Search NASA⌕ Search

Engineering topics

Parke, Michael E.

Publications and source records attributed to Parke, Michael E..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Calibration of the TOPEX altimeter using a GPS buoy

The use of a spar buoy equipped with a Global Positioning System (GPS) antenna to calibrate the height measurement of the TOPEX radar altimeter is described. In order to determine the height of the GPS antenna phase center above the ocean surface, the buoy was also equipped with instrumentation to measure the instantaneous location of the waterline, and tilt of the bouy from vertical. The experiment was conducted off the California coast near the Texaco offshore oil platform, Harvest, during cycle 34 of the TOPEX/POSEIDON observational period. GPS solutions were computed for the bouy position using two different software packages, K&RS and GIPSY-OASIS II. These solutions were combined with estimates of the waterline location on the bouy to yield the height of the ocean surface. The ocean surface height in an absolute coordinate system combined with knowledge of the spacecraft height from tracking data provides a computed altimeter range measurement. By comparing this computed value to the actual altimeter measurement, the altimeter bias can be calibrated. The altimeter height bias obtained with the buoy using K&RS was -14.6 +/- 4 cm, while with GIPSY-OASIS II it was -13.1 +/- 4 cm. These are 0.1 cm and 1.6 cm different from the -14.7 +/- 4 cm result obtained for this flight overflight with the tide gauge instruments located on Platform Harvest.

Born, G. H.↗
NASA NTRS1994

Some aspects of simultaneously flying Topex Follow-On in a Topex orbit with Geosat Follow-On in a Geosat orbit

The advantages of having Geosat Follow-On in a Geosat orbit flying simultaneously with Topex Follow-On in a Topex/Poseidon orbit are examined. The orbits are evaluated using two criteria. The first is the acute crossover angle. This angle should be at least 40 degrees in order to accurately resolve the slope of sea level at crossover locations. The second is tidal aliasing. In order to solve for tides, the largest constituents should not be aliased to a frequency lower than two cycles/year and should be at least one cycle discrete from one another and from exactly two cycles/year over the mission life. The results show that TFO and GFO in these orbits complement each other. Both satellites have large crossover angles over a wide latitude range. In addition, the Topex orbit has good aliasing characteristics for the M2 and P1 tides for which the Geosat orbit has difficulty.

Parke, Michael E.↗
NASA NTRS1994

Precise mean sea level measurements using the Global Positioning System

This paper describes the results of a sea level measurement test conducted off La Jolla, California, in November of 1991. The purpose of this test was to determine accurate sea level measurements using a Global Positioning System (GPS) equipped buoy. These measurements were intended to be used as the sea level component for calibration of the ERS 1 satellite altimeter. Measurements were collected on November 25 and 28 when the ERS 1 satellite overflew the calibration area. Two different types of buoys were used. A waverider design was used on November 25 and a spar design on November 28. This provided the opportunity to examine how dynamic effects of the measurement platform might affect the sea level accuracy. The two buoys were deployed at locations approximately 1.2 km apart and about 15 km west of a reference GPS receiver located on the rooftop of the Institute of Geophysics and Planetary Physics at the Scripps Institute of Oceanography. GPS solutions were computed for 45 minutes on each day and used to produce two sea level time series. An estimate of the mean sea level at both locations was computed by subtracting tide gage data collected at the Scripps Pier from the GPS-determined sea level measurements and then filtering out the high-frequency components due to waves and buoy dynamics. In both cases the GPS estimate differed from Rapp's mean altimetric surface by 0.06 m. Thus, the gradient in the GPS measurements matched the gradient in Rapp's surface. These results suggest that accurate sea level can be determined using GPS on widely differing platforms as long as care is taken to determine the height of the GPS antenna phase center above water level. Application areas include measurement of absolute sea level, of temporal variations in sea level, and of sea level gradients (dominantly the geoid). Specific applications would include ocean altimeter calibration, monitoring of sea level in remote regions, and regional experiments requiring spatial and temporal resolution higher than that available from altimeter data.

Kelecy, Thomas M.↗
NASA NTRS1987

On the choice of orbits for an altimetric satellite to study ocean circulation and tides

The choice of an orbit for satellite altimetric studies of the ocean's circulation and tides requires an understanding of the orbital characteristics that influence the accuracy of the satellite's measurements of sea level and the temporal and spatial distribution of the measurements. The orbital characteristics that influence accurate calculations of the satellite's position as a function of time are examined, and the pattern of ground tracks laid down on the ocean's surface as a function of the satellite's altitude and inclination is studied. The results are used to examine the aliases in the measurements of surface geostrophic currents and tides. Finally, these considerations are used to specify possible orbits that may be useful for the upcoming Topex/Poseidon mission.

Parke, Michael E.↗
NASA NTRS1987

Seasonal variability of the Gulf Stream from satellite altimetry

The nearly continuous 3.5 years of altimeter data in the western North Atlantic Ocean from the GEOS 3 mission (April 1975 to November 1978) have been used to study the seasonal variability of the Gulf Stream. The differences between altimetric measurements of sea surface height made at satellite ground track intersections, called crossovers, are utilized to construct time series of sea level variations. The results indicate that the Gulf Stream in the region off Cape Hatteras has a pronounced seasonal variability. The peak-to-peak amplitude of the seasonal cycle in terms of cross-stream sea level difference is about 15 cm, with a maximum in April and a minimum in December. The result is in good agreement with historic hydrographic observations and recent direct measurements of the Gulf Stream. The mechanisms responsible for the observed seasonal variability are discussed.

Fu, Lee-Lueng↗
NASA NTRS1987

The applicability of satellite altimetry data to tidal models

The characteristics of satellite altimetry data are reviewed, and techniques for incorporating them into numerical tide models are discussed. The relationship between the geocentric tides observed by satellites and the ocean tides measured by gages or predicted by models is explored, and particular attention is given to the differences between deep-water, shelf, and estuarine tidal regimes. It is concluded that a separate tidal solution should always be performed before assimilating satellite data, including calculation of the tides along a single repeated ground track in the case of shelf and estuarine regions. The potential value of the altimetry to be provided by Topex/Poseidon (scheduled launch in 1991) is indicated.

Parke, Michael E.↗