Engineering topics

Pamadi, B. N.

Publications and source records attributed to Pamadi, B. N..

7 records

NASA NTRS1984

Estimation of aerodynamic forces and moments on a steadily spinning airplane

A semiempirical method is presented for the estimation of aerodynamic forces and moments on a steadily rotating airplane model in a spin tunnel. The approach is based on the application of strip theory to determine a part of the aerodynamic coefficient (including rotational velocity) and then estimation of increments to these coefficients because of rotational flow over the stalled airplane. The theory is applied to a light, single-engine, general aviation airplane and the results are compared with the corresponding spin tunnel rotary balance test data.

Pamadi, B. N.↗

NASA NTRS1984

On the prediction of auto-rotational characteristics of light airplane fuselages

A semi-empirical theory is presented for the estimation of aerodynamic forces and moments acting on a steadily rotating (spinning) airplane fuselage, with a particular emphasis on the prediction of its auto-rotational behavior. This approach is based on an extension of the available analytical methods for high angle of attack and side-slip and then coupling this procedure with strip theory for application to a rotating airplane fuselage. The analysis is applied to the fuselage of a light general aviation airplane and the results are shown to be in fair agreement with experimental data.

Pamadi, B. N.↗

NASA NTRS1983

Estimation of parameters involved in high angle-of-attack aerodynamic theory using spin flight test data

The difficulty in applying parameter estimation techniques to spinning airplanes is due in part to the unwieldy number of possible combinations of terms in the equations of motion, when the model structure is unknown. The combination of high angle of attack and high rotation rate results in aerodynamic functions which are quite complex. For wing dominated configurations it is advantageous to use aerodynamic theory to generate the model structure. In this way, the number of unknown parameters is reduced and the model accuracy may be increased. Under conditions for which the theory is inadequate, however, model accuracy may be reduced. Strip theory, for example, is incapable of predicting autorotative rolling moments indicated by wind tunnel tests at angles of attack exceeding 40 degrees. An improved aerodynamic theory would be necessary to successfully apply the technique advanced for such regions.

Taylor, L. W., Jr.↗

NASA NTRS1983

An evaluation of aerodynamics modeling of spinning light airplanes

This paper extends the application of the modified strip theory for wing body combination of a spinning light airplane reported earlier. In addition, to account for the contribution of the tail plane, the shielding effect on vertical tail under steady state spin condition is modeled from basic aerodynamic considerations. The results of this combined analysis, presented for some light airplane configurations, are shown to be in good agreement with spin tunnel rotary balance test data.

Pamadi, B. N.↗

NASA NTRS1982

An estimation of aerodynamic forces and moments on an airplane model under steady state spin conditions

The problem of estimating the aerodynamic characteristics of a wing body configuration of a spinning airplane at extreme angles of attack and spin rates is approached by the application of strip theory. Semiempirical methods are used to estimate the aerodynamic force distributions over each component using static, nonrotational wind-tunnel test data. To these predictions, corrections are applied to account for the primary rotational flow effects which are significant at large spin rates. The results of this modified strip theory are shown to be in good agreement with spin tunnel rotary balance test data.

Pamadi, B. N.↗

NASA NTRS1982

On the impingement of supersonic jet on a normal flat surface

An improved method, based on one strip approximation of the method of integral relations which was reported originally by Belov, Ginzburg and Shub (1973), is presented for the calculation of flow parameters in the impingement region of a supersonic, underexpanded jet striking a normal surface located within the first cell. The results are presented for two impingement conditions and found to be in good agreement with the experimental data.

Pamadi, B. N.↗

NASA NTRS1981

Forebody drag reduction

It is shown that the mechanisms of forebody drag reduction by means of either a spike or a forward-facing jet are similar, with the maximum achievable drag reduction being of the same order. Because the jet may be a relatively cool gas, however, the forward facing jet has the additional capability of reducing the aerodynamic heating that is so severe at high Mach numbers. By means of the correlation presented, jet ejection parameters may be chosen to achieve maximum permissible forebody drag reduction. The correlation method uses a momentum coefficient that characterizes jet efflux and freestream conditions.

Pamadi, B. N.↗