Search NASA⌕ Search

Engineering topics

Peruso, C. J.

Publications and source records attributed to Peruso, C. J..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Preliminary submillimeter spectroscopic measurements using a submillimeter heterodyne radiometer

A submillimeter heterodyne radiometer uses a submillimeter laser, pumped by a CO2 laser, as a local oscillator and a room temperature Schottky barrier diode as the first IF mixer. The radiometer can resolve spectral lines in the submillimeter region of the spectrum (arising from pure rotational molecular transitions) to within 0.3 MHz, using acousto-optic spectrum analyzer which measures the power spectrum by simultaneously sampling 0.3 MHz wide channels over a 100 MHz bandwidth spanning the line. Preliminary observations of eight spectral lines of H2O2, CO, NH3 and H2O, all lying in the 434-524 micrometer wavelength range are described. All eight lines were observed using two local oscillator frequencies obtained by operating the submillimeter laser with either methyl fluoride (CH3F) or formic acid (HCOOH) as the lasing gas. Sample calculations of line parameters from the observed data show good agreement with established values. One development goal is the size and weight reduction of the package to make it suitable for balloon or shuttle experiments to detect trace gases in the upper atmosphere.

Safren, H. G.↗
NASA NTRS1978

Life test results for an ensemble of CO2 lasers

The effects of cathode material, cathode operating temperature, anode configuration, window materials, and hydrogen additives on laser lifetime are determined. Internally oxidized copper and silber-copper alloy cathodes were tested. The cathode operating temperature was raised in some tubes through the use of thermal insulation. Lasers incorporating thermally insulated silver copper oxide cathodes clearly yielded the longest lifetimes-typically in excess of 22,000 hours. The use of platinum sheet versus platinum pin anodes had no observable effect on laser lifetime. Similarly, the choice of germanium, cadmium telluride, or zinc selenide as the optical window material appears to have no impact on lifetime.

Peruso, C. J.↗
NASA NTRS1977

Single mode CO2 laser frequency modulation up to 350 MHz

Experiments on internal frequency modulation (FM) of a CO2 laser showed no limitation of FM by the linewidth. However, distortions in the form of strong enhancement of sideband amplitude arise for frequencies equal to the cavity resonant frequencies, most pronounced if the modulator is positioned near a cavity mirror.

Leeb, W. R.↗
NASA NTRS1972

The BAPE 2 balloon-borne CO2

The systems and techniques which were utilized in the experiment to establish an air-to-ground CO2 laser heterodyne link are described along with the successes and problems encountered when the heterodyne receiver and laser transmitter package were removed from the controlled environment of the laboratory. Major topics discussed include: existing systems and the underlying principles involved in their operation; experimental techniques and optical alignment methods which were found to be useful; theoretical calculations of signal strengths expected under a variety of test conditions and in actual flight; and the experimental results including problems encountered and their possible solutions.

Degnan, J. J.↗
NASA NTRS1972

Multichannel television coupling modulation experiments using a CO2 laser.

Experiments are described in which a carbon dioxide laser oscillating at 28.4 THz has been modulated simultaneously by three commercial television signals with carriers at 54, 66, and 82 MHz. Signal-to-noise degradation in the system was measured to be less than 1 dB, corresponding to modulator drive power of 1 W. This combination of wide bandwidth and low power consumption was made possible by the application of coupling modulation. This technique employs an intracavity electrooptic crystal to which the modulating fields are applied. Despite the fact that the crystal is positioned inside the laser cavity, the maximum bandwidth attainable is independent of both the cavity Q and the laser transition linewidth, and is limited only by modulator characteristics and optical transit time. Rigrod's (1965) method has been adapted to obtain an expression for the power coupled out of the laser. Modulator frequency response and drive power requirements are also summarized. It is seen that the noise bandwidth performance of the system would allow simultaneous modulation by 17 color television channels, or equivalently, more than a 300-megabit/sec capacity.

Hall, D. R.↗