Engineering topics

Olsen, W.

Publications and source records attributed to Olsen, W..

22 records · Page 2

NASA NTRS1976

Lip noise generated by flow separation from nozzle surfaces

Flow separation from nozzle surfaces can be a source of significant noise in addition to the jet noise. When no flow separation region exists only jet noise is observed at every angle, for velocities down to 120 m/sec, with both low and high levels of initial turbulence. Intense nearly periodic turbulence and noise is caused by flow separation from the thin core nozzle lip of a coaxial nozzle. This can be described by a combination of aeolian tone and trailing edge noise theory. Noise caused by flow separation from the surfaces of other nozzle geometries has somewhat different characteristics.

Olsen, W.↗

NASA NTRS1975

Lip noise generated by flow separation from nozzle surfaces

The results of a series of experiments, performed to investigate flow separation and classic lip noise and to aid in understanding aeroacoustic noise generation are presented. Several types of nozzle-lip configurations were used to study the high frequency noise generated by small regions of flow separation at the nozzle lip. These included coaxial nozzles, and circular and slot nozzles with splitter plates. The jet flow velocity was varied and far field noise was measured for all nozzle-lip geometries (coaxial and splitter plate). The effect of a velocity difference across the lip of the coaxial nozzle and the splitter plate on the far field noise was also measured. Finally, an effort was made to find means to reduce the high frequency noise caused by flow separation at the lip.

Olsen, W.↗

NASA NTRS1974

Jet noise from co-axial nozzles over a wide range of geometric and flow parameters

Free field pure jet noise data were taken for a large range of coaxial nozzle configurations. The core nozzles were circular (1 to 4 in. diameter) and plug types. The fan to core area ratio varied from 0.7 to 43.5, while the velocity ratio typically varied from 0 to 1. For most cases the two nozzles were coplanar but large axial extensions of either nozzle were also tested. Correlation of the data resulted in a simple procedure for estimating ambient temperature subsonic coaxial jet noise spectra over a wide range of geometric and flow parameters.

Olsen, W.↗

NASA NTRS1974

Jet noise from coaxial nozzles over a wide range of geometric and flow parameters

Free field pure jet noise data were taken for a large range of coaxial nozzle configurations. The core nozzles were circular (1 to 4 in. diam.) and plug types. The fan to core area ratio varied from 0.7 to 43.5, while the velocity ratio typically varied from 0 to 1. For most cases the two nozzles were coplanar but large axial extensions of either nozzle were also tested. Correlation of the data resulted in a simple procedure for estimating ambient temperature subsonic coaxial jet noise spectra over a wide range of geometric and flow parameters.

Olsen, W.↗