Time dependence of fast electron beam divergence in ultraintense laser-plasma interactions
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Ovchinnikov, V.
Explore the source record for details and available documents.
High-intensity, short-pulse laser-interaction experiments with small-mass, wedge-shaped-cavity Cu targets are presented. The diagnostics provided spatially and spectrally resolved measurements of the Cu K alpha line emission at 8 keV. The conversion efficiency of short-pulse laser energy into fast electrons was inferred from the x-ray yield for wedge opening angles between 30° and 60° and for s- and p-polarized laser irradiation. Up to 36 7% conversion efficiency was measured for the narrowest wedge with p-polarization. The results are compared with predictions from two-dimensional particle-in-cell simulations.
We have conducted experiments on both the Vulcan and Titan laser facilities to study hot electron generation and transport in the context of fast ignition. Cu wires attached to Al cones were used to investigate the effect on coupling efficiency of plasma surround and the pre-formed plasma inside the cone. We found that with thin cones 15% of laser energy is coupled to the 40{micro}m diameter wire emulating a 40{micro}m fast ignition spot. Thick cone walls, simulating plasma in fast ignition, reduce coupling by x4. An increase of prepulse level inside the cone by a factor of 50 reduces coupling by a factor of 3.
Three independent methods (extreme ultraviolet spectroscopy, imaging at 68 and 256 eV) have been used to measure planar target rear surface plasma temperature due to heating by hot electrons. The hot electrons are produced by ultraintense laser-plasma interactions using the 150 J, 0.5 ps Titan laser. Soft x-ray spectroscopy in the 50-400 eV region and imaging at the 68 and 256 eV photon energies give a planar deuterated carbon target rear surface pre-expansion temperature in the 125-150 eV range, with the rear plasma plume averaging a temperature approximately 74 eV.
Measurements of plasma temperature at the rear surface of foil targets due to heating by hot electrons, which were produced in short pulse high intensity laser matter interactions using the 150 J, 0.5 ps Titan laser, are reported. Extreme ultraviolet (XUV) imaging at 256 and 68 eV energies is used to determine spatially resolved target rear surface temperature patterns by comparing absolute intensities to radiation hydrodynamic modeling. XUV mirrors at these two energies were absolutely calibrated at the Advanced Light Source at the Lawrence Berkeley Laboratory. Temperatures deduced from both imagers are validated against each other within the range of 75-225 eV.
The effect of oxygen on diffusion of sodium implanted into silicon is studied for the first time in the temperature range from 500 to 850{sup o}C. A high-resistivity p-Si ({rho} > 1 k{omega} cm) grown by the Czochralski method in a magnetic field (mCz) with the oxygen concentration {approx}3 x 10{sup 17} cm{sup -3} was used. For comparison, we used silicon grown by the crucibleless floating zone method (fz). Temperature dependences of the effective diffusion coefficient of sodium in the mCz-Si and fz-Si crystals were determined and written as D{sub mCz}[cm{sup 2}/s] = 1.12exp(-1.64 eV/kT) cm{sup 2}/s and D{sub fz}[cm{sup 2}/s] = 0.024exp(-1.29 eV/kT) cm{sup 2}/s, respectively. It is assumed that larger values of diffusion parameters in oxygen-containing silicon are caused by formation of complex aggregates that contain sodium and oxygen atoms.
Experimental results from copper cones irradiated with ultraintense laser light are presented. Spatial images and total yields of Cu K{sub {alpha}} fluorescence were measured as a function of the laser focusing properties. The fluorescence emission extends into the cone approximately 300 {mu}m from the cone tip and cannot be explained by ray tracing including cone wall absorption. In addition, the total fluorescence yield from cones is an order of magnitude higher than for equivalent mass foil targets. Indications are that the physics of the laser-cone interaction is dominated by preplasma created from the long duration, low-energy prepulse from the laser.
The concept for Electron Fast Ignition Inertial Confinement Fusion demands sufficient laser energy be transferred from the ignitor pulse to the assembled fuel core via {approx}MeV electrons. We have assembled a suite of diagnostics to characterize such transfer. Recent experiments have simultaneously fielded absolutely calibrated extreme ultraviolet multilayer imagers at 68 and 256eV; spherically bent crystal imagers at 4 and 8keV; multi-keV crystal spectrometers; MeV x-ray bremmstrahlung and electron and proton spectrometers (along the same line of sight); nuclear activation samples and a picosecond optical probe based interferometer. These diagnostics allow careful measurement of energy transport and deposition during and following laser-plasma interactions at extremely high intensities in both planar and conical targets. Augmented with accurate on-shot laser focal spot and pre-pulse characterization, these measurements are yielding new insight into energy coupling and are providing critical data for validating numerical PIC and hybrid PIC simulation codes in an area that is crucial for many applications, particularly fast ignition. Novel aspects of these diagnostics and how they are combined to extract quantitative data on ultra high intensity laser plasma interactions are discussed, together with implications for full-scale fast ignition experiments.