Parikh, P. | Search NASA

NASA NTRS1989

Three dimensional unstructured grids for the solution of the Euler equations

The advancing front technique is being used to develop a code to generate grids around complex 3-D configurations for use in computing the invisid flow solutions by the Euler equations. By the advancing front technique points are introduced concurrently with the connectivity information so that a separate library is not required. The generation of a 3-D grid is accomplished in several steps. First the boundaries of the domain to be gridded must be described by two-, three- or four-sided surface patches. Next, a background mesh is required to control the grid spacing and stretching throughout the domain. This coarse tetrahedral grid is not required to conform to any of the boundaries. Next, each of the patches is mapped to 2-D, triangulated by the advancing front technique and mapped back to 3-D. These triangles form the initial front for the generation of the final tetrahedral mesh.

Gumbert, Clyde↗

NASA NTRS1988

Instability and sound emission from a flow over a curved surface

The growth and decay of a wavepacket convecting in a boundary layer over a concave-convex surface is studied numerically using direct computations of the Navier-Stokes equations. The resulting sound radiation is computed using the linearized Euler equations with the pressure from the Navier-Stokes solution as a time-dependent boundary condition. It is shown that on the concave portion the amplitude of the wavepacket increases and its bandwidth broadens while on the convex portion some of the components in the packet are stabilized. The pressure field decays exponentially away from the surface and then algebraically exhibits a decay characteristic of acoustic waves in two dimensions. The far-field acoustic pressure exhibits a peak at a frequency corresponding to the inflow instability frequency.

Maestrello, L.↗

NASA NTRS1988

Antimisting kerosene: Low temperature degradation and blending

The inline filtration characteristics of freshly blended and degraded antimisting fuels (AMK) at low temperature are examined. A needle valve degrader was modified to include partial recirculation of degraded fuel and heat addition in the bypass loop. A pressure drop across the needle valve of up to 4,000 psi was used. The pressure drop across a 325 mesh filter screen placed inline with the degrader and directly downstream of the needle valve was measured as a function of time for different values of pressure drop across the needle valve. A volume flux of 1 gpm/sq in was employed based on the frontal area of the screen. It was found that, at ambient temperatures, freshly blended AMK fuel could be degraded using a single pass degradation at 4,000 psi pressure drop across the needle valve to give acceptable filterability performance. At fuel temperatures below -20 C, degradation becomes increasingly difficult and a single pass technique results in unacceptable filtration performance. Recirculation of a fraction of the degraded fuel and heat addition in the bypass loop improved low temperature degradation performance. The problem is addressed of blending the AMK additive with Jet A at various base fuel temperatures.

Yavrouian, A.↗

NASA NTRS1987

Wave phenomena in a high Reynolds number compressible boundary layer

The behavior of spatially unstable waves in a high Reynolds number compressible laminar boundary layer is investigated by solution of the laminar two-dimensional compressible Navier-Stokes equations (solved to fourth-order accuracy) over a flat plate with a fluctuating disturbance generated at the inflow. A significant nonlinear distortion is produced, in qualitative agreement with experimental data. It is shown that increasing compressibility can significantly stabilize the flow over a flat plate, and that the mechanism of phase cancellation is a viable mechanism for the control of growing disturbances.

Bayliss, A.↗

NASA NTRS1986

Quantitative determination of engine water ingestion

A nonintrusive optical technique is described for determination of liquid mass flux in a droplet laden airstream. The techniques were developed for quantitative determination of engine water ingestion resulting from heavy rain or wheel spray. Independent measurements of the liquid water content (LWC) of the droplet laden airstream and of the droplet velocities were made at the stimulated nacelle inlet plane for the liquid mass flux determination. The LWC was measured by illuminating and photographing the droplets contained within a thin slice of the flow field by means of a sheet of light from a pulsed laser. A fluorescent dye introduced in the water enchanced the droplet image definition. The droplet velocities were determined from double exposed photographs of the moving droplet field. The technique was initially applied to a steady spray generated in a wind tunnel. It was found that although the spray was initially steady, the aerodynamic breakup process was inherently unsteady. This resulted in a wide variation of the instantaneous LWC of the droplet laden airstream. The standard deviation of ten separate LWC measurements was 31% of the average. However, the liquid mass flux calculated from the average LWC and droplet velocities came within 10% of the known water ingestion rate.

Parikh, P.↗

NASA NTRS1986

Stability and control of compressible flows over a surface with concave-conves curvature

The active control of spatially unstable disturbances in a laminar, two-dimensional, compressible boundary layer over a curved surface is numerically simulated. The control is effected by localized time-periodic surface heating. We consider two similar surfaces of different heights with concave-convex curvature. In one, the height is sufficiently large so that the favorable pressure gradient is sufficient to stabilize a particular disturbance. In the other case the pressure gradient induced by the curvature is destabilizing. It is shown that by using active control that the disturbance can be stabilized. The results demonstrate that the curvature induced mean pressure gradient significantly enhances the receptivity of the flow localized time-periodic surface heating and that this is a potentially viable mechanism in air.

Maestrello, L.↗

NASA NTRS1986

Numerical simulation of boundary-layer excitation by surface heating/cooling

The concept of active control of growing disturbances in an unstable compressible flow by using time periodic, localized surface heating is studied numerically. The simulations are calculated by a fourth-order accurate solution of the compressible, laminar Navier-Stokes equations. Fourth-order accuracy is particularly important for this problem because the solution must be computed over many wavelengths. The numerical results demonstrate the growth of an initially small fluctuation into the nonlinear regime where a local breakdown into smaller scale disturbances can be observed. It is shown that periodic surface heating over a small strip can reduce the level of the fluctuation provided that the phase of the heating current is properly chosen.

Bayliss, A.↗

NASA NTRS1986

Simulation and analysis of natural rain in a wind tunnel via digital image processing techniques

It is desired to simulate natural rain in a wind tunnel in order to investigate its influence on the aerodynamic characteristics of aircraft. Rain simulation nozzles have been developed and tested at JPL. Pulsed laser sheet illumination is used to photograph the droplets in the moving airstream. Digital image processing techniques are applied to these photographs for calculation of rain statistics to evaluate the performance of the nozzles. It is found that fixed hypodermic type nozzles inject too much water to simulate natural rain conditions. A modification uses two aerodynamic spinners to flex a tube in a pseudo-random fashion to distribute the water over a larger area.

Aaron, K. M.↗

NASA NTRS1986

Quantitative determination of engine water ingestion

This paper describes a novel non-intrusive optical technique for determination of liquid mass flux in a droplet laden airstream. The technique was developed for quantitative determination of engine water ingestion resulting from heavy rain or wheel spray. Independent measurements of the liquid water content (LWC) of the droplet laden aircraft and of the droplet velocities were made at the simulated nacelle inlet plane for the liquid mass flux determination. The liquid water content was measured by illuminating and photographing the droplets contained within a thin slice of the flow field by means of a sheet of light from a pulsed YAG laser. A fluorescent dye introduced in the water greatly improved the droplet image definition. The droplet velocities were determined from double exposed photographs of the moving droplet field. The technique was initially applied to a steady spray generated in a wind tunnel. It was found that although the spray was initially steady, the aerodynamic breakup process was inherently unsteady. This resulted in a wide variation of the instantaneous liquid water content of the droplet laden airstream. The standard deviation of ten separate LWC measurements was 31 percent of the average. However, the liquid mass flux calculated from the average LWC and droplet velocities came within 10 percent of the known water ingestion rate.

Parikh, P.↗

NASA NTRS1986

Research on antimisting fuel for suppression of postcrash aircraft fires

Recent experimental results in the field of post-crash aircraft fire suppression are reviewed, with emphasis given to antimisting kerosene fuel (AMK). Findings in three major areas of study are presented, including: rheological studies (skin friction, and heat transfer); fuel breakup processes and nozzle spray combustion; and the development of inline blenders for production of AMK at the refueling point. An interpretation of the results of the FAA/NASA Controlled Impact Demonstration of AMK fuel is also presented. It is concluded that AMK is a sound concept and offers several advantages over conventional fuels in any crash scenario involving post-crash fires.

Sarohia, V.↗

NASA NTRS1986

Droplet field visualization and characterization via digital image analysis

This paper describes techniques that have been developed at JPL for visualization and measurements of droplet fields in a moving airstream. The techniques have been applied to a variety of problems which include simulation of heavy rain conditions in a wind tunnel, engine ingestion of wheel spray, analysis of fuel nozzle sprays and aerodynamic breakup of non-Newtonian liquids. The approach pursued here is direct imaging using a pulsed laser illumination source, followed by digital processing of photographic images. A laser double pulse technique has been used for determination of droplet velocities. Laser induced fluorescence has been used to enhance droplet definition in photographic images. The image processing software developed is capable of distinguishing between out-of-focus and in-focus drops, retaining only the latter for size determination.

Hernan, M. A.↗

NASA NTRS1985

Continuous inline blending of antimisting kerosene

A continuous inline blender was developed to blend polymer slurries with a stream of jet A fuel. The viscosity of the slurries ranged widely. The key element of the blender was a static mixer placed immediately downstream of the slurry injection point. A positive displacement gear pump for jet A was employed, and a progressive cavity rotary screw pump was used for slurry pumping. Turbine flow meters were employed for jet A metering while the slurry flow rate was calibrated against the pressure drop in the injection tube. While using one of the FM-9 variant slurries, a provision was made for a time delay between the addition of slurry and the addition of amine sequentially into the jet A stream.

Parikh, P.↗

NASA NTRS1985

Active control of compressible flows on a curved surface

The effect of localized, time periodic surface heating and cooling over a curved surface is studied. This is a mechanism for the active control of unstable disturbances by phase cancellation and reinforcement. It is shown that the pressure gradient induced by the curvature significantly enhances the effectiveness of this form of active control. In particular, by appropriate choice of phase, active surface heating can completely stabilize and unstable wave.

Maestrello, L.↗

NASA NTRS1985

Wave phenomena in a high Reynolds number compressible boundary layer

Growth of unstable disturbances in a high Reynolds number compressible boundary layer is numerically simulated. Localized periodic surface heating and cooling as a means of active control of these disturbances is studied. It is shown that compressibility in itself stabilizes the flow but at a lower Mach number, significant nonlinear distortions are produced. Phase cancellation is shown to be an effective mechanism for active boundary layer control.

Bayliss, A.↗

NASA NTRS1985

A fourth-order scheme for the unsteady compressible Navier-Stokes equations

A computational scheme is described which is second-order accurate in time and fourth-order accurate in space (2-4). This method is applied to study the stability of compressible boundary layers. The laminar compressible Navier-Stokes equations are solved with a time harmonic inflow superimposed on the steady state solution. This results in spatially unstable modes. It is shown that the second-order methods are inefficient for calculating the growth rates and phases of the unstable modes. In contrast the fourth-order method yields accurate results on relatively course meshes.

Bayliss, A.↗

NASA NTRS1985

Active control of compressible flows on a curved surface

The effect of localized, time periodic surface heating and cooling over a curved surface is studied. This is a mechanism for the active control of unstable disturbances by phase cancellation and reinforcement. It is shown that the pressure gradient induced by the curvature significantly enhances the effectiveness of this form of active control. In particular, by appropriate choice of phase, active surface heating can completely stabilize an unstable wave.

Maestrello, L.↗

NASA NTRS1985

A fourth-order scheme for the unsteady compressible Navier-Stokes equations

A computational scheme is described which is second-order accurate in time and fourth-order accurate in space (2-4). This method is applied to study the stability of compressible boundary layers. The laminar compressible Navier-Stokes equations are solved with a time harmonic inflow superimposed on the steady state solution. This results in spatially unstable modes. It is shown that the second-order methods are inefficient for calculating the growth rates and phases of the unstable modes. In contrast the fourth-order method yields accurate results on relatively coarse meshes.

Bayliss, A.↗

NASA NTRS1985

Numerical simulation of boundary layer excitation by surface heating/cooling

The concept of active control of growing disturbances in an unstable compressible flow by using time periodic, localized surface heating is studied numerically. The simulations are calculated by a fourth-order accurate solution of the compressible, laminar Navier-Stokes equations. Fourth-order accuracy is particularly important for this problem because the solution must be computed over many wavelengths. The numerical results demonstrate the growth of an initially small fluctuation into the nonlinear regime where a local breakdown into smaller scale disturbances can be observed. It is shown that periodic surface heating over a small strip can reduce the level of the fluctuation provided that the phase of the heating current is properly chosen.

Bayliss, A.↗