Search NASA⌕ Search

Engineering topics

Patterson, A.

Publications and source records attributed to Patterson, A..

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2020

Crystallization of TiO 2 polymorphs from RF-sputtered, amorphous thin-film precursors

Crystalline TiO 2 films of anatase, brookite, and rutile are reproducibly made from amorphous precursors deposited by RF magnetron sputtering, producing large-area, single phase films of uniform thickness. Sputtered amorphous TiO 2 precursor thin films follow the general behavior observed for amorphous precursor thin films generated by pulsed laser deposition, namely, that oxygen deficiency is necessary for the formation of brookite and rutile. We quantify the oxygen deficiency and correlate it with the long wavelength optical absorption. We find that the precursor deposition rate is also a contributing factor to phase selection and that brookite and rutile form from films deposited more rapidly and anatase from films deposited more slowly. Sputtered and pulsed laser deposited amorphous precursor films prepared with similar oxygen deficiency and similar thickness result in the same final state after annealing, but the rate for sputtered precursors is slower.

14 SOLAR ENERGY↗
NASA NTRS1986

The calibratrion of dopplergrams and magnetograms at BBSO

The calibration procedure for the Big Bear Solar Observatory (BBSO) videomagnetograph in which the radial velocity of the sidereal rotation of the Sun is used as a calibrator is described. One of the key points of the procedure is to eliminate the effects of the Earth's motion relative to the Sun and the temperature instability of the birefringent filter by tuning the bandpass of the birefringent filter. The other is to make the light level of the direct image of the videomagnetograph the same both in Doppler and in Zeeman modes in order to reduce the errors introduced by imperfect linearity of the transfer curve of the camera tube. Some practical problems of calibration are discussed for further improvement.

Shi, Z.↗
NASA NTRS1984

Flares in Hale 17760 - Magnetic transients in the 1981 July 27 flare

Several magnetic transients were observed in the flare of July 27, 1981 using the videomagnetograph at Big Bear Solar Observatory. Images in the Fe I 5324 A line used by the magnetograph showed emission in the area of the transients. Calculations show that the emission observed will explain the magnetic transient features, provided the magnetic field has two components: a strong and a weak or zero field. The elements of each field must be less than 1 arcsec in size, and the strong field must occupy less than 20 percent of the total area.

Patterson, A.↗
NASA NTRS1982

The H-alpha/H-beta ratio in solar flares

The present investigation involves the study of an extensive body of data accumulated of simultaneous H-alpha and H-beta cinematography of flares. The data were obtained with two telescopes simultaneously photographing flares in H-alpha and H-beta. The results of measurements in a number of flares are presented in a table. The flares were selected purely by optical quality of the data. That the measured ratios are not too different from those in stellar flares is suggested by the last two columns of the table. These columns show that a variety of possible line width ratios could give an integrated intensity ratio of less than unity.

Zirin, H.↗
NASA NTRS1981

Transient magnetic field changes in flares

Magnetic changes have been detected with the videomagnetograph (VMG) at Big Bear during two large flares in 1979 November 5. Two kinds of changes were detected in both flares: a decrease in satellite field strength near the locus of the flare and the appearance of strong transient fields during the peak of the flare. We explain why we believe that the observed effects are real and not instrumental and discuss their significance for flare studies.

Patterson, A.↗
NASA NTRS1967

Mechanisms of superconductivity investigated by nuclear radiation

Investigation focused on the behavior of superconducting magnet and its constituent materials during and after exposure to nuclear radiation. The results will indicate the feasibility of their use in diverse applications and various environments.

Autler, S. H.↗