Engineering topics

Osborne, William P.

Publications and source records attributed to Osborne, William P..

11 records

NASA NTRS1995

Channel fading for mobile satellite communications using spread spectrum signaling and TDRSS

This paper will present some preliminary results from a propagation experiment which employed NASA's TDRSS and an 8 MHz chip rate spread spectrum signal. Channel fade statistics were measured and analyzed in 21 representative geographical locations covering urban/suburban, open plain, and forested areas. Cumulative distribution Functions (CDF's) of 12 individual locations are presented and classified based on location. Representative CDF's from each of these three types of terrain are summarized. These results are discussed, and the fade depths exceeded 10 percent of the time in three types of environments are tabulated. The spread spectrum fade statistics for tree-lined roads are compared with the Empirical Roadside Shadowing Model.

Jenkins, Jeffrey D.↗

NASA NTRS1995

Wideband propagation measurement system using spread spectrum signaling and TDRS

In this paper, a wideband propagation measurement system, which consisted of a ground-based transmitter, a mobile receiver, and a data acquisition system, was constructed. This system has been employed in a study of the characteristics of different propagation environments, such as urban, suburban and rural areas, by using a pseudonoise spreading sequence transmitted over NASA's Tracking and Data Relay Satellite System. The hardware and software tests showed that it met overall system requirements and it was very robust during a 3-month-long outdoor data collection experiment.

Jenkins, Jeffrey D.↗

NASA NTRS1994

Improved small satellite access of the space network

This report contains the results of a study performed under the sponsorship of the National Aeronautics and Space Administration (NASA) made as a grant to the Center for Space Telemetering and Telecommunication Systems at New Mexico State University. The purpose of this phase of the grant is to increase user access to the Space Network (SN) run by NASA for supplying space-to-ground communications for satellites and associated control centers. The identified need is to bring more users into the community of those accessing the SN, especially those in the small satellite class of users. The initial phase of the study concerned the potential for modifications to the standard transponder used in the SN. The results of that investigation are summarized in Section 4. As the hardware modifications were being investigated, a second option was developed, namely to consider changes to the operational mode for the small satellites. This operational concept was to use a single, fixed-pointing antenna in a spin-stabilized satellite and let the antenna pattern sweep past the Tracking and Data Relay Satellites (TDRS) in the SN. The question to be answered by this phase of the study was twofold: could enough contact time per day be made available using this simple operating mode and could the data rate be high enough to allow for sufficient data throughput to satisfy the user community using existing components. Section 2 outlines the methodology and simulation results to answer these questions. Section 3 contains a summary of an operational simulation of a simple satellite payload using these contact scenarios. The simulation is not all inclusive but shows how a payload simulation could be configured to utilize variable contact times. The answer to both of the questions desired to be answered is affirmative. By carefully choosing the correct system transmission power and antenna pattern, the system will allow support to the 50th percentile of expected systems. It is recommended that based on this initial study, further work be done to quantify the exact parameters for transmission through the space network and to optimize usage of the contact time to maximize throughput.

Horan, Stephen↗

NASA NTRS1994

Advanced S-Band studies using the TDRSS communications satellite

This report will describe the design, implementation, and results of a propagation experiment which used TDRSS to transmit spread signals at S-Band to an instrumented mobile receiver. The results consist of fade measurements and distribution functions in 21 environments across the Continental United States (CONUS). From these distribution functions, some idea may be gained about what system designers should expect for excess path loss in many mobile environments. Some of these results may be compared against similar measurements made with narrowband beacon measurements. Such comparisons provide insight into what gains the spread signaling system may or may not have in multipath and shadowing environments.

Jenkins, Jeffrey D.↗

NASA NTRS1994

An analysis of carrier phase jitter in an MPSK receiver utilizing map estimation

The use of 8 and 16 PSK TCM to support satellite communications in an effort to achieve more bandwidth efficiency in a power-limited channel has been proposed. This project addresses the problem of carrier phase jitter in an M-PSK receiver utilizing the high SNR approximation to the maximum aposteriori estimation of carrier phase. In particular, numerical solutions to the 8 and 16 PSK self-noise and phase detector gain in the carrier tracking loop are presented. The effect of changing SNR on the loop noise bandwidth is also discussed. These data are then used to compute variance of phase error as a function of SNR. Simulation and hardware data are used to verify these calculations. The results show that there is a threshold in the variance of phase error versus SNR curves that is a strong function of SNR and a weak function of loop bandwidth. The M-PSK variance thresholds occur at SNR's in the range of practical interest for the use of 8 and 16-PSK TCM. This suggests that phase error variance is an important consideration in the design of these systems.

Osborne, William P.↗

NASA NTRS1994

Issues in the development of a 10 MBPS K=15 Viterbi decoder

The NMSU Telemetry Center, in collaboration with the NASA Microelectronics Center (MRC) at UNM, has completed a study of the feasibility of building a constraint length 15, rate 1/2 Viterbi Decoder (or BVD) to operate at a rate of 10 Mbps. The BVD, if built, would make TDRSS more accessible to all users, small satellites in particular, by providing an additional 2 dB of link margin, relative to the use of the standard constraint length 7 decoder. The study included the following: review of the 1 Mbps BVD built by the Jet Propulsion Laboratory (JPL), currently the only BVD in existence; development of Specifications for the basic processing unit of the BVD (MRC); analytical Determination of performance of large constraint length convolutional codes; investigation of the impact of processor design on the overall system design; and two feasible packaging technologies, proposed by Cincinnati Electronics of Ohio. It was concluded that while the construction of the BVD is feasible, it will require the most advanced packaging technology currently available, and that the project would be best accomplished in an industrial facility. While the size, complexity, and power requirements of the BVD will be extreme, these will impact only the ground station. The spacecraft will incur a minor change in the encoder design, and the increased coding gain will allow a satellite to operate with a smaller antenna.

Osborne, William P.↗

NASA NTRS1993

On the performance of Trellis coded modulation with octal phase shift keying over the TDRSS channel

As the National Aeronautics and Space Administration moves into the 21st century with programs like Space Station Freedom, a manned mission to Mars, and the new Landsat mission, transmission demands on the Tracking and Data Relay Satellite System (TDRSS) will very likely exceed the available bandwidth. The Manual Lujan, Jr. Center for Space Telemetering and Telecommunications Systems (CSTTS) at New Mexico State University (NMSU) is studying techniques for increasing the data rate capabilities of TDRSS. These techniques include the use of advanced bandwidth efficient modulation formats to increase the data rate that can be sustained in a TDRSS transponder and the use of lossless bandwidth compression of the data to be transmitted to lower the data rate required from the user spacecraft. Based upon current technology the most promising bandwidth efficient modulation technique is Trellis Coded Modulation (TCM) operating with Octal Phase shift Keying (8PSK). Trellis Coded Modulation coding with 8PSK carrier modulation has the capability to increase the data rate which can be transmitted through the TDRSS spacecraft by a factor of 2 to 2.5 times that available with todays coded QPSK systems with only a small penalty in link performance relative to the existing systems. However, before NASA can safely employ TCM coding it is necessary to prove that this complex format can perform on the real TDRSS link as it does in labs and simulation studies. This proof-of-concept test over a live satellite channel was the objective of the construction and testing performed under this task of the NMSU NASA grant referenced above. In conjunction with NASA, NMSU's CSTTS has constructed a system to test a new candidate TDRSS modulation scheme, TCM 8PSK, that can enhance the information throughput of the TDRSS spacecraft. The test system for this project which was constructed over a period of 18 months by NMSU consisted of two racks of commercial and univeristy-designed and -built equipment. This project has included modifications of an existing White Sands Ground Terminal (WSGT) High Rate QPSK Demodulator to demodulate 8PSK as well as the construction of other support hardware. Also, two TCM codecs (coder/decoders) have been constructed to implement two levels of bandwidth efficiency. One was designed and built by the research team at NMSU while the other was created by the University of Notre Dame with the University of South Australia. The NMSU codec achieves a 2-to-1 increase in data rate per unit bandwidth with a coding gain relative to QPSK of about 3dB. The Notre Dame/South Australia codec achieves a 2.5-to-1 increase in data rate per unit of occupied bandwidth and a coding gain of about 2dB.

Osborne, William P.↗

NASA NTRS1993

High-speed Viterbi decoding with overlapping code sequences

The Viterbi Algorithm for decoding convolutional codes and Trellis Coded Modulation is suited to VLSI implementation but contains a feedback loop which limits the speed of pipelined architecture. The feedback loop is circumvented by decoding independent sequences simultaneously, resulting in a 5-9 fold speed-up with a two-fold hardware expansion.

Ross, Michael D.↗

NASA NTRS1992

Investigation of Bandwidth-Efficient Coding and Modulation Techniques

The necessary technology was studied to improve the bandwidth efficiency of the space-to-ground communications network using the current capabilities of that network as a baseline. The study was aimed at making space payloads, for example the Hubble Space Telescope, more capable without the need to completely redesign the link. Particular emphasis was placed on the following concepts: (1) what the requirements are which are necessary to convert an existing standard 4-ary phase shift keying communications link to one that can support, as a minimum, 8-ary phase shift keying with error corrections applied; and (2) to determine the feasibility of using the existing equipment configurations with additional signal processing equipment to realize the higher order modulation and coding schemes.

Osborne, William P.↗

NASA NTRS1992

High-speed architecture for the decoding of trellis-coded modulation

Since 1971, when the Viterbi Algorithm was introduced as the optimal method of decoding convolutional codes, improvements in circuit technology, especially VLSI, have steadily increased its speed and practicality. Trellis-Coded Modulation (TCM) combines convolutional coding with higher level modulation (non-binary source alphabet) to provide forward error correction and spectral efficiency. For binary codes, the current stare-of-the-art is a 64-state Viterbi decoder on a single CMOS chip, operating at a data rate of 25 Mbps. Recently, there has been an interest in increasing the speed of the Viterbi Algorithm by improving the decoder architecture, or by reducing the algorithm itself. Designs employing new architectural techniques are now in existence, however these techniques are currently applied to simpler binary codes, not to TCM. The purpose of this report is to discuss TCM architectural considerations in general, and to present the design, at the logic gate level, or a specific TCM decoder which applies these considerations to achieve high-speed decoding.

Osborne, William P.↗

NASA NTRS1991

Telemetering and telecommunications research

The research center activities during the reporting period have been focused in three areas: (1) developing the necessary equipment and test procedures to support the testing of 8PSK-TCM through TDRSS from the WSGT; (2) extending the theoretical decoder work to higher speeds with a design goal of 600MBPS at 2 bits/Hz; and (3) completing the initial phase of the CPFSK Multi-H research and determining what subsets (if any) of these coding schemes are useful in the TDRSS environment. The equipment for the WSGT TCM testing has been completed and is functioning in the lab at NMSU. Measured results to date indicate that the uncoded system with the modified HRD and NMSU symbol sync operates at 1 to 1.5 dB from theory when processing encoded 8PSK. The NMSU pragmatic decoder when combined with these units produces approximately 2.9 dB of coding gain at 10(exp -5) BER. Our study of CPFSK with Multi-H coding has reached a critical stage. The principal conclusions reached in this activity are: (1) no scheme using Multi-H alone investigated by us or found in the literature produces power/bandwidth trades that are as good as TCM with filtered 8PSK; (2) when Multi-H is combined with convolutional coding, one can obtain better coding gain than with Multi-H alone but still no better power/bandwidth performance than TCM and these gains are available only with complex receivers; (3) the only advantage we can find for the CPFSK schemes over filtered MPSK with TCM is that they are constant envelope (however, constant envelope is of no benefit in a multiple access channel and of questionable benefit in a single access channel since driving the TWT to saturation in this situation is generally acceptable); and (4) based upon these results the center's research program will focus on concluding the existing CPFSK studies.

Osborne, William P.↗