Search NASA⌕ Search

Engineering topics

Peng, Fang

Publications and source records attributed to Peng, Fang.

An Inner-Loop Control Method for the Filter-less, Voltage Sensor-less, and PLL-less Grid-Following Inverter-Based Resource

This paper presents a novel inner-loop control method for the inverter-based resource (IBR). The innovative concepts include removing the voltage sensors at the point of common coupling (PCC), removing the inverter interface inductance, and removing the traditional phase-locked loop (PLL) circuits. Simulation is conducted to verify the feasibility of the method. Furthermore, the virtual impedance is applied to the control loop to improve the current THD and dynamics. Compared to the traditional control, the proposed one helps offload the system by reducing the bulky inductors and voltage sensors without compromising the control performance.

grid-forming inverter, inner-loop control, filterl↗

Elucidating the structural properties and reversible regional texture effect of GdB 6 under high pressure

As hard and refractory materials with high chemical resistance and mechanical strength, lanthanide hexaborides (LnB 6 ) have attracted much attention. Among the family of LnB 6 , gadolinium hexaboride (GdB 6 ) occupies a special position due to the half-filled 4f shell of Gd. Here, using in situ synchrotron radiation angle-dispersive X-ray diffraction in a diamond anvil cell at room temperature, the structural stability and compression behavior of GdB 6 are investigated extensively, GdB 6 is observed to be structurally stable up to 73 GPa, and the bulk modulus of 177 GPa is obtained under hydrostatic compression. In this paper, an interesting observation of pressure-induced spotty diffraction rings of GdB6 is reported, its formation mechanism can be well described by the reversible regional texture effect, which highlights the rearrangement of crystal grains under high pressure. The rearrangement mechanism has been well explained by investigating the pressure dependence of full width at half maximum, macro-differential stress and grain size. Collective grain rotation behavior motivated by stress difference is critical for the rearrangement process, the strong isotropy and strong stability of GdB 6 structure also provide necessary conditions for high-pressure grain rotation behavior. These results will help to promote the understanding of high-pressure structural properties of GdB 6 , and provide novel insights on the high-pressure grain behavior in hard materials with strong isotropy and three-dimensional skeleton constituted of strong covalent bonds.

36 MATERIALS SCIENCE↗

Micro-stress dominant displacive reconstructive transition in lithium aluminate

It is supposed that diffusive reconstructive transitions usually take place under hydrostatic pressure or low stresses, and displacive reconstructive phase transitions easily occur at nonhydrostatic pressure. Here, by in-situ high pressure synchrotron X-ray diffraction and single-crystal Raman scattering studies on lithium aluminate at room temperature, we show that the reconstructive transition mechanism is dependent on the internal microscopic stresses rather than the macroscopic stresses. In this case, even hydrostatic pressure can favor the displacive transition if the compressibility of crystal is anisotropic. During hydrostatic compression, γ-LiAlO{sub 2} transforms to δ-LiAlO{sub 2} at about 4 GPa, which is much lower than that in previous nonhydrostatic experiments (above 9 GPa). In the region where both phases coexist, there are enormous microscopic stresses stemming from the lattice mismatch, suggesting that this transition is displacive. Furthermore, the atomic picture is drawn with the help of the shear Raman modes.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Phase transformation and fluorescent enhancement of ErF 3 at high pressure

In this study, pressure-induced phase transformation and fluorescent properties of ErF 3 were investigated here using in-situ synchrotron X-ray diffraction and photoluminescence up to 32.1 GPa at room temperature. Results showed that ErF 3 underwent a reversible pressure-induced phase transition from the β-YF 3 –type to the fluocerite LaF 3 -type at 9.8 GPa. The bulk moduli B 0 for low- and high-pressure phases were determined to be 130 and 208 GPa, respectively. Also, photoluminescencent studies showed that new emission lines belonging to the transition of 2 H 11/2 → 4 I 15/2 , 4 S 3/2 → 4 I 15/2 , and 4 F 9/2 → 4 I 15/2 appeared during phase transition, suggesting pressure-induced electronic band splitting. Remarkably, significant pressure-induced enhancement of photoluminescence was observed, which was attributed to lattice distortion of the material under high pressure.

36 MATERIALS SCIENCE↗

Submicron cubic boron nitride as hard as diamond

Here, we report the sintering of aggregated submicron cubic boron nitride (sm-cBN) at a pressure of 8 GPa. The sintered cBN compacts exhibit hardness values comparable to that of single crystal diamond, fracture toughness about 5-fold that of cBN single crystal, in combination with a high oxidization temperature. Thus, another way has been demonstrated to improve the mechanical properties of cBN besides reducing the grain size to nano scale. In contrast to other ultrahard compacts with similar hardness, the sm-cBN aggregates are better placed for potential industrial application, as their relative low pressure manufacturing perhaps be easier and cheaper.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Exploring the behavior of molybdenum diboride (MoB{sub 2}): A high pressure x-ray diffraction study

Investigation of the equation of state of molybdenum diboride (MoB{sub 2}) has been performed to 24.1 GPa using synchrotron radiation angle-dispersive x-ray diffraction techniques (ADXRD) in a diamond anvil cell (DAC) at room temperature. Rietveld refinement of the X-ray powder diffraction data reveals that the rhombohedral structure MoB{sub 2} is stable up to 24.1 GPa. The ADXRD data yield a bulk modulus K{sub 0} = 314(11) GPa with a pressure derivative K{sub 0}{sup ′} = 6.4(1.5). The experimental data are discussed and compared to the results of first-principles calculations. In addition, the compressibility of the unit cell axes (a and c axes) of MoB{sub 2} demonstrates an anisotropic property with pressure increasing.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

High-pressure x-ray diffraction study of YBO{sub 3}/Eu{sup 3+}, GdBO{sub 3}, and EuBO{sub 3}: Pressure-induced amorphization in GdBO{sub 3}

Angle-dispersive synchrotron X-ray diffraction measurements were performed on vaterite-type YBO{sub 3}/Eu{sup 3+}, GdBO{sub 3}, and EuBO{sub 3}, respectively, up to 41 GPa at room temperature using a diamond-anvil cell. Pressure-induced amorphization was observed in hexagonal GdBO{sub 3} with a significant compression along the c-axis. Compared to the ions of the distorted GdBO{sub 3} phase, its anions may lose their long-range order prior to the cations at high pressures. Based on the experimental pressure-volume data, the obtained bulk moduli of YBO{sub 3}/Eu{sup 3+} and GdBO{sub 3} are 329 and 321 GPa, respectively, which are more than 90% larger than that of EuBO{sub 3} (167 GPa) and are presumably attributed to Gd{sup 3+} and Y{sup 3+} with a high density of d valence electrons.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Z-Source/Current Source Inverter-Topology Analysis, Comparison and Design

The objective of this research is to further reduce the cost, volume and weight of the present power electronics (PE) system in the hybrid electric vehicle (HEV) by 25%. The Toyota Camry PE system is used as the reference. The research efforts will address achieving the 2015 power electronics targets: $\$$5/kW, 12 kW/kg, 12 kW/L.

Nuclear Criticality Safety Program (NCSP)↗

Strength and elastic moduli of TiN from radial x-ray diffraction under nonhydrostatic compression up to 45 GPa

The high pressure behavior of titanium nitride (TiN) was investigated using synchrotron radial x-ray diffraction (RXRD) under nonhydrostatic compression up to 45.4 GPa in a diamond-anvil cell. We obtained the hydrostatic compression equation of state of TiN. Fitting to the third-order Birch-Murnaghan equation of state, the bulk modulus derived from nonhydrostatic compression data varies from 232 to 353 GPa, depending on angle {Psi}, the orientation of the diffraction planes with respect to the loading axis. The RXRD data obtained at {Psi} = 54.7{sup o} yield a bulk modulus K{sub 0} = 282 {+-} 9 GPa with pressure derivative K{prime}{sub 0} fixed at 4. We have analyzed the deformation mechanisms by analyzing the (111), (200), (220), (311), and (222) peaks in the x-ray diffraction under pressures. The ratio of uniaxial stress component to shear modulus t/G ranges from 0.007-0.027 at the pressure of 6.4-45.4 GPa. It was found that the TiN sample could support a maximum uniaxial stress component t of 8.6 GPa, when it started to yield at 45.4 GPa under uniaxial compression. And the aggregate elastic moduli of TiN at high pressure were determined from the synchrotron RXRD measurements.

43 PARTICLE ACCELERATORS↗

Nuclear statistical equilibrium for Type Ia supernova simulations

We solve the equations of nuclear statistical equilibrium (NSE) for the mass fractions of 443 nuclides, including the effects of temperature dependent nuclear partition functions [T. Rauscher, F. Thielemann, At. Data Nucl. Data Tables 75 (2000) 1-351] and Coulomb corrections [G. Chabrier, A.Y. Potekhin, Phys. Rev. E 58 (1998) 4941]. The resulting mass fractions are then convolved with the new weak interaction rates for pf-shell nuclei based on large-scale shell model calculations [K. Langanke, G. Martinez-Pinedo, At. Data Nucl. Data Tables 79 (2001) 1-46] to get the rate of neutronization and the specific neutrino luminosity of matter in NSE. We present tables of the results and give examples of how the tables can be used in Type Ia supernova simulations.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗