Engineering topics

Paul V Ferkul

Publications and source records attributed to Paul V Ferkul.

3 records

NASA NTRSDate not supplied

Effects of Confinement on Flame Spread in Microgravity

Solid fuel combustion experiments aboard the ISS examine the effects of confinement on a concurrent, purely-forced-flow flame spread in microgravity environment. The results for a thin, cotton-fiberglass-blended textile fabric fuel are presented. Flat baffles of differing materials are used to alter the radiative boundary conditions with transparent polycarbonate, black anodized aluminum (reflectance ~ 0), and highly polished aluminum (reflectance ~ 1). The baffles are parallel to the fuel sheet and placed symmetrically on each side. The inter-baffle distance is varied to change the boundary conditions for the flow. In all tests, samples are ignited at the upstream leading edge and allowed to burn to completion. Results show that the flame reaches a steady length and spread rate at low flow speeds (< 15 cm/s) for all tested inter-baffle distances. As the distance decreases, the flame length and spread rate first increase then decrease showing an optimal inter-baffle distance. For all baffle types, the flame either fails to ignite or extinguishes before reaching the end of the sample when the inter-baffle distance is too small (~ 1 cm). This is attributed to the reduction of oxygen supply to the flame zone and heat loss to the baffles. The results also show at the same inter-baffle distance, flame length and spread rate are highest for polished aluminum baffles, and lowest for transparent polycarbonate baffles. The differences are most prominent at intermediate tested baffle distances. While the radiative heat feedback from the baffles is expected to increase when the baffle distance decreases, the combustion is limited by the reduced oxygen supply. Near this limit, flame lengths and spread rates are similar for all baffle types.

Microgravity↗

NASA NTRSDate not supplied

Opposed Flame Spreading Along a Structured PMMA Sample in Exploration Atmosphere Under Microgravity

As part of SAFFIRE V experiments on the ISS supply spacecraft CYGNUS, flame propagation along different surface structures on a PMMA sample was investigated in opposed flow. The sample was 200 x 400 mm (length x width) with a thickness of 10 mm and contained ribs of different widths (1-10 mm), each 3 mm high, on both sides, arranged in the flow direction. The total thickness of the specimen was thus 16 mm for the ribs. For the first 360 s after ignition with a Kanthal wire, the flow velocity was 20 cm/s in the opposed direction. Then the flow velocity was reduced to 5 cm/s for a duration of 300 s before it was switched off to terminate the experiment. The experimental pressure was 761 hPa and the oxygen concentration was 26.9 vol %. These conditions correspond to atmospheric conditions envisioned for future exploration missions. It was found that the flames ignited downstream propagated forward along the rib edges surprisingly fast with up to 0.88 mm/s (1 mm rib width). Also, it was observed that the wider the rib, the slower the propagation. The widest rib (10 mm) already showed two largely independent edge flames. Unintentionally, the experiment showed how sensitive the flames are to small perturbations of the flow field, as remnants of a preceding and upstream experiment disturbed the incoming flow stratification partially.

microgravity↗

NASA NTRSDate not supplied

Extinction of Solid Diffusion Flame in Microgravity: Details of Quenching and Blowoff Processes

Long duration microgravity experiments aboard the International Space Station determine diffusion flame extinction limits of PMMA spheres. Upon ignition from an electrically-heated coil, the 4-cm-diameter samples are exposed to forced flows ranging from 0.2 to 80 cm/s and an oxygen ranging from 13 to 28% in one atmosphere total pressure. Extinction is reached as oxygen concentration gradually decreases by natural depletion. Five extinction tests are presented at different flow velocities and oxygen concentrations. Quenching at low velocity is observed with the flame tip shrinking upstream and blowoff is observed when a hole forms in the flame at the forward flow stagnation point. However, these processes are not quasistatic. The quenching motion involves periodic flame tip pulsating toward downstream and shrinking upstream with a continually decreasing flame size at the end of each cycle. In blowoff, the flame base pulsates between the flame hole and the downstream location, although with far fewer cycles compared to quenching. The pulsations appear to be the result of a premixed flame front spreading into a combustible mixture. Two specific cases are discussed. In the first, at very low flow velocity (~ 0.4 cm/s) and elevated oxygen, self-sustained flame tip cyclic pulsations are observed for a lengthy period (~15 minutes). In the second case with a higher flow velocity (50 cm/s), the diffusion flame is stabilized at the shoulder of the spherical sample after local stagnation point blowoff. With steady decrease in ambient oxygen due to depletion, spinning flamelets are formed. The long-duration microgravity environment makes it possible to observe. these interesting and detailed extinction processes.

Flame quenching↗