Search NASA⌕ Search

Engineering topics

Overzet, Lawrence J.

Publications and source records attributed to Overzet, Lawrence J..

Collaborative Research: Fundamental Studies of Plasma Control Using Surface Embedded Electronic Devices

The research program was collaborative between the researchers at the University of Texas at Dallas and the University of Texas at Austin. The primary subject of this program was to investigate the possibility of active control of secondary electron emission (SEE) from surfaces in contact with plasmas and thereby actively control plasmas. Very few studies of ion-induced electron emission (IIEE) from semiconductors exist, and those that do exist primarily used high-energy ion beams in the experiments. Furthermore, those few studies took extreme measures to ensure that the measurements were performed on atomically clean surfaces because of the surface sensitivity of the IIEE process. Even a small exposure to air can change the IIEE yield significantly. In addition, much of the existing data for IIEE from semiconductors was obtained in the 1950s and ‘60s, when semiconductor materials were first being refined. As a result, nearly all of that data is for p-type Ge and Si. Before this investigation, experimental data on n-type materials was virtually non-existent. While the basic theory assumed that IIEE yields ought to be substantially independent of doping type and concentration, recent measurements of near atmospheric pressure plasmas and of breakdown suggested otherwise. These indirect measurements were made on surfaces that were not atomically clean and seemed to indicate that deep sub-surface changes to the bulk conduction band electron density could lead to substantial variations in the IIEE yield. Exactly in contradiction to the generally accepted theory. Insufficient direct data existed to settle the matter. We performed both experimental measurements and theoretical calculations of IIEE yields from both Si and Ge in order to help clarify whether or not conduction band electrons substantially change the IIEE yield. We used three wafers of each material to carry out the investigation: a heavily doped p-type, an intrinsic and a heavily doped n-type wafer. There was approximately a factor of 10 15 difference in the conduction band electron densities of the p-type and n-type Si wafers and a factor of 10 10 for Ge. We investigated semiconductor surfaces that were both chemically cleaned (not atomically clean) and sputter cleaned (much closer to atomically clean), since such measurements are more relevant to recent indirect measurements. In addition to IIEE measurements, X-ray and ultraviolet photoelectron spectroscopies (XPS and UPS) were utilized to better understand the results.

36 MATERIALS SCIENCE↗

Silicon etch using SF{sub 6}/C{sub 4}F{sub 8}/Ar gas mixtures

While plasmas using mixtures of SF{sub 6}, C{sub 4}F{sub 8}, and Ar are widely used in deep silicon etching, very few studies have linked the discharge parameters to etching results. The authors form such linkages in this report. The authors measured the optical emission intensities of lines from Ar, F, S, SF{sub x}, CF{sub 2}, C{sub 2}, C{sub 3}, and CS as a function of the percentage C{sub 4}F{sub 8} in the gas flow, the total gas flow rate, and the bias power. In addition, the ion current density and electron temperature were measured using a floating Langmuir probe. For comparison, trenches were etched of various widths and the trench profiles (etch depth, undercut) were measured. The addition of C{sub 4}F{sub 8} to an SF{sub 6}/Ar plasma acts to reduce the availability of F as well as increase the deposition of passivation film. Sulfur combines with carbon in the plasma efficiently to create a large optical emission of CS and suppress optical emissions from C{sub 2} and C{sub 3}. At low fractional flows of C{sub 4}F{sub 8}, the etch process appears to be controlled by the ion flux more so than by the F density. At large C{sub 4}F{sub 8} fractional flows, the etch process appears to be controlled more by the F density than by the ion flux or deposition rate of passivation film. CF{sub 2} and C{sub 2} do not appear to cause deposition from the plasma, but CS and other carbon containing molecules as well as ions do.

36 MATERIALS SCIENCE↗

Final Report on Project “Micro-Misted Plasmas”

The key subject of this program was an examination of droplet evaporation kinetics in conjunction with plasma characteristics. Specifically, we undertook a careful investigation of the physical interactions between microscopic droplets of evaporating liquids and low pressure environments (including plasmas) by both experiment and simulation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Gain and loss mechanisms for neutral species in low pressure fluorocarbon plasmas by infrared spectroscopy

This article examines the chemical reaction pathways of stable neutral species in fluorocarbon plasmas. Octafluorocyclobutane (c-C{sub 4}F{sub 8}) inductively coupled plasma discharges were found to primarily produce stable and metastable products downstream from the discharge, including c-C{sub 4}F{sub 8}, C{sub 2}F{sub 4}, C{sub 2}F{sub 6}, CF{sub 4}, C{sub 3}F{sub 8}, C{sub 4}F{sub 10}, C{sub 3}F{sub 6}, and CF{sub 2}. A novel analysis technique allows the estimation of gain and loss rates for neutral species in the steady state as functions of residence time, pressure, and discharge power. The gain and loss rates show that CF{sub 4}, C{sub 2}F{sub 6}, C{sub 3}F{sub 8}, and C{sub 4}F{sub 10} share related gain mechanisms, speculated to occur at the surface. Further analysis confirms that CF{sub 2} is predominantly produced at the chamber walls through electron impact dissociation of C{sub 2}F{sub 4} and lost through gas-phase addition reactions to form C{sub 2}F{sub 4}. Additionally, time-resolved FTIR spectra provide a second-order rate coefficient of 1.8 Multiplication-Sign 10{sup -14} cm{sup 3}/s for the gas-phase addition of CF{sub 2} to form C{sub 2}F{sub 4}. Finally, C{sub 2}F{sub 4,} which is much more abundant than CF{sub 2} in the discharge, is shown to be dominantly produced through electron impact dissociation of c-C{sub 4}F{sub 8} and lost through either surface or gas-phase addition reactions.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Role of surface temperature in fluorocarbon plasma-surface interactions

This article examines plasma-surface reaction channels and the effect of surface temperature on the magnitude of those channels. Neutral species CF{sub 4}, C{sub 2}F{sub 6}, and C{sub 3}F{sub 8} are produced on surfaces. The magnitude of the production channel increases with surface temperature for all species, but favors higher mass species as the temperature is elevated. Additionally, the production rate of CF{sub 2} increases by a factor of 5 as the surface temperature is raised from 25 Degree-Sign C to 200 Degree-Sign C. Fluorine density, on the other hand, does not change as a function of either surface temperature or position outside of the plasma glow. This indicates that fluorine addition in the gas-phase is not a dominant reaction. Heating reactors can result in higher densities of depositing radical species, resulting in increased deposition rates on cooled substrates. Finally, the sticking probability of the depositing free radical species does not change as a function of surface temperature. Instead, the surface temperature acts together with an etchant species (possibly fluorine) to elevate desorption rates on that surface at temperatures lower than those required for unassisted thermal desorption.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗