Unresolved resonance parameter evaluation and uncertainty quantification of n + 181Ta reactions
Not Available
Engineering topics
Publications and source records attributed to Pigni, Marco T..
Not Available
Abstract not provided.
A new 181 Ta neutron resolved resonance region evaluation has been performed from the thermal energy range up to approximately 2.5 keV. The R-matrix SAMMY code was used with the Reich–Moore approximation to evaluate resonance parameters from several experimental data sets. A Monte Carlo approach was used for resonance spin assignments and generating 59 small fictitious resonance levels which were shown to improve the cumulative level, Porter-Thomas, and Wigner distributions as compared to theoretical predictions. Covariance information was also generated for the entire resolved resonance region. Finally, the positive impact of the new evaluation was validated through benchmark calculations which were sensitive to the 181 Ta cross section and showed improvement in the reactivity bias for several benchmark cases.
Minimal updates to current capabilities (SAMMY/AMPX) and to the ENDF format are proposed to include threshold reaction for outgoing charged-particle channels in the URR formalism. If average resonance parameters are reported, probability tables for newly defined reactions channels may be needed, implemented, and tested. Nuclear data evaluation of n+ 35 Cl reactions can be considered the best case to apply the proposed updates.
This report summarizes the critical experiment design 2 (CED-2) or final design study for Integral Experiment Request 554 (IER-554). This experiment describes the effects and importance of adding a commercially available neutron absorber material to a known light-water low-enriched uranium assembly. The assembly in question is the Seven Percent Critical Experiments (7uPCX) at Sandia National Laboratories. The neutron absorber plates considered for the experiment are known as Boralcan and are made of boron carbide (B 4 C) particles embedded in 1100 aluminum alloy. The concentrations of B 4 C and 1100 aluminum were changed as well as the thickness and the positions of the plates, and the fuel rod configuration was adapted to ensure that the assembly would be critical in each case studied. A total of 6 critical configurations, each with a neutron absorber plate inserted, are described in this report. No results of high-quality integral experiments involving neutron absorbers made with B 4 C and 1100 aluminum plates are currently publicly available. Sensitivity to the neutron absorber plate material definition, isotopes, and cross sections of specific regions and configurations are also analyzed. As part of the final design of the experiment, a safe plate holder made of 3003 aluminum was designed. The study results indicate that these experiments are achievable with sufficiently low uncertainties and minimal modification to the assembly, and the CED-3 phase can start when funding allows.
An evaluation of n+ 88 Sr reactions up to 950 keV was compiled from a publicly available set of resonance parameters. Starting from the repository of the ENDF/B-VIII.0 library, an evaluated nuclear data file was assembled and submitted for inclusion to the Evaluated Nuclear Data File (ENDF)/B-VIII.1 release. This evaluation features an external function representation defined by pole strengths and R ∞ parameters over the entire resolved resonance range. This work improves the modeling of the R-matrix parameterization from multi-Level Breit-Wigner resonance parameters to Reich-Moore formalism, and it also extends thrice the upper energy range of the current ENDF/B-VIII.0 resolved resonance evaluation.
Oak Ridge National Laboratory completed the resolved resonance region (RRR) evaluation of the two most abundant cerium isotopes, 140 Ce (88.45%) and 142 Ce (11.11%), as requested by the US Nuclear Criticality Safety Program. These evaluations are based on recent high-resolution transmission and capture measurements performed on nat Ce and highly enriched 142 Ce samples at the JRC-Geel Linear Accelerator facility, as well as measured thermal constants available from the EXFOR database. Starting from the resonance parameters of the ENDF/B-VIII.0 library followed by a preliminary R-matrix analysis, an updated set of resonance parameters and corresponding covariance information were derived by fitting these measured data using the Reich–Moore approximation of the R -matrix theory, as implemented in the SAMMY code system. The 140 Ce RRR upper energy limit was kept at 200 keV, whereas the 142 Ce resonance region was extended from 13 to 26 keV. Updated statistical properties were obtained for the new evaluations and compared to those derived from the ENDF/B-VIII.0 nuclear data library. The new evaluation work improved some of the discrepancies found in previous work, such as the capture resonance integral and stellar Maxwellian-averaged cross sections. These integral quantities were mainly derived from the fit of the latest measured data, especially the neutron capture yield data for 142 Ce isotope.
This presentation touches on thermal scattering cross section and scattering lengths including criticality benchmarks (fission). Secondly, development and completeness of charged particle libraries: criticality benchmarks (fission), neutron source (fission/fusion), simulation benchmarks and light elements generation (fusion). Additionally, this presentation details on the covariances (methodology and completeness) with adjustment and optimization of nuclear data libraries (fission/fusion). Finally nuclear data reproducibility and conclusions are discussed.
Light-element reactions at low energies in the resolved resonance region are important for a range of applications in basic and applied sciences including nuclear reactors, nonproliferation, cultural heritage, forensics and environmental control, rare event investigations and nuclear astrophysics. In this paper, we report on an effort to evaluate charged-particle cross sections in the resolved resonance region and produce evaluated nuclear data files for further processing and inclusion in evaluated data libraries. We discuss the open issues in R-matrix calculations as we extend to higher energies, such as dealing with the rapidly growing number of open channels and merging with the regime of smooth cross sections described by the statistical model, and present attempts to address these issues in neutron-induced reactions relevant to nuclear reactor applications.
A resolved resonance region evaluation of 140,142 Ce was conducted by Oak Ridge National Laboratory. Requested by the US Nuclear Criticality Safety Program, this evaluation is based on recent high-resolution transmission and capture high-resolution measurements of nat Ce and 142 Ce conducted at JRC-Geel at the Geel Linear Accelerator facility. It is also based on recently measured thermal constants available from the EX FOR database. Starting from the resonance parameters from the ENDF/B-VIII.0 library and following a preliminary R-matrix analysis, an updated set of resonance parameters and corresponding covariance in formation was derived by the fit of these experimental datasets using the Reich–Moore approximation of the R-matrix theory, as implemented in the SAMMY code system. The resolved resonance region upper energy limit for 140 Ce was kept at 200 keV, whereas the 142 Ce resonance region was extended from 13 to 26 keV. This new evaluation was found to be in good agreement not only with several integral quantities of interest to the reactor physics community, but also with the stellar Maxwellian-averaged cross section.
In support of the Nuclear Criticality Safety Program, a set of evaluated resonance parameters was generated for seven dysprosium isotopes in the neutron energy range from thermal up to a few keV. The evaluation methodology used the Reich-Moore approximation to fit, with the R-matrix code SAMMY, the high-resolution capture and transmission measurements on natural and enriched samples recently performed at the Rensselaer Polytechnic Institute Gaerttner LINear ACcelerator facility. Additional transmission data measured on enriched samples by Liou at the Columbia University Nevis synchrocyclotron in the mid-seventies were used to gauge the neutron widths above 15 eV. Thermal constants such as absorption and (in)coherent scattering cross sections and corresponding scattering lengths were calibrated to the National Institute of Standards and Technology’s compilation except for 161,164 Dy isotopes.
This presentation shows current status of in ENDF/B-VIII.0 and ENDF/B-VIII.0β 1 Pu evaluations. With a focus on the Pu thermal solutions (PST) and sanity check on fast metal assemblies (PMF). Pu ENDFβ 1 file in the low-energy region included updates in RRR (up to 2.5 keV), TNC and PFNS. Discussed are improvements over ENDF/B-VIII.0 in the C/E benchmarks (PST 81 cases) with preliminary ν p and cross section covariance generation for the resolved resonance energy range up to 2.25 keV. Highlighted are proposed updates for ENDFβ 2 with an extension of the RRR evaluation up to 5 keV, inclusion of Mosby’s data including proper resolution function (thanks to Marian J.), and a particular focus on η energy dependence from thermal up to 10 eV with the impact of the capture-to-fission ratio at 0.29 eV. This presentation concludes with an updated ν p and cross section covariance generation for the resolved resonance energy range up to 5 keV. And additional validation to test performance at about 2 eV and in the keV region.
This presentation covers fiscal year 2022 for Nuclear Criticality Safety Program (NCSP) accomplishments for Uranium (U) and Plutonium (Pu) evaluations. This presentation includes an overview on plutonium and uranium. Additionally, this presentation covers the inclusion of sub-thermal data for 235 U and the inclusion of LANL ratio capture-to-fission data for 233 U and 235 Pu. The presentation ends with a discussion on 239 Pu Primary fit of Mosby's data as reported and a look at the uncertainty quantification.
The evaluated 35 Cl($\textit{n, p}$) cross sections in the ENDF/B-VIII.0 nuclear data library remain uncertain because of the lack of measured data in the neutron energy range between 100-600 keV. In this energy region, the R-matrix analysis relies heavily on estimated ($\textit{n, p}$) partial widths and level density information. This resulted in significant differences of the evaluated cross sections and predicted reactivity in nuclear reactor applications with respect to previous nuclear data libraries. Here, we present a methodology to quantify the cross sections for the 35 Cl($\textit{n, p}$) reaction channel from the combination of measured total cross sections and model calculations.
The modeling of background sources in large volume detection systems requires accurate nuclear cross sections for a variety of reactions. Among the most important are (α,n) on light nuclei, where α particles, up to ≈9 MeV, are produced from the decay of actinides present in trace amounts in detection and structural material. In order to model the neutron energy spectra and production of other secondary particles, the partial cross sections are needed. Yet very little experimental data exists for these partial cross sections because past measurements, hampered by the experimental challenges of neutron detection, have focused mostly on total reaction cross section measurements. Here, in this paper, the partial cross section of the 13 C(α,n 1 ) 16 O reaction is reported for the first time. The measurements were made near the reaction threshold using a high energy resolution helium spectrometer. The measurements show a rapidly increasing cross section, which quickly becomes a significant fraction of the total reaction cross section. Measurements are compared with previous theory estimates and differences of more than an order of magnitude are found. A comparison is made with new total cross section measurements and the current level of consistency is demonstrated.
This presentation discusses the objective of the research which is to update n+ 63,65 Cu cross section evaluations with recently measured data to resolve discrepancies in benchmark performance. It also discusses the models used which are the R -matrix analysis and the analysis of angular distribution coefficients. Additionally, the validation methods that were used are discussed, including the Rez shielding benchmark and the ICSBEP criticality benchmarks. In conclusion, he n+ 63,65 Cu cross sections have been updated via R-matrix analysis up to 100 keV. An increased average capture cross section and the adoption of experimentally based Legendre coefficients lead to improved performance in reactivity benchmarks. In the fast region, the adoption of the JENDL-4.0 cross sections above 4.0 MeV improves the performance in shielding benchmarks. Ultimately, the n 63,65 Cu ENDF files will be submitted to ENDF/B-VIII.1.
This presentation provides overviews of uraniums, 233 U and 235 U, plutonium research including motivations, current status in ENDF/B-VIII.0, the inclusion of sub-thermal data, and the inclusion of LANL ratio capture-to-fission data. Additionally, the preliminary fit of Mosby’s data as reported, fluctuating neutron multiplicities, uncertainty in evaluated libraries, and experimental effects are also presented. The presentation concludes by providing a summary of plans for the U and Pu evaluation work.
For uranium and plutonium isotopes, evaluation work is converging to a stable configuration with an overall satisfactory benchmark performance (more information on the validation tests after CSEWG). Strontium evaluation was included in the repository library and successfully tested by processing codes relative to an alternative quantification of the external function. Cerium covariance matrices were updated to address review comments on the magnitude of the uncertainty. For future uncertainty quantification, theoretical observables should be properly decoupled from current measured guidelines. Tests to correctly include LP (from resonance parameters) fitted to measured energy-averaged data are in progress. Current ENDF files contains experimental LP data.