moderate gas hydrate saturations with S-wave results slightly lower than those for P-waves. For the Unit B, located just above the BGHS, we obtain moderate to high gas hydrate saturation estimates from both sonic logs. Our P-wave saturation estimates agree well with results from electrical-resistivity-based estimates, whereas estimates from nuclear magnetic resonance LWD data generally suggest 5 to 10 percent higher saturations; our S-wave results suggest lower saturations. These differences likely indicate complexities in the form of gas hydrate occurrence within the sediment pore space, potentially including differences between hydrate occurrence in Units D and B.</p>

Haines, Seth↗

Abstract for CRADA between the Japan Oil, Gas, and Metals National Corporation (JOGMEC) and NETL (AGMT-0671)

The US Department of Energy’s National Energy Technology Laboratory (NETL) and the Japan Oil, Gas, and Metals National Corporation (JOGMEC) have long-established gas hydrate R&D programs and both have identified an extended duration scientific field test of depressurization as a key requirement in advancing critical science and technology development objectives. Both Parties recognize that the Alaska North Slope (“ANS”) is the most feasible location on Earth to conduct such a test and that a proven ANS Operator should be engaged to carry out the desired scientific drilling and testing field programs in full compliance with all regulations. Given the unpredictable nature of field programs conducted in harsh operating environments, the parties have executed this CRADA to clearly establish a basic framework of the project goals, and to articulate roles, responsibilities, and decision-making protocols prior to the initiation of a field program. Therefore, this CRADA establishes a project “Steering Committee” to guide major project decision points and allocation of resources; an “R&D Committee” to jointly develop field program technical and scientific plans designed to achieve program objectives; and “Field Representatives” to enable effective, real-time, and collaborative decision making during field programs.

03 NATURAL GAS↗