Search NASA⌕ Search

Engineering topics

Parkison, Adam J.

Publications and source records attributed to Parkison, Adam J..

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Insights into Tetravalent Np Speciation in HNO 3 through Spectroelectrochemistry and Multivariate Analysis

In situ optical spectroscopy, spectropotentiometry, and multivariate analysis were applied to the Np(IV) nitrate system to better understand speciation and quantify HNO 3 concentration. Thin-layer spectropotentiometry, or spectroelectrochemistry, was leveraged to isolate and stabilize Np(IV) without compromising the solution conditions and generate representative Vis-NIR absorption spectra from 0.5 to 10 M HNO 3 and benchmark the corresponding Np(IV) molar absorptivity coefficients. Spectra were described with principal component analysis (PCA) to identify the purest Np(IV) absorbance spectra among other oxidation states [e.g., Np(V/VI)] at each acid concentration and then to identify the primary sources of variance within each Np(IV) spectrum with respect to Np(IV) nitrate complexes. Then, partial least-squares regression (PLSR) and support vector regression (SVR) models were built to predict HNO 3 concentration from the Np(IV) spectral data. The nonlinear SVR model outperformed the linear PLSR model for the HNO 3 concentration predictions. Finally, the inclusion of spectra collected in edge and center point HNO 3 concentrations in the calibration set was determined to be crucial for producing models with strong predictive capabilities. The multivariate approach used in this study makes it possible to quantify HNO 3 concentration solely based on Np(IV) absorption spectra, which is essential to quantifying processing streams in various online monitoring applications.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2024

Simultaneous Thermal Analysis of Anion and Cation Exchange Resins

The decomposition reactions of one anion exchange resin (Bio-Rad AG MP-1) and one cerium-loaded cation exchange resin (DOWEX 50W-X8), both in nitrate form, were analyzed using simultaneous thermal analysis methods. Thermogravimetric analysis, dynamic scanning calorimetry, and evolved gas analysis were deployed in combination to probe the temperature profiles, reaction enthalpies, and off-gases from these resins under process-relevant temperature ranges. Analysis indicates that both resins undergo three clear phases during heating. The first is a dehydration step with prominent off-gassing of water, the second is a decomposition step with evolution of several gaseous species, and lastly is a combustion step with a large release of CO 2 . The temperature at which combustion ends varies slightly between AG MP-1 and DOWEX 50W: combustion completed at ~690°C and ~810°C, respectively. For the DOWEX cation resin, the combustion reaction showed greater sensitivity to the availability of oxygen under the test conditions. Both resins displayed broad exotherms during the combustion step of the decomposition, but the DOWEX cation resin demonstrated a 4.5 times higher specific enthalpy than that of the AG MP-1.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Improving understanding of NpO 2 and Np 2 O 5 through vibrational spectroscopy

Raman spectra of three NpO 2 samples and two samples produced from a modified direct denitration (MDD) process were collected. The spectral features of the NpO 2 samples were consistent and indicated only NpO 2 . The spectra of the MDD samples indicated the presence of NpO 2 and an additional phase attributed to the neptunium binary oxide Np 2 O 5 . These Raman spectra are the first reported of Np 2 O 5 , and the proportions of these neptunium oxide phases varied within the samples, suggesting significant sample inhomogeneity. Peaks in the Raman spectra of Np 2 O 5 at 569 and 782 cm –1 were tentatively assigned to concerted, symmetric stretches of the neptunyl cations. Finally, laser-induced heating of regions in the MDD samples that were rich in Np 2 O 5 showed spectral features that indicated conversion to NpO 2 .

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Evaluating Optical Techniques to Characterize Solid State Samples for the Pu-238 Supply Program

This report documents steps that have been taken to establish advanced characterization capabilities for solid-state samples to support the 238 Pu Supply Program. The program has already invested significantly in spectroscopy and online monitoring development for liquid processes. Many of the data, analytical methods, and equipment could also be leveraged for the analysis of Np/Pu oxides and Np pellets to help classify material properties and link them to operations. The techniques described in this work include diffuse reflectance spectroscopy (DRS), Raman spectroscopy, and laser-induced breakdown spectroscopy (LIBS). Each technique is sensitive to various chemical and/or elemental species and can provide complimentary information to more standard methods such as powder x-ray diffraction and scanning electron microscopy. These options are remotely deployable via fiber-optic cables. DRS and Raman spectroscopy are already approved for glove box and hot cell work, but LIBS requires US Department of Energy approval for incorporation. Raman spectroscopy does require laser shielding, which means that DRS is the easiest method to implement. However, each technique provides complimentary data, and the most robust sample characterization could be achieved when all three, among other methods, are harnessed together. This report documents some of the progress made testing these capabilities, some of the challenges, and next steps to optimize the technology and integration strategies.

07 ISOTOPE AND RADIATION SOURCES↗
DOE OSTI2023

Quantifying neptunium oxidation states in nitric acid through spectroelectrochemistry and chemometrics

Controlled-potential in situ thin-layer spectropotentiometry was leveraged to generate visible/near-infrared (VIS/NIR) absorption spectral data sets for the development of chemometric models to quantify Np(III/IV/V/VI) oxidation states in HNO 3 . This technology would be valuable in laboratory studies and when monitoring process solutions to guide feed adjustments for radiochemical separations—the performance of which depends on oxidation state. This approach successfully isolated and stabilized Np species in pure (~99%) oxidation states without compromising solution optical properties. Multivariate curve resolution–alternating least squares models were evaluated to resolve spectral and component concentrations from a scan that sequentially produced Np(VI), Np(V), Np(IV), and Np(III) spectra with mixtures of two valences at a time. Although it provided a useful approximation, the method was not able to quantitively resolve each component likely because of rotational ambiguity. Additionally, partial least squares regression models were built from artificial and electrochemically generated VIS/NIR spectral training sets to study the effect of interionic interactions on spectral characteristics. Models built with true Bi-chemical mixtures of coexisting Np oxidation states and spectra generated from additive combinations of pure end points had similar prediction performance. This methodology can be used to directly quantify Np concentration and the ratio of Np oxidation states and other actinides in remote settings such as hot cells.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2019

The Effects on Non-Actinide Impurities from Aging Heat Source Plutonium in Stainless Steel Containers

Replacing the tantalum vials used for 238 PuO 2 sample collection and storage with stainless steel sample vials has several advantages. These advantages include a decreased cost, better material availability, and ease of fabrication. However, it must first be demonstrated that the alloying elements contained in stainless steel are not leached into the 238 PuO 2 such that product specifications are exceeded. In order to determine the suitability of stainless steel for this application, two seperate 238 PuO 2 fuel lots were investigated. These two fuel lots had been stored in stainless steel containers since their first sampling date of March of 2015, and were again sampled in February of 2019.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2016

Fabrication of ThN Using a Carbothermic Reduction to Nitridation Process

A carbothermic reduction to nitridation process was developed which is capable of producing high-purity thorium mononitride (ThN) in bulk quantities. This was accomplished through study of three distinct processing routes using thermogravimetric analysis. The information gathered was then used to guide development of a draft process, which was tested within a tungsten production furnace. Scaling issues were identified and corrected following the draft process. Finally, a partitioned process was developed in response to the draft process which separates the reduction from the nitridation and carbon cleanup steps. This partitioned process was demonstrated to be capable of producing phase-pure ThN, with oxygen and carbon impurities of 990 ± 130 wppm and 240 ± 30 wppm, respectively.

36 MATERIALS SCIENCE↗
DOE OSTI2016

Deconvolution of mass gain and mass loss mechanisms during carbothermic reduction to nitridization reactions in the zirconium system through thermogravimetric analysis

A novel approach was used to understand the effects of processing conditions on the conversion of zirconium dioxide to zirconium carbonitride using a carbothermic reduction to nitridation process. The conversion process was studied through the use of thermogravimetric analysis, X-ray diffraction (XRD), and scanning electron microscopy, resulting in an understanding of the nature and progression of conversion. The rate of mass change as measured through thermogravimetric analysis was plotted as a function of reaction progression, guiding the use of XRD in further understanding the conversion process. This approach was then used to characterize the important effect of initial compact morphology on conversion. Coupled analysis techniques allow for advancement of a number of hypotheses regarding the rate-limiting factors along the various steps in the carbothermic reduction to nitridation process. These results demonstrate the value of the proposed approach to aid in deconstruction of competing reaction mechanisms as necessary to understand the system studied here or other systems of scientific and industrial relevance.

36 MATERIALS SCIENCE↗
DOE OSTI2016

Hydrogen measurement during steam oxidation using coupled thermogravimetric analysis and quadrupole mass spectrometry

An analytical technique is presented with the goal of measuring reaction kinetics during steam oxidation reactions for three cases in which obtaining kinetics information often requires a prohibitive amount of time and cost. The technique presented relies on coupling thermogravimetric analysis (TGA) with a quantitative hydrogen measurement technique using quadrupole mass spectrometry (QMS). The first case considered is in differentiating between the kinetics of steam oxidation reactions and those for simultaneously reacting gaseous impurities such as nitrogen or oxygen. The second case allows one to independently measure the kinetics of oxide and hydride formation for systems in which both of these reactions are known to take place during steam oxidation. The third case deals with measuring the kinetics of formation for competing volatile and non-volatile oxides during certain steam oxidation reactions. In order to meet the requirements of the coupled technique, a methodology is presented which attempts to provide quantitative measurement of hydrogen generation using QMS in the presence of an interfering fragmentation species, namely water vapor. This is achieved such that all calibrations and corrections are performed during the TGA baseline and steam oxidation programs, making system operation virtually identical to standard TGA. Benchmarking results showed a relative error in hydrogen measurement of 5.7–8.4% following the application of a correction factor. Lastly, suggestions are made for possible improvements to the presented technique so that it may be better applied to the three cases presented.

36 MATERIALS SCIENCE↗