Search NASA⌕ Search

Engineering topics

Panja, Palash

Publications and source records attributed to Panja, Palash.

5 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Understanding the performance of membrane for direct air capture of CO 2

Abstract Direct air capture (DAC) of CO 2 is becoming increasingly important for reducing greenhouse gas concentrations in the atmosphere. However, the cost and energy requirements associated with DAC make it less economically feasible than carbon capture from flue gases. While various methods like solid sorbents and gas–liquid absorption have been explored for DAC, membrane processes have only recently been investigated. The objective of this study is to examine the separation performance of a membrane unit for capturing CO 2 from ambient air. The performance of a membrane depends on several factors, including the composition of the feed gas, pressure ratio, material selectivity, and membrane area. The single‐stage separation process with the co‐current flow and constant permeability flux model is evaluated using a commercial module integrated with a process simulator to separate a binary mixture of carbon dioxide and nitrogen to assess the sensitivity of selectivity on purity and recovery of CO 2 in permeate, and power requirement. Additionally, three levels of CO 2 reduction from the feed stream to the retentate stream (25%, 50%, and 75%) are studied. A trade‐off between purity and recovery factor is observed, and achieving high purity in permeate requires high concentration in the retentate.

Panja, Palash↗
DOE OSTI2023

Adsorption of rare earth elements in carboxylated mesoporous carbon

The separation of Rare Earth Elements (REEs) from various non-conventional sources is critically important to maintain the supply–demand balance of REEs in the western world. Here, in this research, we have investigated coal Fly Ash (CFA) as the non-conventional source of REEs. In order to recover REEs, we have synthesized carboxylate-functionalized mesoporous carbon (CMC) to harness the chelation-induced adsorption of REEs. These adsorbents were characterized with pore textural properties, FTIR spectroscopy, and SEM-EDX mapping. In the initial study with single-component La(III) Dy(III) and Lu(III), it was revealed that CMC can adsorb those REEs 2–4 times more than that of pristine mesoporous carbon confirming the effective role of the carboxylate group in the REE separation. Furthermore, the affiliation of the carboxylate group towards heavier REEs (Lu>Dy>La, when present is equal amounts) provides an added benefit of this adsorbent owing to the high demand for heavier REEs in the technology sectors. The leachate solution produced from CFA contained sixteen REEs in the range of 50–200 ppb for most of the REEs. It was revealed that CMC can extract 80–90% of all the REEs thereby further confirming the success of the CMC as an effective REE sorbent. Three successive cycles of adsorption and desorption of REEs with the same CMC revealed the consistent adsorption capacity of REEs. In-situ X-ray Absorption Near Edge Spectroscopy (XANES) analysis confirmed the +3 oxidation states of La, Dy, and Lu within CMC. In-situ Extended X-ray Absorption Fine Structure (EXAFS) analysis revealed the shortening of mean La-O, Dy-O, and Lu-O bond distance by 0.03–0.05 Å thereby confirming the coordination of these REEs with carboxylate groups present on CMC.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Flow of long chain hydrocarbons through carbon nanotubes (CNTs)

The pressure-driven flow of long-chain hydrocarbons in nanosized pores is important in energy, environmental, biological, and pharmaceutical applications. This paper examines the flow of hexane, heptane, and decane in carbon nanotubes (CNTs) of pore diameters 1–8 nm using molecular dynamic simulations. Enhancement of water flow in CNTs in comparison to rates predicted by continuum models has been well established in the literature. Our work was intended to observe if molecular dynamic simulations of hydrocarbon flow in CNTs produced similar enhancements. We used the OPLS-AA force field to simulate the hydrocarbons and the CNTs. Our simulations predicted the bulk densities of the hydrocarbons to be within 3% of the literature values. Molecular sizes and shapes of the hydrocarbon molecules compared to the pore size create interesting density patterns for smaller sized CNTs. We observed moderate flow enhancements for all the hydrocarbons (1–100) flowing through small-sized CNTs. For very small CNTs the larger hydrocarbons were forced to flow in a cork-screw fashion. As a result of this flow orientation, the larger molecules flowed as effectively (similar enhancements) as the smaller hydrocarbons.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗