Search NASA⌕ Search

Engineering topics

Paulson, J. W., Jr.

Publications and source records attributed to Paulson, J. W., Jr..

At least 19 records

Transient aerodynamic forces on a fighter model during simulated approach and landing with thrust reversers

Previous wind tunnel tests of fighter configurations have shown that thrust reverser jets can induce large, unsteady aerodynamic forces and moments during operation in ground proximity. This is a concern for STOL configurations using partial reversing to spoil the thrust while keeping the engine output near military (MIL) power during landing approach. A novel test technique to simulate approach and landing was developed under a cooperative Northrop/NASA/USAF program. The NASA LaRC Vortex Research Facility was used for the experiments in which a 7-percent F-18 model was moved horizontally at speeds of up to 100 feet per second over a ramp simulating an aircraft to ground rate of closure similar to a no-flare STOL approach and landing. This paper presents an analysis of data showing the effect of reverser jet orientation and jet dynamic pressure ratio on the transient forces for different angles of attack, and flap and horizontal tail deflection. It was found, for reverser jets acting parallel to the plane of symmetry, that the jets interacted strongly with the ground, starting approximately half a span above the ground board. Unsteady rolling moment transients, large enough to cause the probable upset of an aircraft, and strong normal force and pitching moment transients were measured. For jets directed 40 degrees outboard, the transients were similar to the jet-off case, implying only minor interaction.

Humphreys, A. P.↗

Investigation of trailing-edge-flap, spanwise-blowing concepts on an advanced fighter configuration

The aerodynamic effects of spanwise blowing on the trailing edge flap of an advanced fighter aircraft configuration were determined in the 4 by 7 Meter Tunnel. A series of tests were conducted with variations in spanwise-blowing vector angle, nozzle exit area, nozzle location, thrust coefficient, and flap deflection in order to determine a superior configuration for both an underwing cascade concept and an overwing port concept. This screening phase of the testing was conducted at a nominal approach angle of attack from 12 deg to 16 deg; and then the superior configurations were tested over a more complete angle of attack range from 0 deg to 20 deg at tunnel free stream dynamic pressures from 20 to 40 lbf/sq ft at thrust coefficients from 0 to 2.

Paulson, J. W., Jr.↗

Approach and landing aerodynamic technologies for advanced STOL fighter configurations

Providing next-generation fighter aircraft with STOL capability will require effective high-lift systems, methods of providing adequate longitudinal trim and control, and thrust reversers compatible with advanced configurations. Recent wind-tunnel tests in the NASA Langley 4 x 7-m tunnel have provided the opportunity to investigate some promising technologies for providing this STOL capability. These tests include investigations of the high-lift contribution of spanwise blowing on a trailing-edge flap system, the trim capability of a blown high-lift canard, and the deceleration contribution of a thrust reverser for ground-roll reduction. This paper reviews the results of each investigation and examines the integration of these technologies on a common advanced-fighter configuration to determine their compatibility and the resulting overall performance of the configurations.

Banks, D. W.↗

Thrust-induced effects on subsonic longitudinal aerodynamic characteristics of a vectored-engine-over-wing configuration

An investigation was conducted in the Langley 4 by 7 Meter Tunnel of the thrust induced effects on the longitudinal aerodynamic characteristics of a vectored-engine-over-wing fighter aircraft. The investigation was conducted at Mach numbers from 0.14 to 0.17 over an angle-of-attack range from -2 deg to 26 deg. The major model variables were the spanwise blowing nozzle sweep angle and main nozzle vector angle along with trailing edge, flap deflections. The overall thrust coefficient (main and spanwise nozzles) was varied from 0 (jet off) to 2.0. The results indicate that the thrust-induced effects from the main nozzle alone were small and mainly due to boundary-layer control affecting a small area behind the nozzle. When the spanwise blowing nozzles were included, the induced effects were larger than the main nozzle alone and were due to both boundary layer control and induced circulation lift. No leading edge vortex effects were evident.

Quinto, P. F.↗

STOL wind tunnel test results for a tactical supercruiser

Attention is given to the NASA Langley Research Center's testing of a 10.5 percent-scale supersonic cruiser (supercruiser) aircraft model in its V/STOL wind tunnel, in order to investigate the low speed aerodynamic characteristics of STOL enhancement devices. The STOL devices employed by the supercruiser configuration are high vector angle ramp nozzles, working in conjunction with a remote augmented lift system (RALS), in addition to a canard trim system. Also investigated were thrust reverser/ground plane interaction effects, for the evaluation of landing characteristics. It is noted that STOL approach thrust management requires the use of a partially reversing RALS nozzle which develops approximately 31 percent of main nozzle thrust, and that strong nose-up interactions during ground roll, with reverser operation, may limit dry power engine thrust for braking assistance to about 50 percent of maximum dry power.

Hutchison, R. A.↗

Flap effectiveness on subsonic longitudinal aerodynamic characteristics of a modified arrow wing

An investigation of the subsonic longitudinal aerodynamic characteristics of a modified arrow-wing model was conducted in the Langley 4- by 7-Meter Tunnel. This investigation addressed the effectiveness of the leading and trailing edge flap deflections of this model. The arrow wing was tested at a Mach number of 0.02 and at an angle-of-attack range from -4 deg to 24 deg. The results of the investigation showed that deflecting the leading edge and trailing edge in combination could promote an attached-flow condition at the wing leading edge. Also, the leading edge suction could be maximized over the complete lift-coefficient range by scheduling a combination of leading and trailing edge flap deflections.

Quinto, P. F.↗

Trimming high lift for STOL fighters

The results of investigations of three different approaches to obtaining longitudinal trim for advanced fighter configurations with STOL performance are presented. The first, a differential thrust vectoring/reverser nozzle on an F-15 model, was very effective with an increment in pitching moment generated by the 90 deg/50 deg nozzle at military power equal to that which would be produced by a change in horizontal tail deflection of 20 deg. This trim pitching moment was accompanied by a modest loss in lift. The second method involved a nose jet on a supersonic cruise fighter configuration which, when combined with some canard deflection and longitudinal instability, provided trim capability for the configuration with military power setting and main nozzles deflected 43 degrees. Finally, a blown-high-lift canard on an advanced fighter configuration indicated that trim could be obtained across the complete angle-of-attack range tested with thrust set at military power and the main nozzles deflected 40 degrees. There was no loss in configuration lift and a slight increase in longitudinal stability.

Paulson, J. W., Jr.↗

An experimental and theoretical investigation of thick wings at various sweep angles in and out of ground effect

The effects of sweep and aspect ratio on the longitudinal aerodynamics of a wing in and out of ground effect are analyzed. Experimental data were obtained in the Langley 4 by 7 Meter Tunnel for a wing with various sweep angles, aspect ratios, and flap deflections both in and out of ground effect. Theoretical predictions of the out of ground effect lift coefficients and flap effectiveness and the in ground effect lift coefficients are compared with the experimental results. As expected, the lift curve slope and flap effectiveness are reduced when the aspect ratio is reduced or the sweep angle is increased both in and out of ground effect. In ground effect, the lift and flap effectiveness are increased above a wing height to span ratio of 0.15. However, with flap deflections less than or equal to 10 deg and an angle of attack near 0 deg lift is markedly decreased at very low heights above the ground plane. This trend is not predicted by planar theoretical models but is predicted by a surface panel method where thickness effects are included.

Paulson, J. W., Jr.↗

Thrust-induced effects on low-speed aerodynamics of fighter aircraft

Results of NASA Langley has conducted wind-tunnel investigations of several fighter configurations conducted to determine the effects of both thrust vectoring and spanwise blowing are reviewed. A recent joint NASA/Grumman Aerospace Corporation/U.S. Air Force Wright Aeronautical Laboratory wind-tunnel investigation was conducted to examine the effects of spanwise blowing on the trailing-edge flap system. This application contrasts with the more familiar method of spanwise blowing near the wing leading edge. Another joint program among NASA/McDonnell Aircraft Company/U.S. Air Force Wright Aeronautical Laboratory investigated the effects of reverse thrust on the low-speed aerodynamics of an F-15 configuration. The F-15 model was fitted with a rotating van thrust reverser concept which could simulate both in-flight reversing for approach and landing or full reversing for ground roll reduction. The significant results of these two joint programs are reported.

Banks, D. W.↗

Thrust-induced effects on low-speed aerodynamics of fighter aircraft

The design and technology requirements for STOL fighter aircraft as defined in NASA studies are reviewed. The research has concentrated on advanced high-lift systems using mechanical flaps, methods of obtaining longitudinal trim during the use of thrust vectoring, and thrust reversal to shorten ground roll distances. Several early configurations are described, and investigations of the effect of thrust reversal on the low-speed aerodynamics of the F-15 are detailed. Although the NASA design was a wing-canard configuration, similarities in a Grumman baseline STOL aircraft allowed incorporation of the Grumman nacelle, primary nozzles, spanwise blowing nozzles, and trailing-edge flap systems.

Banks, D. W.↗

Effect of sweep and aspect ratio on the longitudinal aerodynamics of a spanloader wing in and out of ground effect

A wind tunnel investigation was conducted in the Langley 4 by 7 meter tunnel to determine the effects of leading edge sweep, aspect ratio, flap deflection, and elevon deflection on the longitudinal aerodynamic characteristics of a span distributed load advanced cargo aircraft (spanloader). Model configurations consisted of leading edge sweeps of 0, 15, 30 and 45 deg and aspect ratios of approximately 2, 4, 6, and 8. Data were obtained for angles of attack of -8 to 18 deg out of ground effect and at angles of attack of -2, 0, and 2 deg in ground effect at Mach number equal 0.14. Flap and elevon deflections ranged from -20 to 20 deg. The data are represented in tabulated form.

Kjelgaard, S. O.↗

An analysis of thrust-induced effects on the longitudinal aerodynamics of STOL fighter configurations

An analysis of the thrust-induced longitudinal aerodynamic characteristics of three fighter-type configurations is presented. A brief discussion of the take-off and landing requirements for the next generation fighter aircraft leads to the conclusion that advances in lift coefficient and thrust reversing will be required to allow short-field operation. Typical power-on longitudinal aerodynamic data for the three fighter configurations, indicating different approaches to meeting the high-lift coefficient requirement, are discussed. Thrust reversing is not addressed in this paper. The power-on data are analyzed to determine what power effects are present, that is, direct thrust, boundary-layer control, vortex flows, or supercirculation. The results of the analysis indicate, for the configurations studied, that induced effects are small compared to direct thrust and that boundary-layer control, rather than leading-edge vortex flows or supercirculation, is the only significant thrust-induced effect.

Paulson, J. W., Jr.↗

Summary of low-speed longitudinal aerodynamics of two powered close-coupled wing-canard fighter configurations

Investigations of the low speed longitudinal characteristics of two powered close coupled wing-canard fighter configurations are discussed. Data obtained at angles of attack from -2 deg to 42 deg, Mach numbers from 0.12 to 0.20, nozzle and flap deflections from 0 deg to 40 deg, and thrust coefficients from 0 to 2.0, to represent both high angle of attack subsonic maneuvering characteristics and conventional takeoff and landing characteristics are examined. Data obtained with the nozzles deflected either 60 deg or 90 deg and the flaps deflected 60 deg to represent vertical or short takeoff and landing characteristics are discussed.

Paulson, J. W., Jr.↗

Low-speed aerodynamic performance of a high-aspect-ratio supercritical-wing transport model equipped with full-span slat and part-span double-slotted flaps

An investigation was conducted in the Langley V/STOL tunnel to determine the static longitudinal and lateral-directional aerodynamic characteristics of an advanced high-aspect-ratio supercritical-wing transport model equipped with a full-span leading-edge slat and part-span double-slotted trailing-edge flaps. This wide-body transport model was also equipped with spoiler and aileron control surfaces, flow-through nacelles, landing gear, movable horizontal tails, and interchangeable wing tips with aspect ratios of 10 and 12. The model was tested with leading-edge slat and trailing-edge flap combinations representative of cruise, climb, takeoff, and landing wing configurations. The tests were conducted at free-stream conditions corresponding to Reynolds numbers (based on mean geometric chord) of 0.97 to 1.63 x 10 to the 6th power and corresponding Mach numbers of 0.12 to 0.20, through an angle-of-attack range of -2 deg to 24 deg and a sideslip-angle range of -10 deg to 5 deg.

Morgan, H. L., Jr.↗

Powered low-aspect-ratio Wing In Ground effect (WIG) aerodynamic characteristics

A wing-in-ground effect configuration was investigated. The configuration used large diameter, low pressure ratio fans mounted about 0.76 wing chord ahead of the wing leading edge to achieve a power augmented ram wing during operation in ground effect. Tests of both in and out of ground effect aerodynamic transition characteristics from very low speeds to cruise speeds are described. The investigation provided a number of conclusions concerning the aerodynamic/propulsive performance interaction. While power augmented lift is required for low speed flight, there is a thrust loss when the efflux is trapped under the wing which reduced the effective thrust to weight available for acceleration by about a third of the installed thrust to weight ratio.

Thomas, J. L.↗