Search NASA⌕ Search

Engineering topics

Pei, S

Publications and source records attributed to Pei, S.

Substrate Hybridization and Rippling of Graphene Evidenced by Near-Edge X-ray Absorption Fine Structure Spectroscopy

Interfacial interactions at graphene/metal and graphene/dielectric interfaces are likely to profoundly influence the electronic structure of graphene. We present here the first angle-resolved near-edge X-ray absorption fine structure (NEXAFS) spectroscopy study of single- and bilayered graphene grown by chemical vapor deposition on Cu and Ni substrates. The spectra indicate the presence of new electronic states in the conduction band derived from hybridization of the C-{pi} network with Cu and Ni d-orbitals. In conjunction with Raman data demonstrating charge transfer, the NEXAFS data illustrate that the uniquely accessible interfaces of two-dimensional graphene are significantly perturbed by surface coatings and the underlying substrate. NEXAFS data have also been acquired after transfer of graphene onto SiO{sub 2}/Si substrates and indicate that substantial surface corrugation and misalignment of graphene is induced during the transfer process. The rippling and corrugation of graphene, studied here by NEXAFS spectroscopy, is thought to deleteriously impact electrical transport in graphene.

36 MATERIALS SCIENCE↗

Damping Effect Studies for X-band Normal Conducting High Gradient Standing Wave Structures

The Multi-TeV colliders should have the capability to accelerate low emittance beam with high rf efficiency, X-band normal conducting high gradient accelerating structure is one of the promising candidate. However, the long range transverse wake field which can cause beam emittance dilution is one of the critical issues. We examined effectiveness of dipole mode damping in three kinds of X-band, {pi}-mode standing wave structures at 11.424GHz with no detuning considered. They represent three damping schemes: damping with cylindrical iris slot, damping with choke cavity and damping with waveguide coupler. We try to reduce external Q factor below 20 in the first two dipole bands, which usually have very high (R{sub T}/Q){sub T}. The effect of damping on the acceleration mode is also discussed.

43 PARTICLE ACCELERATORS↗

Conceptual Design of the Drive Beam for a PWFA-LC

Plasma Wake-Field Acceleration (PWFA) has demonstrated acceleration gradients above 50 GeV/m. Simulations have shown drive/witness bunch configurations that yield small energy spreads in the accelerated witness bunch and high energy transfer efficiency from the drive bunch to the witness bunch, ranging from 30% for a Gaussian drive bunch to 95% for bunch with triangular shaped longitudinal profile. These results open the opportunity for a linear collider that could be compact, efficient and more cost effective than the present microwave technologies. A concept of a PWFA-based Linear Collider (PWFA-LC) has been developed by the PWFA collaboration. Here we will describe the conceptual design and optimization of the drive beam, which includes the drive beam linac and distribution system. We apply experience of the CLIC drive beam design and demonstration in the CLIC Test Facility (CTF3) to this study. We discuss parameter optimization of the drive beam linac structure and evaluate the drive linac efficiency in terms of the drive beam distribution scheme and the klystron/modulator requirements.

43 PARTICLE ACCELERATORS↗

TTF HOM Data Analysis with Curve Fitting Method

To investigate the possibility of using HOM signals induced in SC cavities as beam and cavity diagnostics, narrow band (20 MHz) data was recorded around the strong TE111-6(6{pi}/9-like) dipole modes (1.7 GHz) in the 40 L-band (1.3 GHz) cavities at the DESY TTF facility. The analyses of these data have so far focused on using a Singular Value Decomposition (SVD) technique to correlate the signals with each other and data from conventional BPMs to show the dipole signals provide an alternate means of measuring the beam trajectory. However, these analyses do not extract the modal information (i.e., frequencies and Q's of the nearly degenerate horizontal and vertical modes). In this paper, we described a method to fit the signal frequency spectrum to obtain this information, and then use the resulting mode amplitudes and phases together with conventional BPM data to determine the mode polarizations and relative centers and tilts. Compared with the SVD analysis, this method is more physical, and can also be used to obtain the beam position and trajectory angle.

43 PARTICLE ACCELERATORS↗