Ultra-Wide-Bandgap Semiconductors: Challenges and Opportunities (invited).
Abstract not provided.
Kaplar, Robert↗
Engineering topics
Pavlidis, Dimitris
Publications and source records attributed to Pavlidis, Dimitris.
Quantum state transfer in double-quantum-well devices
A Monte Carlo simulation of double-quantum-well (DQW) devices is presented in view of analyzing the quantum state transfer (QST) effect. Different structures, based on the AlGaAs/GaAs system, were simulated at 77 and 300 K and optimized in terms of electron transfer and device speed. The analysis revealed the dominant role of the impurity scattering for the QST. Different approaches were used for the optimization of QST devices and basic physical limitations were found in the electron transfer between the QWs. The maximum transfer of electrons from a high to a low mobility well was at best 20%. Negative differential resistance is hampered by the almost linear rather than threshold dependent relation of electron transfer on electric field. By optimizing the doping profile the operation frequency limit could be extended to 260 GHz.
Jakumeit, Jurgen↗
Experimental characteristics and performance analysis of monolithic InP-based HEMT mixers at W-band
Experimental characteristics of monolithic InAlAs/InGaAs HEMT mixers are presented together with a theoretical analysis. Experiments at W-band show a maximum conversion gain of 0.9 dB with 2 dBm of LO power level. This is the first demonstration of a monolithic HEMT mixer with conversion gain at W-band. The conversion gain dependence on LO power, RF frequency and gate bias is measured and compared with the theoretical predictions. Good agreement between the theory and experiment could be found.
Kwon, Youngwoo↗
A study of subterahertz HEMT monolithic oscillators
A detailed study of monolithic InP-based HEMT oscillators for subterahertz operation is presented. InAlAs/InGaAs HEMT's have been optimized for high frequency operation and showed very high maximum oscillation frequencies (f(sub max)) of 310 GHz using offset self-aligned gamma-gate technology. Power characteristics of HEMT oscillators are reported. An oscillation power of more than 10 mW was evaluated by large-signal analysis at 320 GHz using HEMT's with f(sub max) = 450 GHz, V(sub br) = 10 V and a gate width (W(sub g)) of 8 x 22.5 microns. Oscillator topology studies showed that complex feedback schemes such as dual and active feedback enhance the negative resistance. Push-push oscillator designs based on harmonic signal generation can finally be used to overcome the frequency barrier imposed by f(sub max).
Kwon, Youngwoo↗
An evaluation of HEMT potential for millimeter-wave signal sources using interpolation and harmonic balance techniques
A large-signal analysis method based on an harmonic balance technique and a 2-D cubic spline interpolation function has been developed and applied to the prediction of InP-based HEMT oscillator performance for frequencies extending up to the submillimeter-wave range. The large-signal analysis method uses a limited number of DC and small-signal S-parameter data and allows the accurate characterization of HEMT large-signal behavior. The method has been validated experimentally using load-pull measurement. Oscillation frequency, power performance, and load requirements are discussed, with an operation capability of 300 GHz predicted using state-of-the-art devices (fmax is approximately equal to 450 GHz).
Kwon, Youngwoo↗
Frequency-dependent characteristics and trap studies of lattice-matched (x = 0.53) and strained (x greater than 0.53) In(0.52)Al(0.48)As/In(x)Ga(1-x)As HEMT's
The low-frequency characteristics of InAlAs/In(x)Ga(1-x)As high-electron-mobility transistors (HEMTs) are studied, and trap densities are evaluated. The HEMTs' transconductance g(m) and output resistance R(ds) dispersion are smallest for 60 percent indium (In) content and largest for 53 percent In. The maximum dispersion for the 53 percent In sample is about 6 percent for g(m) and about 13.3 percent for R(ds), corresponding to lower values than observed in MESFETs. The R(ds) dispersion characteristics are weaker than in AlGaAs/GaAs HEMTs and manifest themselves primarily up to 100 kHz. An analysis of the dispersion results indicates that, unlike in the case of MESFETs, the channel region under the gate rather than the access regions is responsible for the dispersion. Interface state densities were extracted by the AC conductance method and were found to follow the same trend as the g(m) and R(ds) dispersion.
Ng, Geok-Ing↗
Self-consistent analysis of lattice-matched and pseudomorphic quantum-well emission transistors
A self-consistent analysis of the quantum-well emission transistor (QWET) is presented allowing an exact calculation of the device quantum properties. Poisson's and Schroedinger's equation are solved numerically using a finite-difference method on a self-consistent basis. Pseudomorphic AlGaAs/InGaAs designs with 15-20 percent excess In are suggested for improving the device performance. Design with doping in various parts of the QWET are also studied. This analysis reveals that the device performance is less optimistic than previously predicted by analytic approaches. By introducing the pseudomorphic channel principle, while maintaining a reasonably low Al content for the gate and collector layers, it is, however, possible to obtain satisfactory performance. Optimum pseudomorphic designs showed high current driving capability (200,000 A/sq cm), high transconductance (3S/mm), and small intrinsic delay time (2 ps).
Hong, Kyushik↗
Millimeter-wave and optoelectronic applications of heterostructure integrated circuits
The properties are reviewed of heterostructure devices for microwave-monolithic-integrated circuits (MMICs) and optoelectronic integrated circuits (OICs). Specific devices examined include lattice-matched and pseudomorphic InAlAs/InGaAs high-electron mobility transistors (HEMTs), mixer/multiplier diodes, and heterojunction bipolar transistors (HBTs) developed with a number of materials. MMICs are reviewed that can be employed for amplification, mixing, and signal generation, and receiver/transmitter applications are set forth for OICs based on GaAs and InP heterostructure designs. HEMTs, HBTs, and junction-FETs can be utilized in combination with PIN, MSM, and laser diodes to develop novel communication systems based on technologies that combine microwave and photonic capabilities.
Pavlidis, Dimitris↗