Search NASA⌕ Search

Engineering topics

Park, K

Publications and source records attributed to Park, K.

SU-F-T-294: The Analysis of Gamma Criteria for Delta4 Dosimetry Using Statistical Process Control

Purpose: To evaluate the sensitivity of gamma criteria for patient-specific volumetric modulated arc therapy(VMAT) quality assurance of the Delta{sup 4} dosimetry program using the statistical process control(SPC) methodology. Methods: The authors selected 20 patient-specific VMAT QA cases which were undertaken MapCHECK and ArcCHECK with gamma pass rate better than 97%. The QAs data were collected Delta4 Phantom+ and Elekta Agility six megavolts without using an angle incrementer. The gamma index(GI) were calculated in 2D planes with normalizing deviation to local dose(local gamma). The sensitivity of the GI methodology using criterion of 3%/3mm, 3%/2mm and 2%/3mm was analyzed with using process acceptability indices. We used local confidence(LC) level, the upper control limit(UCL) and lower control limit(LCL) of I-MR chart for process capability index(Cp) and a process acceptability index (Cpk). Results: The lower local confidence levels of 3%/3mm, 3%/2mm and 2%/3mm were 92.0%, 83.6% and 78.8% respectively. All of the calculated Cp and Cpk values that used LC level were under 1.0 in this study. The calculated LCLs of I-MR charts were 89.5%, 79.0% and 70.5% respectively. These values were higher than 1.0 which means good quality of QA. For the generally used lower limit of 90%, we acquired over 1.3 of Cp value for the gamma index of 3%/3mm and lower than 1.0 in the rest of GI. Conclusion: We applied SPC methodology to evaluate the sensitivity of gamma criteria and could see the lower control limits of VMAT QA for the Delta 4 dosimetry and could see that Delta 4 phantom+ dosimetry more affected by the position error and the I-MR chart derived values are more suitable for establishing lower limits. Acknowledgement: This research was supported by Basic Science Research Program through the National Research Foundation of Korea(NRF) funded by the Ministry of Education (No. 2015R1D1A1A01060463)

60 APPLIED LIFE SCIENCES↗

SU-E-J-64: Feasibility Study of Surgical Clips for Fiducial Tracking in CyberKnife System

Purpose: To investigate the ability of CyberKnife to track surgical clips used as fiducial markers. Methods: The Octavius 1000SRS detector and solid water (RW3) slab phantom were used with motion platform to evaluate the study. The RW3 slab phantom was set up to measure the dose distribution from coronal plane. It consists of 9 plates and the thickness of each plate is 10mm. Among them, one plate was attached with 3 surgical clips, which are orthogonally positioned on outer region of array. The length of attached clip was represented as 1cm on planning CT. The clip plate was placed on the 1000SRS detector and 3 slabs were stacked up on the plate to build the measuring depth. Below the detector, 5 slabs were set. The two-axis motion platform was programmed with 1D sinusoidal movement (20mm peak-to-peak, 3s period) toward superior/inferior and left/right directions to simulate target motion. During delivery, two clips were extracted by two X-ray imagers, which led to translational error correction only. Synchrony was also used for dynamic tracking. After the irradiation, the measured dose distribution of coronal plane was compared with the planar dose distribution calculated by the CyberKnife treatment planning system (Multiplan) for cross verification. The results were assessed by comparing the absolute Gamma (γ) index. Results: The dose distributions measured by the 1000SRS detector were in good agreements with those calculated by Multiplan. In the dosimetric comparison using γ-function criteria based on the distance-to-agreement of 3mm and the local dose difference of 3%, the passing rate with γ- parameter ≤1 was 91% in coronal plane. Conclusion: The surgical clips can be considered as new fiducials for robotic radiosurgery delivery by considering the target margin with less than 5mm.

60 APPLIED LIFE SCIENCES↗

SU-E-T-117: Analysis of the ArcCHECK Dosimetry Gamma Failure Using the 3DVH System

Purpose: To evaluate gamma analysis failure for the VMAT patient specific QA using ArcCHECK cylindrical phantom. The 3DVH system(Sun Nuclear, FL) was used to analyze the dose difference statistic between measured dose and treatment planning system calculated dose. Methods: Four case of gamma analysis failure were selected retrospectively. Our institution gamma analysis indexes were absolute dose, 3%/3mm and 90%pass rate in the ArcCHECK dosimetry. The collapsed cone convolution superposition (CCCS) dose calculation algorithm for VMAT was used. Dose delivery was performed with Elekta Agility. The A1SL(standard imaging, WI) and cavity plug were used for point dose measurement. Delivery QA plans and images were used for 3DVH Reference data instead of patient plan and image. The measured data of ‘.txt’ file was used for comparison at diodes to acquire a global dose level. The,.acml’ file was used for AC-PDP and to calculated point dose. Results: The global dose of 3DVH was calculated as 1.10 Gy, 1.13, 1.01 and 0.2 Gy respectively. The global dose of 0.2 Gy case was induced by distance discrepancy. The TPS calculated point dose of was 2.33 Gy to 2.77 Gy and 3DVH calculated dose was 2.33 Gy to 2.68 Gy. The maximum dose differences were −2.83% and −3.1% for TPS vs. measured dose and TPS vs. 3DVH calculated respectively in the same case. The difference between measured and 3DVH was 0.1% in that case. The 3DVH gamma pass rate was 98% to 99.7%. Conclusion: We found the TPS calculation error by 3DVH calculation using ArcCHECK measured dose. It seemed that our CCCS algorithm RTP system over estimated at the central region and underestimated scattering at the peripheral diode detector point. The relative gamma analysis and point dose measurement would be recommended for VMAT DQA in the gamma failure case of ArcCHECK dosimetry.

60 APPLIED LIFE SCIENCES↗

Field-tuned Fermi Liquid in Quantum Critical YFe2Al10

We present measurements of the magnetization M, ac susceptibility {chi}{prime}, electrical resistivity {rho}, and specific heat C in single crystals of metallic YFe{sub 2}Al{sub 10}. The magnetic susceptibility follows a Curie-Weiss temperature dependence for 75 K {le} T {le} 750 K, with a fluctuating Fe moment of 0.45 {mu}{sub B}/Fe, and the ac susceptibility {chi}{prime} diverges at lower temperatures {chi}{prime} {approx} T{sup -1.28} {+-} 0.04 when the ac field is in the basal plane. The field B and temperature T dependencies of the magnetization M are well described by the scaling expression MT{sup -{beta}} = F(B/T{sup {beta}+{gamma}}) for 1.8 K {le} T {le} 30 K and for fields larger than 0.1T. These results indicate that strong quasi-two-dimensional critical fluctuations are present that can be suppressed by magnetic fields. The magnetic and electronic parts of the specific heat C{sub M} show a similar divergence for 0.4 K {le} T {le} 12 K, where C{sub M}/T {approx}T{sup -0.47 {+-} 0.03}. The divergences in {chi}{prime} and C{sub M}/T indicate that YFe{sub 2}Al{sub 10} is located near a quantum critical point, and no magnetic order is observed above 0.09 K. We argue that our results are inconsistent with quantum impurity or disorder models, suggesting instead that YFe{sub 2}Al{sub 10} is on the verge of bulk magnetic ordering, and that the critical fluctuations that are associated with this quantum critical point lead to the divergencies in CM/T and {chi}{prime}.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Measurement of Single- and Double-Spin Asymmetries in Deep Inelastic Pion Electroproduction with a Longitudinally Polarized Target

We report the first measurement of the transverse momentum dependence of double-spin asymmetries in semi-inclusive production of pions in deep-inelastic scattering off the longitudinally polarized proton. Data have been obtained using a polarized electron beam of 5.7 GeV with the CLAS detector at the Jefferson Lab (JLab). Modulations of single spin asymmetries over the azimuthal angle between lepton scattering and hadron production planes {phi} have been measured over a wide kinematic range in Bjorken x and virtual photon squared four-momentum Q{sup 2}. A significant nonzero sin2{phi} single spin asymmetry was observed for the first time indicating strong spin-orbit correlations for transversely polarized quarks in the longitudinally polarized proton.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Tensor Correlations Measured in {sup 3}He(e,e{sup '}pp)n

We have measured the {sup 3}He(e,e{sup '}pp)n reaction at an incident energy of 4.7 GeV over a wide kinematic range. We identified spectator correlated pp and pn nucleon pairs by using kinematic cuts and measured their relative and total momentum distributions. This is the first measurement of the ratio of pp to pn pairs as a function of pair total momentum p{sub tot}. For pair relative momenta between 0.3 and 0.5 GeV/c, the ratio is very small at low p{sub tot} and rises to approximately 0.5 at large p{sub tot}. This shows the dominance of tensor over central correlations at this relative momentum.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Photoproduction of the {Lambda}*(1520) Hyperon

The photoproduction of the {Lambda}*(1520) on both the proton and neutron have been studied by using the CLAS eg3 run data set. The reactions are {gamma}d{yields}K{sup +{Lambda}}*(n) and {gamma}d{yields}K{sup 0{Lambda}}*(p) with {Lambda}*{yields}pK{sup -}. Preliminary total and differential cross sections have been extracted in the photon energy region 1.75 GeV<E{sub {gamma}<}5.50 GeV. This is the first time that the photoproduction of {Lambda}*(1520) on the neutron is reported, and we will extend the results on the proton to higher energies than in previous studies.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Electroexcitation of nucleon resonances from CLAS data on single pion electroproduction

We present results on the electroexcitation of the low mass resonances {delta}(1232)P{sub 33}, N(1440)P{sub 11}, N(1520)D{sub 13}, and N(1535)S{sub 11} in a wide range of Q{sup 2}. The results were obtained in the comprehensive analysis of data from the Continuous Electron Beam Accelerator Facility (CEBAF) large acceptance spectrometer (CLAS) detector at the Thomas Jefferson National Accelerator Facility (JLab) on differential cross sections, longitudinally polarized beam asymmetries, and longitudinal target and beam-target asymmetries for {pi} electroproduction off the proton. The data were analyzed using two conceptually different approaches--fixed-t dispersion relations and a unitary isobar model--allowing us to draw conclusions on the model sensitivity of the obtained electrocoupling amplitudes. The amplitudes for the {delta}(1232)P{sub 33} show the importance of a meson-cloud contribution to quantitatively explain the magnetic dipole strength, as well as the electric and scalar quadrupole transitions. They do not show any tendency of approaching the pQCD regime for Q{sup 2}{<=}6 GeV{sup 2}. For the Roper resonance, N(1440)P{sub 11}, the data provide strong evidence that this state is a predominantly radial excitation of a three-quark (3q) ground state. Measured in pion electroproduction, the transverse helicity amplitude for the N(1535)S{sub 11} allowed us to obtain the branching ratios of this state to the {pi}N and {eta}N channels via comparison with the results extracted from {eta} electroproduction. The extensive CLAS data also enabled the extraction of the {gamma}*p{yields}N(1520)D{sub 13} and N(1535)S{sub 11} longitudinal helicity amplitudes with good precision. For the N(1535)S{sub 11}, these results became a challenge for quark models and may be indicative of large meson-cloud contributions or of representations of this state that differ from a 3q excitation. The transverse amplitudes for the N(1520)D{sub 13} clearly show the rapid changeover from helicity-3/2 dominance at the real photon point to helicity-1/2 dominance at Q{sup 2}>1 GeV{sup 2}, confirming a long-standing prediction of the constituent quark model.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Light vector mesons in the nuclear medium

The light vector mesons ({rho},{omega}, and {phi}) were produced in deuterium, carbon, titanium, and iron targets in a search for possible in-medium modifications to the properties of the {rho} meson at normal nuclear densities and zero temperature. The vector mesons were detected with the CEBAF Large Acceptance Spectrometer (CLAS) via their decays to e{sup +}e{sup -}. The rare leptonic decay was chosen to reduce final-state interactions. A combinatorial background was subtracted from the invariant mass spectra using a well-established event-mixing technique. The {rho}-meson mass spectrum was extracted after the {omega} and {phi} signals were removed in a nearly model-independent way. Comparisons were made between the {rho} mass spectra from the heavy targets (A>2) with the mass spectrum extracted from the deuterium target. With respect to the {rho}-meson mass, we obtain a small shift compatible with zero. Also, we measure widths consistent with standard nuclear many-body effects such as collisional broadening and Fermi motion.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗