Engineering topics
Publications and source records attributed to Platzer, Max F..
The prediction of separation bubbles on NACA 65-213 and NACA 0012 using a modified Chen-Thyson transition model is presented. The contents include: 1) Background; 2) Analysis of NACA 65-213 separation bubble using cebeci's viscous-inviscid interaction method; 3) Analysis of NACA 0012 separation bubble using navier-stokes method; and 4) Comparison with experiment.
A major challenge in the design and development of turbomachine airfoils for gas turbine engines is high cycle fatigue failures due to flutter and aerodynamically induced forced vibrations. In order to predict the aeroelastic response of gas turbine airfoils early in the design phase, accurate unsteady aerodynamic models are required. However, accurate predictions of flutter and forced vibration stress at all operating conditions have remained elusive. The overall objectives of this research program are to develop a transition model suitable for unsteady separated flow and quantify the effects of transition on airfoil steady and unsteady aerodynamics for attached and separated flow using this model. Furthermore, the capability of current state-of-the-art unsteady aerodynamic models to predict the oscillating airfoil response of compressor airfoils over a range of realistic reduced frequencies, Mach numbers, and loading levels will be evaluated through correlation with benchmark data. This comprehensive evaluation will assess the assumptions used in unsteady aerodynamic models. The results of this evaluation can be used to direct improvement of current models and the development of future models. The transition modeling effort will also make strides in improving predictions of steady flow performance of fan and compressor blades at off-design conditions. This report summarizes the progress and results obtained in the first year of this program. These include: installation and verification of the operation of the parallel version of TURBO; the grid generation and initiation of steady flow simulations of the NASA/Pratt&Whitney airfoil at a Mach number of 0.5 and chordal incidence angles of 0 and 10 deg.; and the investigation of the prediction of laminar separation bubbles on a NACA 0012 airfoil.
One concept for high lift aerodynamics is the trapped-vortex. Recently it has been suggested that several spoilers located at different chordwise locations on an airfoil could be deployed to form several cavities in the chordwise direction. This may provide a means of increasing upper surface camber and thereby increase wing lift. It is envisioned that the cavities would be located on an airfoil in its pressure recovery region. Investigations of the effect of one or more cavities on the adjacent boundary layer in an adverse boundary layer were not found in a literature survey. Since flow separation can be caused by flow over cavities, boundary layer measurements were made in the vicinity of cavities which were located in an adverse pressure gradient to study the associated flow in an effort to identify any benefits. The experimental data from the present investigation indicate a minimal impact on the boundary layer profiles is caused by the presence of cavities in either a constant pressure freestream or an adverse pressure gradient. The data from the experimental investigation has been obtained and analyzed. The computational investigation using an incompressible Navier-Stokes code show that reasonable results are being obtained when they are compared with the experimental data.
A Navier-Stokes/potentia/flow interactive solution method suitable for the solution of steady-state and unsteady flowfields around airfoils has been developed. The Navier-Stokes equations are solved in the close proximity of an airfoil and in its wake. The inviscid flowfield surrounding the viscous flow regions is assumed to be irrotational and isentropic. In the inviscid flow region, the potential flow equations, which are based on distributed sources and vortices, are solved. The two solutions are strongly coupled through the application of their boundary conditions. The strongly coupled Navier-Stokes/potential flow interactive solution method confines computations to a small domain in the proximity of an airfoil. For steady flow solutions, the computational domain may be confined to a region which extends less than one-fifth of a chord length distance away from the airfoil surface. Computed solutions have the same accuracy as the full domain NavierStokes solutions. Yet, as a result of the significantly reduced computational domain and increased convergence rates, the Navier-Stokes/potential flow interactive solution method is about 40 percent more efficient computationally.
Euler and Navier-Stokes solutions for airfoil flows on zonal grids are presented. The governing equations are solved with an implicit, iterative, factorized numerical scheme. The inviscid fluxes are examined with a third-order accurate upwind method. Zonal grid solutions are compared with experimental measurements for flows over airfoils at fixed angles of incidence. The computed unsteady solutions for rapidly pitching and oscillating airfoils are in good agreement with experiments.
The vortical flowfield over a double-delta wing configuration, consisting of a sharp leading edge 76 deg sweep strake and a 40 deg sweep wing section is investigated. The governing equations are solved numerically with a partially upwind, finite-difference, factorized algorithm. The leeward side vortex system resulting from the strake and wing vortices is investigated for subsonic, high-Reynolds-number flow at various angles of incidence. At low angles of attack the strake and wing vortices remain separate over the wing section, while for flows at higher angles of attack the two vortices merge and vortex breakdown develops. Vortex breakdown appears initially at the trailing edge region of the wing section. As the angle of attack increases bursting occurs further upstream closer to the strake section. The effect of numerical grid density is investigated, and the solutions are compared with available experimental data.
This paper describes a method for calculating heat transfer on turbine blades subjected to passing wakes. It is based on the numerical solution of the boundary-layer equations for laminar, transitional, and turbulent flows with a novel procedure to account for the movement of the stagnation point. Results are presented for a model flow and show that the procedure is numerically sound and produces results that can give good agreement with measurements provided that the turbulence model is adequate.
The development of a general method for calculating unsteady heat transfer on turbine blades is described. It is based on the numerical solution of the boundary-layer equations for laminar, transitional, and turbulent flows. A novel procedure has been developed to account for the movement of the stagnation point caused by blade-passing wakes and has been applied to the stagnation region of three model flows with results which confirm its validity for laminar flows. It has also been applied to an experimental arrangement in which the average Nusselt number has been reported for turbulent flows and the results show considerable promise.
The effect on a plane subsonic turbulent jet of controlled high-amplitude periodic oscillations applied to the nozzle is investigated experimentally. A variable-speed motor and a gear-cam mechanism are used to make the lips of the nozzle reciprocate in opposite directions at the desired frequency. Velocity profiles, flow visualizations, and pressure-signal traces are presented and analyzed in detail. The complex vortex processes involved in the oscillation-induced spreading and entrainment of the jet are explored, and a critical Strouhal number for vortex formation and amplification is determined. The oscillation technique is found to augment the thrust of a jet/duct-diffuser configuration by a factor of 1.20; the thrust increases with oscillation frequency up to 20 Hz and remains constant if the frequency is further increased.
Recent experiments suggest that the heat-transfer characteristics of stator blades are influenced by the frequency of passing of upstream rotor blades. The calculation of these effects requires that the movement of the stagnation point with variations in freestream velocity is properly represented together with the possible effects of turbulence characteristics on the thin leading-edge boundary layer. A procedure to permit the achievement of these purposes is described for laminar flows in this paper together with results of its application to two model problems which demonstrate its abilities and quantify the influence of wake characteristics on fluid-dynamic and heat-transfer properties of the flow and their effects on surface heat transfer.