Search NASA⌕ Search

Engineering topics

Peng, P.

Publications and source records attributed to Peng, P..

10 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Addressing Data Center Cooling Needs through the Use of Subsurface Thermal Energy Storage Systems

This study aims to evaluate the feasibility of addressing the cooling needs for information technology (IT) equipment in data centers by using reservoir thermal energy storage (RTES) to provide reliable and sustainable low-temperature fluid. This project focuses on the technical viability of operating such a system in Houston, Texas, which is a representative location for crypto mining data centers. An analysis has been performed to investigate the technical feasibility with climate data for Houston. Results show that data centers on the scale of 30 MW, and operating at a temperature of 27 degrees C, can be reliably cooled by a combined RTES and dry coolers setup. A techno-economic analysis will be performed and energy/water saving benefits will be quantified in the future. In addition, the study will be extended to other representative data center locations with different climates and geographical locations.

cooling↗
DOE OSTI2018

Beam-target helicity asymmetry E in K 0 Λ and K 0 Σ 0 photoproduction on the neutron

Here, we report the first measurements of the $E$ beam-target helicity asymmetry for the $\vec{\gamma} \vec{n} \to K^{0}\Lambda$, and $K^{0}\Sigma^{0}$ channels in the energy range of 1.70$\leq W\leq$2.34 GeV. The CLAS system at Jefferson Lab used a circularly polarized photon beam and a target consisting of longitudinally polarized solid molecular hydrogen deuteride (HD) with low background contamination for the measurements. Comparisons with predictions from the KaonMAID, SAID, and Bonn-Gatchina models are presented. These results will help separate the isospin $I=0$ and $I=1$ photo-coupling transition amplitudes in pseudoscalar meson photoproduction.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2018

Formation and Toughening Mechanisms of Dispersions in Interfacial Intermetallics of Dissimilar Laser Al/Steel Joints

The key to improve the strength of Al/steel dissimilar joint is to toughen the hard and brittle interfacial intermetallics. Introducing soft and tough dispersions into the interfacial intermetallics would be a promising method. In the present study, Zn-Al alloy (Zn-22Al) was used as the filler metal to generate dispersions in the interfacial intermetallics matrix of dissimilar laser Al/steel joint. The results have shown that soft and tough dispersions, i.e., FeZn{sub 10,} Al-rich amorphous phase, and Zn solid solution, were successfully introduced into the hard and brittle Fe{sub 2}Al{sub 5−x}Zn{sub x} matrix. The formation of these dispersions was resulted from diffusion of elements Fe and Al and infiltration of liquid Zn along the grain boundaries of Fe{sub 2}Al{sub 5−x}Zn{sub x} matrix and the subsequent chemical reaction and solidification. With this kind of interfacial microstructure, the joint exhibited a stable peak fracture load of 1200 N even though the interfacial layer thickness increased from 20 to 45 μm. This was because the interfacial layer was toughened by the soft and tough dispersions. Using this example, introduction of soft and tough dispersions into hard and brittle intermetallics matrix to toughen interfacial layer and then strengthening of dissimilar joints will be highlighted.

36 MATERIALS SCIENCE↗
DOE OSTI2017

Beam-target helicity asymmetry for γ → n → → π - p in the N * resonance region

In this paper, we report the first beam-target double-polarization asymmetries in the $\gamma + n(p) \rightarrow \pi^- + p(p)$ reaction spanning the nucleon resonance region from invariant mass $W$= $1500$ to $2300$ MeV. Circularly polarized photons and longitudinally polarized deuterons in $HD$ have been used with the CLAS detector at Jefferson Lab. The exclusive final state has been extracted using three very different analysis techniques that show excellent agreement, and these have been used to deduce the $E$ polarization observable for an effective neutron target. These results have been incorporated into new partial wave analyses, and have led to revised values for several $\gamma nN^*$ resonance photo-couplings.

43 PARTICLE ACCELERATORS↗
DOE OSTI2017

Target and beam-target spin asymmetries in exclusive pion electroproduction for Q 2 > 1 GeV 2 . I. e p → e π + n

Beam-target double-spin asymmetries and target single-spin asymmetries were measured for the exclusive π+ electroproduction reaction γ*p → nπ + . The results were obtained from scattering of 6-GeV longitudinally polarized electrons off longitudinally polarized protons using the CEBAF Large Acceptance Spectrometer at Jefferson Laboratory. The kinematic range covered is 1.1 < W < 3 GeV and 1 < Q 2 < 6GeV 2 . Results were obtained for about 6000 bins in W, Q 2 , cos(θ*), and Φ*. Except at forward angles, very large target-spin asymmetries are observed over the entire W region. Reasonable agreement is found with phenomenological fits to previous data for W < 1.6 GeV, but very large differences are seen at higher values of W. Finally, a generalized parton distributions (GPD)-based model is in poor agreement with the data. When combined with cross-sectional measurements, the present results provide powerful constraints on nucleon resonance amplitudes at moderate and large values of Q 2 , for resonances with masses as high as 2.4 GeV.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2017

Target and beam-target spin asymmetries in exclusive pion electroproduction for Q 2 > 1 GeV 2 . II. e p → e π 0 p

Beam-target double-spin asymmetries and target single-spin asymmetries were measured for the exclusive π + electroproduction reaction γ*p→nπ + . The results were obtained from scattering of 6-GeV longitudinally polarized electrons off longitudinally polarized protons using the CEBAF Large Acceptance Spectrometer at Jefferson Laboratory. The kinematic range covered is 1.1 < W < 3 GeV and 1 < Q 2 < 6GeV 2 . Results were obtained for about 6000 bins in W, Q 2 , cos(θ*), and Φ*. Except at forward angles, very large target-spin asymmetries are observed over the entire W region. Reasonable agreement is found with phenomenological fits to previous data for W < 1.6 GeV, but very large differences are seen at higher values of W. A generalized parton distributions (GPD)-based model is in poor agreement with the data. As a result, when combined with cross-sectional measurements, the present results provide powerful constraints on nucleon resonance amplitudes at moderate and large values of Q 2 , for resonances with masses as high as 2.4 GeV.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2016

Dual role of monolayer MoS{sub 2} in enhanced photocatalytic performance of hybrid MoS{sub 2}/SnO{sub 2} nanocomposite

The enhanced photocatalytic performance of various MoS{sub 2}-based nanomaterials has recently been observed, but the role of monolayer MoS{sub 2} is still not well elucidated at the electronic level. Herein, focusing on a model system, hybrid MoS{sub 2}/SnO{sub 2} nanocomposite, we first present a theoretical elucidation of the dual role of monolayer MoS{sub 2} as a sensitizer and a co-catalyst by performing density functional theory calculations. It is demonstrated that a type-II, staggered, band alignment of ∼0.49 eV exists between monolayer MoS{sub 2} and SnO{sub 2} with the latter possessing the higher electron affinity, or work function, leading to the robust separation of photoexcited charge carriers between the two constituents. Under irradiation, the electrons are excited from Mo 4d orbitals to SnO{sub 2}, thus enhancing the reduction activity of latter, indicating that the monolayer MoS{sub 2} is an effective sensitizer. Moreover, the Mo atoms, which are catalytically inert in isolated monolayer MoS{sub 2}, turn into catalytic active sites, making the monolayer MoS{sub 2} to be a highly active co-catalyst in the composite. The dual role of monolayer MoS{sub 2} is expected to arise in other MoS{sub 2}-semiconductor nanocomposites. The calculated absorption spectra can be rationalized by available experimental results. These findings provide theoretical evidence supporting the experimental reports and pave the way for developing highly efficient MoS{sub 2}-based photocatalysts.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
NASA NTRS1981

Pupillometry, a bioengineering overview

The pupillary control system is examined using a microprocessor based integrative pupillometer. The real time software functions of the microprocessor include: data collection, stimulus generation and area to diameter conversion. Results of an analysis of linear and nonlinear phenomena are presented.

Myers, G.↗