Search NASA⌕ Search

Engineering topics

Pless, Lewis C.

Publications and source records attributed to Pless, Lewis C..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Segmented Ion Engine Operation and Performance

The continuing trend toward smaller and smaller planetary spacecraft to enable the use of smaller, less expensive launch vehicles has motivated an examination of new approaches to reduce the size and mass of xenon ion propulsion systems for these new spacecraft. A system is proposed which is based on the use of a single 4x15-cm segmented ion thruster operated from a single internally redundant power processing unit. An engine input power throttling range of 380 to 4640 W is projected. The design and operation over a power range of 600 to 2400 W of a laboratory model segmented ion engine equipped with carbon-carbon grids is presented. There appear to be no problems associated with interactions with multiple ion sources operating from a single set of high voltage power supplies, neutralization of multiple ion sources from a single centrally located neutralizer, or operation of flat, thin carbon-carbon grids.

ion↗
NASA NTRS1992

Ion engine endurance testing at high background pressures

Ion engine endurance testing at vacuum chamber pressures in the low 10 exp -3 Pa range is enabled through the use of a three-grid accelerator system with the decelerator grid biased 50 to 100 volts negative of neutralizer cathode potential. The negative decelerator grid serves to collect the facility induced charge exchange ion current which normally results in rapid erosion of the accelerator grid during testing at elevated vacuum chamber pressures. This screen, accelerator, negative decelerator (SAND) grid configuration enables an order of magnitude reduction in vacuum chamber pumping speeds relative to that required for endurance testing of ion engines with conventional two-grid accelerator systems. A 900-hr test of a 30-cm diameter engine at 6.5 kW and a tank pressure of 3.7 x 10 exp -3 Pa was performed to test the feasibility of the three-grid SAND accelerator system technology. Grid erosion rates from this test are compared to those from a 200-hr test performed with the same discharge chamber, in the same test facility, and at the same background pressure with a conventional two grid accelerator system. The SAND optics resulted in greater than a factor of 100 reduction in accelerator grid erosion rate relative to the two-grid system.

Brophy, John R.↗
NASA NTRS1988

Ion propulsion system design and throttling strategies for planetary missions

This paper describes recent advances in ion propulsion system design which promise to increase the propulsion system reliability by reducing the overall system complexity. The greatest simplification in the overall propulsion system operation is accomplished through a change in the ion engine throttling strategy. By using three grid optics it is possible to effect engine throttling at a constant beam curent over at least a 3.8 to 1 variation in input power. Throttling at a constant beam current results in a single discharge chamber operating point and eliminates the need for active propellant flow controllers and complex engine throttling software. Detailed mission analysis calculations for a CNSR mission performed using this constant beam current throttling strategy indicate only a small reduction in delivered payload and increase in required propellant relative to a conventional throttling profile based on varying the beam curent.

Garner, Charles E.↗
NASA NTRS1987

Hollow cathode plasma source for active spacecraft charge control

A prototype plasma source spacecraft discharge device has been developed to control overall and differential spacecraft surface charging. The plasma source is based on a unique hollow cathode discharge, where the plasma generation process is contained completely within the cathode. This device can be operated on argon, krypton, or xenon and has a rapid cold start time of less than 4 s. The discharge system design includes a spacecraft-discharge/net-charge sensing circuit which provides the ability to measure the polarity, magnitude, pulse shape, and time duration of a discharging event. Ion currents of up to 325 microA and electron currents ranging from 0.02 to 6.0 A have been extracted from the device. In addition, the spacecraft discharge device successfully discharged capacitively biased plates, from as high as + or - 2500 V, to ground potential, and discharged and clamped actively biased plates at +5 V with respect to ground potential during ground simulation testing.

Deininger, William D.↗
NASA NTRS1987

Operating characteristics of a 10 kW xenon ion propulsion module

Performance testing of a two-engine functional model xenon ion propulsion module is described. Use of highly modified J-series 30 cm ion engines reconfigured for xenon propellant, a computer controlled operating system, and precise flow control system are shown to result in very reliable ion module operation at high input power levels. Ion engine operation at a nominal 4.0 ampere beam current and 30.0 volt discharge gives a specific impulse of 3310 sec, a total engine efficiency of 64.3 percent, and a thrust-to-power ratio of 39.5 mN/kW at an input power level of 5.10 kW. These modified J series ion engines are shown to be capable of throttling over an 8:1 range from a power level of 5.48 kW at 3285 sec to a power level of 0.70 kW at 1856 sec. In addition, complete ion engine performance mapping of important system level parameters such as thrust, specific impulse, efficiency and thrust-to-power ratio are presented.

Aston, Graeme↗