Search NASA⌕ Search

Engineering topics

Patterson, G. K.

Publications and source records attributed to Patterson, G. K..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

A method for measuring skin friction drag on a flat plate in contaminated gas flows

A technique for measuring friction drag in turbulent gas and gas/particle flows over flat plates is presented, and preliminary results are reported. A 0.25-in.-thick 72 x 6-in. Al plate is suspended by six horizontal support air bearings and four vertical alignment air bearings between fixed dummy plates and leading-edge and trailing-edge fairings in the 32-in.-high 48-in.-wide 11-ft-long test section of a closed-circuit atmospheric wind tunnel operating at 50-150 ft/sec. Particles of Fe and Al oxides of diameter 20-150 microns and density up to 0.3 lb particles per lb air are injected via a 6 x 0.167-in. nozzle; turbulence is induced by a roughened section of the leading-edge fairing; and friction drag is measured using a load-cell pressure transducer. Sample results are shown in a graph, demonstrating good agreement with theoretical drag calculations.

Oetting, R. B.↗
NASA NTRS1971

Frequency response studies for a wedge probe in viscoelastic fluids.

Investigation of a hot-film wedge probe in viscoelastic fluids by imposing on the probe a sinusoidal vibration of known amplitude and frequency. Root-mean-square (rms) velocities calculated from the displacement of the probe are compared to rms velocities obtained with a constant temperature anemometer. The tests were performed under turbulent flow conditions and also at flow rates where viscoelastic effects, i.e., decrease of heat transfer rates from the probe to the fluid and drag reduction, were observed. The experimental technique was established by measuring the response of the probe in mineral oil.

Rodriguez, J. M.↗