Two Ar gas-puff experiments, each using loads consisting of two annuli and a center jet, were recently performed on Sandia National Laboratories' Z machine. These shots had the same load except that one of them (Z2603) employed a Xe dopant of 0.8% by number in the jet, which was not present in the otherwise identical Z2605. The extensive diagnostics deployed in these experiments reveal that the presence of this small fraction of Xe had a significant effect on the emitted K-shell radiation. Use of the Xe dramatically reduced the Ar K-shell yield from 373 ± 9% to 129 ± 9% kJ. However, the total yield increased, from 1.02 ± 17% to 1.14 ± 17% MJ. Also, the K-shell power pulse for Z2603 exhibited two nearly equal peaks separated by ∼5 ns, but that of Z2605 consisted of a more conventional single peak. Analysis of time- and space resolved K-shell spectra using a detailed atomic model for Ar ions indicates that a much greater fraction of the load mass was heated to the K-shell in the non-Xe shot Z2605. Previous average-ion atomic calculations of Xe cooling rates [Post et al., At. Data Nucl. Data Tables 20, 397 (1977)] show that the radiative cooling of the small 0.8% Xe fraction is nonetheless significant compared to that of the Ar and is therefore likely responsible for the differences in the shots.

Apruzese, J. P.↗

DOE OSTI2015

The effect of gradients at stagnation on K-shell x-ray line emission in high-current Ar gas-puff implosions

We report that argon gas puffs have produced 330 kJ ± 9% of x-ray radiation above 3 keV photon energy in fast z-pinch implosions, with remarkably reproducible K-shell spectra and power pulses. This reproducibility in x-ray production is particularly significant in light of the variations in instability evolution observed between experiments. Lastly, soft x-ray power measurements and K-shell line ratios from a time-resolved spectrum at peak x-ray power suggest that plasma gradients in these high-mass pinches may limit the K-shell radiating mass, K-shell power, and K-shell yield from high-current gas puffs.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2014

Diagnostic constraints on the amount of cold mass in imploded argon pinches on Z

The refurbished Z machine at Sandia National Laboratories has been successfully configured to drive gas-puff Z pinches. A series of experiments using Ar loads produced K-shell yields of 330 ± 9% kJ, with highly reproducible K-shell spectra and power pulses. Using spectroscopic and power data, we are able to constrain the properties of both the cold, non-K-shell radiating mass as well as the hot K-shell component of the pinch plasma. As in previous gas-puff shots on the original version of Z, only about 1/4 to 1/3 of the load mass was heated to temperatures sufficient to produce K-shell x-rays.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2014

Radiation from mixed multi-planar wire arrays

The study of radiation from different wire materials in wire array Z-pinch plasma is a very challenging topic because it is almost impossible to separate different plasmas at the stagnation. A new approach is suggested based on planar wire array (PWA) loads to assess this problem. Multi-planar wire arrays are implemented that consist of few planes, each with the same number of wires and masses but from different wire materials, arranged in parallel rows. In particular, the experimental results obtained with triple PWAs (TPWAs) on the UNR Zebra generator are analyzed with Wire Ablation Dynamics Model, non-local thermodynamic equilibrium kinetic model, and 2D radiation magneto-hydrodynamic to illustrate this new approach. In TPWAs, two wire planes were from mid-atomic-number wire material and another plane was from alloyed Al, placed either in the middle or at the edge of the TPWA. Spatial and temporal properties of K-shell Al and L-shell Cu radiations were analyzed and compared from these two configurations of TPWAs. Advantages of the new approach are demonstrated and future work is discussed.

74 ATOMIC AND MOLECULAR PHYSICS↗

DOE OSTI2014

Inner-shell radiation from wire array implosions on the Zebra generator

Implosions of brass wire arrays on Zebra have produced L-shell radiation as well as inner-shell Kα and Kβ transitions. The L-shell radiation comes from ionization stages around the Ne-like charge state that is largely populated by a thermal electron energy distribution function, while the K-shell photons are a result of high-energy electrons ionizing or exciting an inner-shell (1s) electron from ionization stages around Ne-like. The K- and L-shell radiations were captured using two time-gated and two axially resolved time-integrated spectrometers. The electron beam was measured using a Faraday cup. A multi-zone non-local thermodynamic equilibrium pinch model with radiation transport is used to model the x-ray emission from experiments for the purpose of obtaining plasma conditions. These plasma conditions are used to discuss some properties of the electron beam generated by runaway electrons. A simple model for runaway electrons is examined to produce the Kα radiation, but it is found to be insufficient.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗