Engineering topics

Petty, C. C.

Publications and source records attributed to Petty, C. C..

9 records

DOE OSTI2022

Examination of stiff ion temperature gradient mode physics in simulations of DIII-D H-mode transport

A systematic evaluation of gyrokinetic and gyrofluid model predictions of ion temperature gradient (ITG) stability and transport using parameters from DIII-D high confinement mode (H-mode) plasmas has been performed. The nonlinear CGYRO code is used to make the gyrokinetic predictions, and the quasilinear TGLF model for the corresponding gyrofluid predictions. The assessments are made at three radii (normalized toroidal flux ρtor = 0.4, 0.55, and 0.7) in three different plasma scenarios with varying levels of neutral beam heating and torque. For each of the nine cases (3 radii × 3 scenarios) considered, ITG turbulence is found to be the dominant long-wavelength instability and transport mechanism. The inclusions of both transverse magnetic fluctuations and dynamic fast beam ions are stabilizing for all cases considered, with strongest effects seen at ρor = 0.4 where the fast ion population and normalized plasma pressure β = 2μ0nT/B2 are highest. The further inclusion of parallel magnetic fluctuations does not have a meaningful impact on the ITG turbulence in these scenarios, but does destabilize (in combination with fast ions) new high-frequency instabilities at ρtor = 0.4 in the high power scenarios. In each case the linear and nonlinear ITG critical gradients are predicted to be lower than the measured ITG scale lengths and their associated uncertainties. Inclusion of equilibrium flow shear in the transport predictions generally leads to an upshift in effective critical gradient rather than a qualitative change in the predicted stiffness, with stronger responses typically seen in the gyrokinetic predictions than in the gyrofluid results. However, in most cases these upshifted gradients still remain below the measured values and their uncertainties. Although the predicted critical gradients are below the measured gradients, both models predicted flux-matching gradients consistent with measured values in six of the nine cases considered, with no clear systematic over- or underprediction. Thus, while the experimental ion temperature profiles do not appear to be closely pinned to the ITG critical gradient, both gyrokinetic and gyrofluid models are able to accurately match the measured gradients reasonably well in most cases.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Doubling off-axis electron cyclotron current drive efficiency via velocity space engineering

For the first time, experiments on the DIII-D tokamak have demonstrated electron cyclotron current drive with more than double the conventional efficiency by tailoring the wave–particle interactions in velocity space using a novel ‘top launch’ geometry. Steering the EC waves to propagate nearly parallel to the resonance drives current more efficiently by (1) selective damping on electrons with higher parallel velocity v ||, and (2) longer absorption path to compensate for inherently weaker absorption at higher v ||. Experiments using a fixed-injection top launch system find an optimal velocity space interaction for maximum current drive efficiency at ρ ~ 0.5 where the ease of drawing out a high v || electron tail is balanced by sufficient absorption.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

The high-power helicon program at DIII-D: gearing up for first experiments

Helicon current drive, also called fast wave current drive in the lower hybrid range of frequencies, has long been regarded as a promising current drive tool for reactor grade plasmas. A newly installed MW-level system at DIII-D will be the first test of this technology in reactor-relevant plasmas, in the sense that full single-pass absorption is expected. A 30-module traveling wave antenna has been installed and optimized in-vessel in early 2020. The linear electromagnetic characteristics of the unloaded module array have been extensively tested both on the bench and in the vessel at instrumentation power levels. Excellent performance has been achieved, ~2% reflected power and ~1.5% dissipated power per module in air, in a 10 MHz band around 476 MHz. Stripline feeds on both ends of the antenna allow either co or counter current drive. The installation of a 1.2 MW klystron and associated high-power electronics was completed in Fall 2020. Commissioning of the antenna is ongoing. An important goal of this experiment is to validate the helicon current drive physics basis using an extensive set of new and upgraded diagnostics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Achievement of Reactor-Relevant Performance in Negative Triangularity Shape in the DIII-D Tokamak

Plasma discharges with a negative triangularity (δ=−0.4) shape have been created in the DIII-D tokamak with a significant normalized beta (βN=2.7) and confinement characteristic of the high confinement mode (H98y2=1.2) despite the absence of an edge pressure pedestal and no edge localized modes (ELMs). These inner-wall-limited plasmas have a similar global performance as a positive triangularity (δ=+0.4) ELMing H-mode discharge with the same plasma current, elongation and cross sectional area. For cases both of dominant electron cyclotron heating with Te/Ti>1 and dominant neutral beam injection heating with Te/Ti=1, turbulent fluctuations over radii 0.5<ρ<0.9 were reduced by 10–50% in the negative triangularity shape compared to the matching positive triangularity shape, depending on the radius and conditions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

L-H transition trigger physics in ITER-similar plasmas with applied n = 3 magnetic perturbations

The L–H transition power threshold PLH is observed to increase with applied n = 3 resonant magnetic perturbations (RMP) in ITER-similar-shape plasmas with balanced neutral beam torque injection in DIII-D. The increase is most pronounced with added electron–cyclotron heating: PLH increases with decreasing edge plasma collisionality as PLH/PLH-08 ~ (ν*)−0.5, where PLH-08 is the 2008 ITPA multi-machine power threshold scaling. This result raises concerns for H-mode access at low edge collisionality in ITER, where RMP may have to be applied before the L–H transition to safely suppress the first edge-localized mode. Non-axisymmetric modifications with RMP include a simultaneous reduction of the radial electric field (Er) well depth and E × B shear. This can be attributed to increasing edge toroidal co-current rotation, and is consistent with substantially increased local long-wavelength turbulence (measured via beam emission spectroscopy). At high RMP perturbation strength the edge electric field Er reverses sign locally (becomes positive), with changes in dominant turbulence modes. Edge magnetic stochasticity provides an attractive explanation of the observed modifications, and the observed changes in toroidal rotation and Er are consistent with a simple fluid model describing radial electron current flow along stochastic fieldlines. The observed collisionality dependence of the L-mode edge electric field with applied RMP is also qualitatively consistent with this model. Reflectometry data indicate a significant reduction of the normalized L-mode radial density gradient a/Ln at high RMP field with simultaneous increase in radial particle flux and electron thermal flux from power balance analysis. We conjecture that the increase of PLH with RMP results from the combined effects of reduced E × B flow shear (increasing turbulent transport levels) and toroidal/poloidal flow modulation due to edge stochasticity. Initial experiments indicate that non-resonant n = 3 magnetic perturbations lead only to relatively small changes in Er, E × B shear and fluctuation characteristics, and have less impact on the L–H transition power threshold. This motivates further exploration of the RMP spectrum dependence of PLH for possible mitigation of the observed threshold increase.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Response of thermal and fast-ion transport to beam ion population, rotation and T e / T i in the DIII-D steady state hybrid scenario

The thermal and fast-ion transport properties of DIII-D steady-state hybrid discharges with normalized beta β N ≳ 3 are studied at low injected torque and an increased electron to ion temperature ratio T e / T i . Linear stability analysis performed with the TGLF turbulent code indicates that a high-k mode is usually dominant at smaller radii, whereas a low-k mode is usually dominant at larger radii in these plasmas. A reduction in the net injected torque from 8.6 to 4.3 N-m leads to reduced E × B shear and hence, an enhanced turbulence that was observed on the Doppler backscattering diagnostic and was also computed with TGLF. As T e / T i in the core was increased from 0.57 to 0.66 by adding electron cyclotron current drive (ECCD) to these plasmas, higher levels of transport are observed with increased high-k modes indicated by TGLF. The fast-ion transport level varied over an order of magnitude in these discharges depending on whether Alfvén eigenmodes, fishbones, or no instabilities were observed. Hybrid plasmas with fishbones have decreased fast-ion transport, compared to plasmas with Alfvén eigenmodes, since they are resonant with a smaller portion of phase space and their resonance is farther from the wall. This reduction in fast-ion transport with ECCD mitigates the increase in turbulent transport, resulting in higher performance than expected during strong electron heating. Similarly, the lowest fast-ion transport was observed in the low torque plasma, which also led to better than expected performance at this torque value. Finally, the thermal and fast-ion transport changes observed as the torque/rotation and T e / T i are varied indicate possible methods for transferring this scenario to a reactor.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Grassy ELM regime at low pedestal collisionality in high-power tokamak plasma

Spontaneous mitigation of giant ELMs and appearance of grassy ELMs have been observed repeatedly at low pedestal collisionality (${\nu }_{\mathrm{e},\mathrm{p}\mathrm{e}\mathrm{d}}^{{\ast}}\sim 0.15$) in the high-power (P inj > 13 MW) hybrid scenario in DIII-D. Higher β p and higher q 95 appear to be beneficial to achieving the grassy ELM regime. The grassy ELM H-mode plasma shows high energy confinement performance (H 98y2 up to over 1.5) under the conditions of high neutral beam torque and high core rotation. The pedestal width appears to exceed the EPED1.0 model prediction by more than 50%. Pedestal stability analysis performed with the ELITE code indicates that the stability against low-n kink/peeling modes is improved with increased auxiliary heating power and the operational point in the grassy ELM regime is located near the ballooning boundary. The pedestal stability characteristics during the grassy ELM crashes have been investigated in comparison with the giant ELM crashes based on plasma profiles experimentally measured with high resolution and accuracy. It has been found that the underlying mechanism for the observed small-amplitude ELM crashes is mainly the expansion of the ballooning stability boundary induced by an initial radially localized collapse in the pedestal, which helps to stop the growth of instabilities and further collapse of the pedestal. The effect of electron density pedestal on mitigating edge localized instabilities has been analyzed by numerical simulation, suggesting that the electron density pedestal characterized by high n e,sep /n e,ped and low density gradient helps to stabilize peeling-ballooning modes because of a low pressure pedestal gradient and to lower the ballooning boundary mainly because of a low ion diamagnetic frequency in the pedestal region, thus triggering ballooning instabilities and producing the intrinsic grassy ELMs. Numerical simulation of the Chinese fusion engineering test reactor (CFETR) with the SOLPS code indicates that the separatrix density might be insensitive to the electron diffusivity in the pedestal region and increase with the power flowing from the core region to the edge region. Furthermore, pedestal stability analysis suggests that the flat density pedestal with high separatrix density obtained in the high-power plasma in CFETR would make the operational point close to the ballooning boundary, which is considered to help destabilize ballooning instabilities and facilitate the access to the grassy ELM regime.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Magnetic shear effect on plasma transport at T e / T i ~ 1 through electron cyclotron heating in DIII-D plasmas

The effect of magnetic shear on plasma transport for an electron to ion temperature ratio ( T e / T i ) near unity has been explored in DIII-D utilizing electron cyclotron heating (ECH). Previous reports showed that significant confinement degradation occurred at T e / T i ~ 1 in positive shear (PS) plasmas in DIII-D, whereas reduced confinement degradation was observed in negative central shear (NCS) plasmas. In this study, plasma transport in weak magnetic shear (WS) plasmas with ECH is investigated and compared with that in NCS and PS plasmas. Here the magnetic shears ($\hat s$) are $\hat s$ > 0.5, ~0 and <-0.1 in the core region (ρ~ 0.3–0.4) of PS, WS and NCS plasmas, respectively, and flat or negative inside ρ~ 0.4 in the WS and NCS plasmas. Weak magnetic shear is found to be effective in minimizing degradation of ion thermal confinement as T e / T i increases through ECH application, and an improved confinement factor of H 98y2 ~ 1.2 is maintained, similar to NCS plasmas. At T e / T i ~ 1, the ion thermal diffusivity around an internal transport barrier decreases when changing the magnetic shear from positive to weak or negative shear. Also, reduced local particle and momentum transport was indicated by steeper density and toroidal rotation profiles in the weak and negative shear regimes. Linear gyrokinetic simulations predict little change in growth rates of low-k turbulence with ECH application in the WS and NCS plasmas, which is consistent with the transport and profile analyses.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Collisionality driven turbulent particle transport changes in DIII-D H-mode plasmas

The results of the experimental dimensionless scan in this paper confirm that there is an increase in density peaking towards lower collisionality and that this can be partly linked to a shift in the turbulence regime from ITG towards TEM. However at the lowest collisionality, the changes in turbulence and transport are much more pronounced than expected from direct collisionality effect on the turbulence. In this paper, the collisionality, ν * is varied by a factor 5, while keeping ρ * , q , β , M , fixed. Additionally, a 3 Hz gas puff modulation is applied to modulate the electron density profile and extract the perturbed transport coefficients using two diagnostics. The transport analysis shows that the increase in density peaking at low ν * is linked to an increase in the inward particle pinch and not an increase in core fueling. These observations are not only in agreement with prior modeling scans of how turbulence changes as a function of collisionality and its impact upon the particle fluxes, but also with the multi-machine database (Fable E. et al 2010 Plasma Phys. Control. Fusion 52 015007) (Angioni C. et al 2003 Phys. Rev. Lett. 90 205003). The changes in turbulence across the collisionality scan were captured at large scale by the BES and at smaller scale by the DBS. A comparison with gradient-driven GENE simulations showed similar trends at both scales. Moreover, the changes observed in overall transport are in agreement with gradient-driven TGLF particle flux simulations. This indicates that TGLF/GENE when given the gradients as input, are able to reproduce the experimentally observed turbulence changes.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗