Search NASA⌕ Search

Engineering topics

Phongikaroon, Supathorn

Publications and source records attributed to Phongikaroon, Supathorn.

5 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Determination and Comparison of Parameters from Cyclic Voltammetry of LaCl 3 in Eutectic LiCl-KCl

Electrochemical measurements of LaCl 3 were obtained in eutectic LiCl-KCl at 773 K. Cyclic voltammetry data were acquired using a tungsten electrode LaCl 3 amounts in the molten salt in the range of 0.5 to 3.0 wt%. Both cyclic voltammetry and Tafel analyses of the data resulted in calculation of values for the charge transfer coefficient (0.262), diffusion coefficient (1.67 × 10 -5 cm 2 s -1 ), exchange current density (0.0148 to 0.0473 A cm -2 ), and charge transfer resistance (0.404 to 1.99 Ω) related to lanthanum ions in the molten salt. Calculated values were compared to those available in the literature. The values of parameters found in literature varied significantly in comparison to those in the present study due to dissimilar experimental conditions, e.g., electrode material, temperature, and LaCl 3 concentration.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2021

Rapid dissolution of PuO 2 analytical samples using mediated electrochemical oxidation

Current methods for quantitative dissolution of solid PuO 2 involve lengthy dissolution times. The adaptation of mediated electrochemical oxidation, which uses an electrochemically produced oxidizing agent to catalyze dissolution, has been explored for radiochemical analysis scale dissolutions of PuO 2 . The effects of temperature, electrode material, and electrocatalyst on the dissolution kinetics were explored. Under conditions examined in this study, complete dissolution of tens of milligrams of solid PuO 2 can be achieved in less than 1 h at ambient temperature. Overall, this methodology could be adapted to dissolve other metal oxides.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2020

Fundamental Study of Uranium Dendrites Electrochemically Separated in Molten Salt with the Presence of Cerium

In this study, uranium was electrochemically separated in the presence of cerium in eutectic LiCl-KCl at varying concentrations of cerium and varying overpotentials. Harvested dendrites were then examined and analyzed for their morphological features and elemental composition using various analytical techniques. Conclusions: Increasing the applied overpotential causes the dendrites to evolve from relatively simple and large platelet-like crystals (25 mV), to a grid-like network with crystals having jagged and smooth features (50 mV, 100 mV), and finally into a very chaotic and complex crystal morphology (200 mV) for all uranium-cerium compositions explored. Varying the uranium:cerium concentration ratio did not have much effect on the uranium dendrite morphologies. EDS results show that cerium is not co-deposited on the surface of the dendrite crystals, ICP-MS results do show a presence of cerium in the volumetric composition. This is likely due to salt occlusion during the dendrite formation. XRD has been performed on several samples at the 25 mV overpotential with 1 wt% U and 0 wt% Ce in the molten salt eutectic. These results indicate that there is not salt occlusion within the dendrites during electrochemical separation. Additionally, the uranium metal quickly oxidizes during preparation for XRD.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2020

Electrochemical Impedance Spectroscopy and Cyclic Voltammetry Methods for Monitoring SmCl 3 Concentration in Molten Eutectic LiCl-KCl

Molten salt solutions consisting of eutectic LiCl-KCl and concentrations of samarium chloride (0.5 to 3.0 wt%) at 500 C were analyzed using both cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The CV technique gave the average diffusion coefficient for Sm 3+ over the concentration range. Equipped with Sm 3+ diffusion coefficient, the Randles-Sevcik equation predicted Sm 3+ concentration values that agree with the given experimental values. From CV measurements; the anodic, cathodic, and half-peak potentials were identified and subsequently used as a parameter to acquire EIS spectra. A six-element Voigt model was used to model the EIS data in terms of resistance-time constant pairs. The lowest resistances were observed at the half-peak potential with the associated resistance-time constant pairs characterizing the reversible reaction between Sm 3+ and Sm 2+ . By extrapolation, the Voigt model estimated the polarization resistance and established a polarization resistance-concentration relationship.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗