Search NASA⌕ Search

Engineering topics

Papayannis, A.

Publications and source records attributed to Papayannis, A..

Lidar-Radiometer Inversion Code (LIRIC) for the Retrieval of Vertical Aerosol Properties from Combined Lidar Radiometer Data: Development and Distribution in EARLINET

This paper presents a detailed description of LIRIC (LIdar-Radiometer Inversion Code)algorithm for simultaneous processing of coincident lidar and radiometric (sun photometric) observations for the retrieval of the aerosol concentration vertical profiles. As the lidar radiometric input data we use measurements from European Aerosol Re-search Lidar Network (EARLINET) lidars and collocated sun-photometers of Aerosol Robotic Network (AERONET). The LIRIC data processing provides sequential inversion of the combined lidar and radiometric data by the estimations of column-integrated aerosol parameters from radiometric measurements followed by the retrieval of height-dependent concentrations of fine and coarse aerosols from lidar signals using integrated column characteristics of aerosol layer as a priori constraints. The use of polarized lidar observations allows us to discriminate between spherical and non-spherical particles of the coarse aerosol mode. The LIRIC software package was implemented and tested at a number of EARLINET stations. Inter-comparison of the LIRIC-based aerosol retrievals was performed for the observations by seven EARLNET lidars in Leipzig, Germany on 25 May 2009. We found close agreement between the aerosol parameters derived from different lidars that supports high robustness of the LIRIC algorithm. The sensitivity of the retrieval results to the possible reduction of the available observation data is also discussed.

Chaikovsky, A.↗

Lidar Measurements for Desert Dust Characterization: An Overview

We provide an overview of light detection and ranging (lidar) capability for describing and characterizing desert dust. This paper summarizes lidar techniques, observations, and fallouts of desert dust lidar measurements. The main objective is to provide the scientific community, including non-practitioners of lidar observations with a reference paper on dust lidar measurements. In particular, it will fill the current gap of communication between research-oriented lidar community and potential desert dust data users, such as air quality monitoring agencies and aviation advisory centers. The current capability of the different lidar techniques for the characterization of aerosol in general and desert dust in particular is presented. Technical aspects and required assumptions of these techniques are discussed, providing readers with the pros and cons of each technique. Information about desert dust collected up to date using lidar techniques is reviewed. Lidar techniques for aerosol characterization have a maturity level appropriate for addressing air quality and transportation issues, as demonstrated by some first results reported in this paper

Mona, L.↗

Ozone transport during a cut-off low event studied in the frame of the TOASTE program

A study of ozone transfer to the troposphere has been performed during two phases of the evolution of a cut-off low using both ozone vertical profiles and objective analysis of the ECMWF to compute potential vorticity distributions and air mass trajectories. Ozone profiles were measured by a ground based lidar system at the Observatoire de Haute Provence (OHP, 43 deg 55 N, 5 deg 42 E). A stratospheric ozone transport into the troposphere has been observed during a tropopause fold which occurred at the beginning of the cut-off low formation and during the erosion phase of the cut-off low. From the estimate of the maximum ozone content transferred to the troposphere, both mechanisms have the same order of magnitude of influence on the ozone flux to the troposphere. On a time scale of a few days, the correlation is very good between the potential vorticity and the ozone time evolution in the vicinity of the upper level frontal system.

Ancellet, G.↗