Search NASA⌕ Search

Engineering topics

Olsen, Bradley D.

Publications and source records attributed to Olsen, Bradley D..

At least 19 records

Engineered selective biotoxin‐binding hydrogels for toxin sequestration

The development of synthetic selective membranes that separate materials of similar sizes, charges, and/or polarities remains a difficult challenge, and looking towards biology provides inspiration for new designs. In this work, a series of cholera toxin binding peptides (CTBPs) are identified, spanning a range of binding inhibitions, and integrated into chemically cross-linked cholera toxin binding gels (CTBGs) via thiol-Michael polycondensation reactions. All gels demonstrate rheological profiles consistent with elastic solids. The CTBGs are probed via small-angle neutron scattering and exhibit a correlation length, ξ, smaller than most proteins (1.3–2.5 nm). Thus, an effective entropic mesh is formed to block non-targeted proteins. However, the CTBGs have a dynamic mesh size, Ξ, that is larger than cholera toxin (CT) to allow the transport of target proteins. The CTBGs with the highest binding inhibitions both show high selectivity and permeation of CT, rejecting all other tested proteins. In total, two new highly selective CTBGs are synthesized and validated for use in cholera toxin remediation. Together, this platform demonstrates the wide applicability of selectively-diffusive materials for difficult separations.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Hindered segmental dynamics in associative protein hydrogels studied by neutron spin-echo spectroscopy

Transient binding between associating macromolecules can cause qualitative changes to chain dynamics, including modes of conformational relaxation and diffusion, through tethering effects imparted by long-range connectivity. Here, in this work, the role of binding on short-time segmental dynamics in associative polymer gels is investigated by neutron spin-echo (NSE) measurements on a class of model artificial coiled-coil proteins with a systematically varied architecture, probing timescales of 0.1–130 ns, and length scales close to the molecular radius of gyration. The results illustrate effects of transient cross-linking on chain dynamics on different timescales, manifested in changes in segmental relaxation behavior with variations in strand length, chain concentration, and sticker distribution (endblock- vs midblock-functionalized). In all gels, a short-time cooperative diffusion mode is seen over all wave vectors, analogous to a semidilute solution, with no transitions seen at any known structural length scale. However, the diffusion coefficients are found to decrease with increasing junction density across all gels, with the strand length and number of stickers per chain in each gel appearing to play a relatively minor role. The slowing of cooperative diffusion with junction density contrasts with classical predictions of a greater restoring force for fluctuation dissipation due to the increased elasticity, suggesting additional effects of the coiled-coil junctions such as an enhancement in local viscosity that slows dynamics. Notably, the relaxation rates for all gels can be rescaled by the interjunction spacing inferred from small-angle neutron scattering, where they collapse onto a master curve suggestive of self-similar dynamics even in networks with different strand lengths and chain architectures. On long timescales (but shorter than the junction exchange time), a slowing of network relaxation is observed, resulting in a nondecaying plateau in the spin-echo amplitude attributed to a freezing of chain dynamics due to tethering. A characteristic length scale corresponding to the extent of dynamic fluctuations is estimated for each gel, which appears to be smaller than the interjunction spacing but similar to the correlation blob size of the overlapping strands. The results indicate an important role of transient binding on molecular-scale dynamics in associative polymer gels, even on timescales shorter than the junction exchange time, in addition to its effects on long-range self-diffusion previously observed.

36 MATERIALS SCIENCE↗

Networks and interfaces as catalysts for polymer materials innovation

Autonomous experimental systems offer a compelling glimpse into a future where closed-loop, iterative cycles—performed by machines and guided by artificial intelligence (AI) and machine learning (ML)—play a foundational role in materials research and development. This perspective draws attention to the roles of networks and interfaces—of and between humans and machines—for the purpose of generating knowledge and accelerating innovation. Polymers, a class of materials with massive global impact, present a unique opportunity for the application of informatics and automation to pressing societal challenges. To develop these networks and interfaces in polymer science, the Community Resource for Innovation in Polymer Technology (CRIPT)—a polymer data ecosystem based on novel polymer data model, representation, search, and visualization technologies—is introduced. The ongoing co-design efforts engage stakeholders in industry, academia, and government to uncover rapidly actionable, high-impact opportunities to build networks, bridge interfaces, and catalyze innovation in polymer technology.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Predicting transport of intra-articularly injected growth factor fusion proteins into human knee joint cartilage

There are no drugs or treatment methods known to prevent the development of post-traumatic osteoarthritis (PTOA), a type of osteoarthritis (OA) that is triggered by traumatic joint injuries and accounts for ~12% of the nearly 600 million OA cases worldwide. Lack of effective drug delivery techniques remains a major challenge in developing clinically effective treatments, but cationic delivery carriers can help overcome this challenge. Scaling up treatments that are effective in in vitro models to achieve success in preclinical in vivo models and clinical trials is also a challenging problem in the field. Here we use a cationic green fluorescent protein (GFP) as a carrier to deliver Insulin-Like Growth Factor 1 (IGF-1), a drug considered as a potential therapeutic for PTOA. GFP-IGF-1 conjugates were first synthesized as fusion proteins with different polypeptide linkers, and their transport properties were characterized in human cartilage explants. In vitro experimental data were used to develop a predictive mathematical transport model that was validated using an independent in vitro experimental data set. In this study, the model was used to predict the transport of these fusion proteins upon intra-articular injection into human knee joints. The predictions included results for the rate and extent of fusion protein penetration into cartilage, and the maximum levels of fusion proteins that would escape into systemic circulation through the joint capsule. Together, our transport measurements and model set the stage for translation of such explant culture studies to in vivo preclinical studies and potentially clinical application.

36 MATERIALS SCIENCE↗

SANS quantification of bound water in water-soluble polymers across multiple concentration regimes

Contrast-variation small-angle neutron scattering (CV-SANS) is a widely used technique for quantifying hydration water in soft matter systems, but it is predominantly applied in the dilute regime or for systems with a well-defined structure factor. Here, CV-SANS was used to quantify the number of hydration water molecules associating with three water-soluble polymers with different critical solution temperatures and types of water–solute interactions in dilute, semidilute, and concentrated solution through the exploration of novel methods of data fitting and analysis. Multiple SANS fitting workflows with varying levels of model assumptions were evaluated and compared to give insight into SANS model selection. These fitting pathways ranged from general, model-free algorithms to more standard form and structure factor fitting. In addition, Monte Carlo bootstrapping was evaluated as a method to estimate parameter uncertainty through simulation of technical replicates. The most robust fitting workflow for dilute solutions was found to be form factor fitting without CV-SANS ( i.e. polymer in 100% D 2 O). For semidilute and concentrated solutions, while the model-free approach can be mathematically defined for CV-SANS data, the addition of a structure factor imposes physical constraints on the optimization problem, suggesting that the optimal fitting pathway should include appropriate form and structure factor models. The measured hydration numbers were consistent with the number of tightly bound water molecules associated with each monomer unit, and the concentration dependence of the hydration number was largely governed by the chemistry-specific interactions between water and polymer. Polymers with weaker water–polymer interactions ( i.e. those with fewer hydration water molecules) were found to have more bound water at higher concentrations than those with stronger water–polymer interactions due to the increase in the number of forced water–polymer contacts in the concentrated system. This SANS-based method to count hydration water molecules can be applied to polymers in any concentration regime, which will lead to improved understanding of water–polymer interactions and their impact on materials design.

36 MATERIALS SCIENCE↗

Predicting Protein–Polymer Block Copolymer Self-Assembly from Protein Properties

Protein–polymer bioconjugate self-assembly has attracted a great deal of attention as a method to fabricate protein nanomaterials in solution and the solid state. To identify protein properties that affect phase behavior in protein–polymer block copolymers, a library of 15 unique protein- b -poly(N-isopropylacrylamide) (PNIPAM) copolymers comprising 11 different proteins was compiled and analyzed. Many attributes of phase behavior are found to be similar among all studied bioconjugates regardless of protein properties, such as formation of micellar phases at high temperature and low concentration, lamellar ordering with increasing temperature, and disordering at high concentration, but several key protein-dependent trends are also observed. In particular, hexagonal phases are only observed for proteins within the molar mass range 20–36 kDa, where ordering quality is also significantly enhanced. While ordering is generally found to improve with increasing molecular weight outside of this range, most large bioconjugates exhibited weaker than predicted assembly, which is attributed to chain entanglement with increasing polymer molecular weight. Additionally, order–disorder transition boundaries are found to be largely uncorrelated to protein size and quality of ordering. However, the primary finding is that bioconjugate ordering can be accurately predicted using only protein molecular weight and percentage of residues contained within β sheets. This model provides a basis for designing protein–PNIPAM bioconjugates that exhibit well-defined self-assembly and a modeling framework that can generalize to other bioconjugate chemistries.

59 BASIC BIOLOGICAL SCIENCES↗

Polymethacrylamide and Carbon Composites that Grow, Strengthen, and Self-Repair using Ambient Carbon Dioxide Fixation

Plants accumulate solid carbon mass and self-repair using atmospheric CO 2 fixation from photosynthesis. Synthetic materials capable of mimicking this property can significantly reduce the energy needed to transport and repair construction materials. Here, a gel matrix containing aminopropyl methacrylamide (APMA), glucose oxidase (GOx), and nanoceria-stabilized extracted chloroplasts that is able to grow, strengthen, and self-repair using carbon fixation is demonstrated. Glucose produced from the embedded chloroplasts is converted to gluconolactone (GL) via GOx, polymerizing with APMA to form a continuously expanding and strengthening polymethacrylamide. The extracted spinach chloroplasts exhibit enhanced stability and produce 12 µg GL mg -1 Chl h -1 after optimization of the temporal illumination conditions and the glucose efflux rate, with the insertion of chemoprotective nanoceria inside the chloroplasts. This system achieves an average growth rate of 60 µm 3 h -1 per chloroplast under ambient CO 2 and illumination over 18 h, thickening with a shear modulus of 3 kPa. This material can demonstrate self-repair using the exported glucose from chloroplasts and chemical crosslinking through the fissures. These results point to a new class of materials capable of using atmospheric CO 2 fixation as a regeneration source, finding utility as self-healing coatings, construction materials, and fabrics.

36 MATERIALS SCIENCE↗

Influence of End-Block Dynamics on Deformation Behavior of Thermoresponsive Elastin-like Polypeptide Hydrogels

End-block association dynamics are known to influence deformation behavior in block copolymer systems. The ability to obtain precisely sequence controlled systems can help inform this deformation behavior, which is often influenced by dispersity in sequence and molar mass. Elastin-like polypeptides (ELPs) are a class of protein that consists of a sequence of five amino acids (XPGVG) that thermoresponsively aggregate in solution. These ELPs can be used as end-blocks in triblock fusion proteins with coiled-coil associating midblock domains to result in dual-associating, network-forming materials. By modifying the standard glycine-containing ELP sequence (XPGVG) to instead contain alanine in the third position of the repeat sequence (XPAVG), it is possible to improve the properties of the material in both shear and extension. In extension at 50 °C, the alanine-containing triblock (A 10 P 4 A 10 ) and the glycine-containing triblock (G 10 P 4 G 10 ) have similar Young’s moduli. However, while G 10 P 4 G 10 yields and breaks within 5 strain units, A 10 P 4 A 10 plastically deforms to an ultimate strain at break of over 15 strain units and a tensile stress of almost 90 kPa. In shear, G 10 P 4 G 10 exhibits a clear stress overshoot at less than one strain unit before plateauing at a steady-state shear stress of 0.43 kPa, while the shear stress of A 10 P 4 A 10 monotonically increases to a shear stress of 48.4 kPa after 2.4 strain units. In shear, these differences in behavior correlate to rearrangement of G 10 P 4 G 10 ’s nanostructure during viscous-dominated flow, while the nanostructure of A 10 P 4 A 10 initially elastically deforms. These differences are a function of the relative network relaxation time scales, where the presence of the faster glycine-containing ELP end-block sequence decreases the network relaxation time such that it occurs on the same order of magnitude as the imposed flow.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗