Search NASA⌕ Search

Engineering topics

Paduch, M

Publications and source records attributed to Paduch, M.

Fusion neutron detector for time-of-flight measurements in z-pinch and plasma focus experiments

We have developed and tested sensitive neutron detectors for neutron time-of-flight measurements in z-pinch and plasma focus experiments with neutron emission times in tens of nanoseconds and with neutron yields between 10{sup 6} and 10{sup 12} per one shot. The neutron detectors are composed of a BC-408 fast plastic scintillator and Hamamatsu H1949-51 photomultiplier tube (PMT). During the calibration procedure, a PMT delay was determined for various operating voltages. The temporal resolution of the neutron detector was measured for the most commonly used PMT voltage of 1.4 kV. At the PF-1000 plasma focus, a novel method of the acquisition of a pulse height distribution has been used. This pulse height analysis enabled to determine the single neutron sensitivity for various neutron energies and to calibrate the neutron detector for absolute neutron yields at about 2.45 MeV.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Experimental evidence of thermonuclear neutrons in a modified plasma focus

The PF-1000 plasma focus was modified by adding the cathode disk 3 cm in front of the anode. This modification facilitated the evaluation of neutron energy spectra. Two neutron pulses were distinguishable. As regards the first neutron pulse, it lasted 40 ns during the plasma stagnation and it demonstrated high isotropy of neutron emission. A peak neutron energy detected upstream was 2.46{+-}0.02 MeV. The full width of neutron energy spectra of 90{+-}20 keV enabled to calculate an ion temperature of 1.2 keV. These parameters and a neutron yield of 10{sup 9} corresponded to theoretical predictions for thermonuclear neutrons.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Spatially resolved high-resolution x-ray spectroscopy of high-current plasma-focus discharges

Soft x-ray emission from a Mather-type plasma-focus device (PF-1000) operated at {approx}400 kJ was measured. The high density and temperature plasma were generated by the discharge in the deuterium-argon gas mixture in the modified (high-current) plasma-focus configuration. A spherically bent mica crystal spectrograph viewing the axial output of the pinch region was used to measure the x-ray spectra. Spatially resolved spectra including the characteristic x-ray lines of highly ionized Ar and continua were recorded by means of an x-ray film. The x-ray emission of PF-1000 device was studied at different areas of the pinch.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Neutron Production and Fast Deuteron Characteristics at the Plasma Focus Discharge

This paper summarized the results of interferometry, X-ray and neutron diagnostics performed at the plasma focus facility filled with deuterium. The fusion processes are produced mainly in the dense and hot spherical structure of 2 cm diameter 5-8 cm in front of the anode. The electron temperature of this structure is about 750 eV and the density 5x10{sup 24}-5x10{sup 25}. The neutron energy distribution was calculated using time of flight analysis and showed the dominant direction of the fast deuteron velocity downstream. The deuteron energy distribution was estimated supposing isotropy distribution of the sum of opposite orientation. The total number of fast deuterons in the energy range of 10-400 keV is about 10{sup 18} with total energy of 20 kJ. Plasma in the spherical structure is heated dominantly with ion-ion Coulomb collisions of fast deuterons in the energy range below 10 keV.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Study of D-D Reaction at the Plasma Focus Device

The plasma focus device PF-1000 at IPPLM Warsaw with neutron yields of 10{sup 9}-10{sup 11} neutrons per shot is convenient for the determination of the axial neutron energy distribution in the fusion D-D reaction due to the horizontal position of a discharge axis and the distance of scintillation detectors up to 85 m from the neutron source in both axial (downstream and upstream) directions. In this paper the determination of the axial energy component of the fast deuterons producing neutrons is presented for the shot with a relative small neutron yield and nearly isotropic neutron energy distribution and the total energy of fast deuterons producing neutrons is estimated. We calculated, if the dense structure with the length of 2 cm and the density of 2xl0{sup 25} m{sup -3} could be the source of neutrons. We estimated the upper limit of energy of deuterons producing neutrons as 10-20 keV and their total number as 10{sup 18}. The deuterons with energies below 10-20 keV can't produce high number of neutrons due to the small cross-section of D-D reaction but they can be principally confined by magnetic field. We discuss the influence of magnetic field on the motion of deuterons.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Fast-Neutron Source Based on Plasma-Focus Device

This paper describes investigations of neutrons produced by small plasma focus device PF-6 operating in the Institute of Plasma Physics and Laser Microfusion, Warsaw, Poland. Main parameters of neutron radiation have been measured by scintillation probe, and by activation technique. Current derivative probe has also been applied to measure dI/dt signal. Simultaneously neutron transport calculations have been carried out by Monte Carlo method. Finally, experimental measurements and numerical calculations have allowed concluding that plasma focus devices can be useful pulse neutron sources for different applications.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Damages of Carbon-Tungsten Samples under Influence of Deuterium Ions and Dense Plasma Streams within Plasma-Focus Facility

The paper reports on experimental studies of processes of the interaction of pulsed streams of fast deuterium ions (E{sub i}{approx}100 keV) and dense deuterium plasma (v{sub pl}>10{sup 7} cm/s) with samples made of carbon and tungsten. Experiments were performed in the large PF-1000 plasma-focus facility with the charging energy of 481 kJ and with the pure deuterium filling. Power flux density of plasma/ions streams was q = 10{sup 7}-10{sup 10} W/cm{sup 2} and the pulse length was from 10{sup -7} s to 10{sup -6} s, whereas the duration of heat pulses (due to a secondary plasma at the target's surface) was 10{sup -4} s. The stainless steel, tungsten and carbon-tungsten samples were placed in the zone of their strong melting and evaporation or in the zone without their melting. Each sample was exposed to 1 through 10 discharges, and the irradiated samples were investigated with optical-, electron- and atomic-force-microscopes. The interaction of intense plasma-ion pulses with the carbon-tungsten samples caused the formation of a wave-like relief on sample surfaces, the evident erosion of the sample material, and the creation of numerous micro-cracks. It was also found that about 200-nm-thick layer of the irradiated tungsten sample contained many melted fragments of nm-dimensions. The results might be useful for estimations of tungsten behavior in extreme situations (e.g. disruptions) expected in fusion reactors with magnetic plasma confinement.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Studies of Pulsed Plasma-Ion Streams During Their Free Propagation And Interaction With Carbon-Tungsten Targets In PF-1000 Facility

The paper presents results of recent experimental studies within the PF-1000 plasma-focus facility [1], which were performed during the free propagation of pulsed plasma-ion streams inside the vacuum chamber, and during their interaction with different targets. Optical spectra were recorder by means of a Mechelle registered 900 spectrometer operated with some delays in relation to the discharge current peculiarity (dip) and with exposition varied from 100 ns to 100 {mu}s. The recorded spectral lines were used to estimate the density of the free-propagating plasma stream. The electron concentration, as estimated from the Stark broadening of the D{sub {beta}} line recorded at a distance of z = 30 cm from the electrode ends, changed from about 4x10{sup 17} cm{sup -3} to 2x10{sup 16} cm{sup -3} in about 30 {mu}s. Analogous spectroscopic measurements were carried out in experiments performed with targets made of carbon and sintered tungsten, which were placed at a distance of 15 cm from the electrode outlet, where q = 10{sup 10} W/cm{sup 2}, and at a distance of 30 cm, where q = 10{sup 9} W/cm{sup 2}. Particular attention was paid to investigation of a plasma layer formed in the front of the target. In that case the electron density, as estimated on the basis of carbon-and deuterium-ion lines, changed from about 3x10{sup 18} cm{sup -3} to 3x10{sup 16} cm{sup -3} in 30 {mu}s. For the target made of the sintered tungsten, which was placed at a distance of 30 cm, the recorded optical spectr a showed intense D{sub {alpha}} and D{sub {beta}} lines as well as CII-CIV lines, which covered tungsten (WI and WII) lines.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗