Search NASA⌕ Search

Engineering topics

Patton, J. M., Jr.

Publications and source records attributed to Patton, J. M., Jr..

18 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Development of spin resistance criteria for light general aviation airplanes

A brief history of stall/spin technology for light general aviation airplanes is presented. Criteria needed to describe desirable characteristics of a spin-resistant airplane and means to evaluate airplanes for compliance with the criteria have been developed. Initial results from limited flight tests of an experimental high-wing airplane indicated that the basic configuration would not meet the spin resistance criteria. Further tests with the airplane modified to enhance its spin resistance are planned.

Dicarlo, D. J.↗
NASA NTRS1985

Flight investigation of stall, spin and recovery characteristics of a low-wing, single-engine, T-tail light airplane

Flight tests were performed to investigate the stall, spin, and recovery characteristics of a four-place, low-wing, single-engine, T-tail, general aviation research airplane at an aft center-of-gravity position. Most stalls resulted in roll-offs. Spins were oscillatory in roll and pitch at 43 deg angle of attack; the magnitude of the oscillations was determined by aileron position. Power, flap deflection, and landing gear position did not affect the angle of attack to the spin. Antispin rudder followed by forward wheel with ailerons neutral produced the fastest and most consistent recoveries but the initial application of recovery controls did not always stop a spin.

Stough, H. P., III↗
NASA NTRS1980

Spinning for safety's sake

NASA Langley is currently engaged in a comprehensive research program to improve the stall/spin characteristics of general aviation airplanes. Part of this program has included systematic flight tests of a fully instrumented airplane to determine the effects of various tail, wing, and fuselage modifications, and variation of inertia, center-of-gravity, and control positions on the spin and recovery characteristics. Airplane equipment, onboard instrumentation ground equipment, test area, and test procedures have been combined to provide a safe, practical means for conducting research in preplanned hazardous conditions. Configuration changes produced spins varying from easily recoverable to unrecoverable, and wind section design significantly influenced airplane stall, spin, and recovery characteristics.

Stough, H. P., III↗
NASA NTRS1980

Effects of discontinuous drooped wing leading-edge modifications on the spinning characteristics of a low-wing general aviation airplane

Wind tunnel and flight tests were conducted to determine the effects of several discontinuous drooped wing leading-edge configurations on the spinning characteristics of a light, single-engine, low-wing research airplane. Particular emphasis was placed on the identification of modifications which would improve the spinning characteristics. The spanwise length of a discontinuous outboard droop was varied and several additional inboard segments were added to determine the influence of such leading-edge configurations on the spin behavior. Results of the study indicated that the use of only the discontinuous outboard droop, over a specific spanwise area, was most effective towards improving spin and spin recovery characteristics, whereas the segmented configurations having both inboard and outboard droop exhibited a tendency to enter a flat spin.

Dicarlo, D. J.↗
NASA NTRS1980

Pilot assessment of two computer-generated display formats for helicopter instrument approach

Two computer generated display formats were evaluated as primary displays by six research pilots in a fixed base simulator. One of the computer generated display formats was an electronic attitude director indicator (EADI) which featured three cue flight director, command information, superimposed on true perspective runway symbology. The other computer generated display format featured separate horizontal and vertical situation information with vector predictors. A baseline display, consisting of an electromechanical attitude director indicator (ADI) with a three cue flight director and a moving map, was used as a reference for the pilot evaluations.

Niessen, F. R.↗
NASA NTRS1980

NASA general aviation stall/spin flight testing

A comprehensive program incorporating spin tunnel, static and rotary balance wind tunnel, full scale wind tunnel, free flight radio control model, flight simulation, and full scale flight testing was undertaken. Work includes aerodynamic definition of various configurations at high angles of attack, testing of stall and spin prevention concepts, definition of spin and spin recovery characteristics, and development of test techniques and emergency spin recovery systems. Some of the more interesting results to date are presented for the first airplane in the program in the areas of tail design, wind leading edge design, mass distribution, center of gravity location, and small airframe changes, with associated pilot observations. Design philosophy of the spin recovery parachute system is discussed, in addition to test techniques.

Patton, J. M., Jr.↗
NASA NTRS1980

A status report on NASA general aviation stall/spin flight testing

The NASA Langley Research Center has undertaken a comprehensive program involving spin tunnel, static and rotary balance wind tunnel, full-scale wind tunnel, free flight radio control model, flight simulation, and full-scale testing. Work underway includes aerodynamic definition of various configurations at high angles of attack, testing of stall and spin prevention concepts, definition of spin and spin recovery characteristics, and development of test techniques and emergency spin recovery systems. This paper presents some interesting results to date for the first aircraft (low-wing, single-engine) in the program, in the areas of tail design, wing leading edge design, mass distribution, center of gravity location, and small airframe changes, with associated pilot observations. The design philosophy of the spin recovery parachute system is discussed in addition to test techniques.

Patton, J. M., Jr.↗
NASA NTRS1979

The effects of configuration changes on spin and recovery characteristics of a low-wing general aviation research airplane

A fully instrumented, low-wing, single-engine general aviation airplane has been spin tested. Several tail configurations, wing leading-edge modifications, fuselage modifications, moment-of-inertia variations, center-of-gravity positions, and control inputs have been tested to determine their effect on spinning and spin recovery. Results indicate that wing airfoil design can significantly influence airplane spin and recovery characteristics and can overpower the effects of tail design. Results also point out a need to determine limitations of such factors as Reynolds number in model spin test techniques and high angle-of-attack aerodynamics.

Stough, H. P., III↗
NASA NTRS1979

Flight investigation of piloting techniques and crosswind limitations using a research type crosswind landing gear

A research-type crosswind landing gear was tested in a flight program which used a light STOL transport in strong crosswind conditions. The research-type crosswind landing gear used enabled the airplane to land to crosswinds up to a magnitude of 25 to 30 knots. Three modes of landing-gear operation were investigated: preset, automatic, and castor (passive self-alignment). Actual test data and histograms are given for the 195 'visual flight rules' crosswind landings made.

Fisher, B. D.↗
NASA NTRS1979

Spin flight research summary

An extensive general aviation stall/spin research program is underway at the NASA Langley Research Center. Flight tests have examined the effects of tail design, wing leading edge design, mass distribution, and minor airframe modifications on spin and recovery characteristics. Results and observations on test techniques are presented for the first airplane in the program. Configuration changes produced spins varying from easily recoverable slow, steep spins to unrecoverable, fast flat spins.

Patton, J. M., Jr.↗
NASA NTRS1976

A flight investigation of piloting techniques and crosswind limitations during visual STOL-type landing operations

A flight research program was undertaken to investigate problems concerned with landing a STOL airplane in crosswind conditions. The program included a study of piloting techniques and crosswind limitations during visual STOL type landing operations. The results indicated that the crosswind was more limiting during the ground roll out than during the airborne phases. The pilots estimated that the crosswind limit for commercial STOL type operations with the test aircraft would be approximately 15 to 20 knots. The pilots thought that the crosswind limits for ground operation might be extended by incorporating wing-lift spoilers, improved nose gear steering, and improved engine response. The pilots agreed that a crosswind landing gear would also be beneficial.

Fisher, B. D.↗
NASA NTRS1975

Motion-base simulator study of control of an externally blown flap STOL transport aircraft after failure of an outboard engine during landing approach

A moving-base simulator investigation of the problems of recovery and landing of a STOL aircraft after failure of an outboard engine during final approach was made. The approaches were made at 75 knots along a 6 deg glide slope. The engine was failed at low altitude and the option to go around was not allowed. The aircraft was simulated with each of three control systems, and it had four high-bypass-ratio fan-jet engines exhausting against large triple-slotted wing flaps to produce additional lift. A virtual-image out-the-window television display of a simulated STOL airport was operating during part of the investigation. Also, a simple heads-up flight director display superimposed on the airport landing scene was used by the pilots to make some of the recoveries following an engine failure. The results of the study indicated that the variation in visual cues and/or motion cues had little effect on the outcome of a recovery, but they did have some effect on the pilot's response and control patterns.

Middleton, D. B.↗
NASA NTRS1972

Fixed base simulator study of an externally blown flap STOL transport airplane during approach and landing

A fixed-base simulator study was conducted to determine the flight characteristics of a representative STOL transport having a high wing and equipped with an external-flow jet flap in combination with four high-bypass-ratio fan-jet engines during the approach and landing. Real-time digital simulation techniques were used. The computer was programed with equations of motion for six degrees of freedom and the aerodynamic inputs were based on measured wind-tunnel data. A visual display of a STOL airport was provided for simulation of the flare and touchdown characteristics. The primary piloting task was an instrument approach to a breakout at a 200-ft ceiling with a visual landing.

Grantham, W. D.↗
NASA NTRS1972

A pilot's opinion - VTOL control design requirements for the instrument approach task.

This paper presents pilot opinion supported by test data concerning flight control and display concepts and control system design requirements for VTOL aircraft in the instrument approach task. Material presented is drawn from research flights in the following aircraft: Dornier DO-31, Short SC-1, LTV XC-142A, and Boeing-Vertol CH-46. The control system concepts and mechanizations employed in the above aircraft are discussed, and the effect of control system augmentation is shown on performance. Operational procedures required in the instrument approach task are described, with comments on need for automation and combining of control functions.

Patton, J. M., Jr.↗
NASA NTRS1972

A flight evaluation of VTOL jet transport under visual and simulated instrument conditions

A flight investigation was performed with the Dornier DO-31 VTOL to evaluate the performance, handling qualities, and operating characteristics that are considered to be important in the operation of a commerical VTOL transport in the terminal area. The DO-31, a 20,000 kilogram transport, has a mixed jet propulsion system; main engines with nozzles deflect from a cruise to a hover position, and vertical lift engines operated below 170 knots. This VTOL mode incorporates pitch and roll attitude and yaw rate stabilization. The tests concentrated on the transition, approach, and vertical landing. The mixed jet propulsion system provided a large usable performance envelope that enabled simulated IFR approaches to be made on 7 deg and 12 deg glide slopes. In these approaches management of thrust magnitude and direction was a primary problem, and some form of integrating the controls will be necessary. The handling qualities evaluation pointed out the need for additional research of define flight path criteria. The aircraft had satisfactory control and stability in hover out of ground effect. The recirculation effects in vertical landing were large below 15 meters.

Holzhauser, C. A.↗