Improving the Landing Precision of an MSL-class Vehicle
No abstract available
21.5-m diameter disk / gap / band parachute↗
Engineering topics
Ploen, Scott
Publications and source records attributed to Ploen, Scott.
Reactive Collision Avoidance Algorithm
The reactive collision avoidance (RCA) algorithm allows a spacecraft to find a fuel-optimal trajectory for avoiding an arbitrary number of colliding spacecraft in real time while accounting for acceleration limits. In addition to spacecraft, the technology can be used for vehicles that can accelerate in any direction, such as helicopters and submersibles. In contrast to existing, passive algorithms that simultaneously design trajectories for a cluster of vehicles working to achieve a common goal, RCA is implemented onboard spacecraft only when an imminent collision is detected, and then plans a collision avoidance maneuver for only that host vehicle, thus preventing a collision in an off-nominal situation for which passive algorithms cannot. An example scenario for such a situation might be when a spacecraft in the cluster is approaching another one, but enters safe mode and begins to drift. Functionally, the RCA detects colliding spacecraft, plans an evasion trajectory by solving the Evasion Trajectory Problem (ETP), and then recovers after the collision is avoided. A direct optimization approach was used to develop the algorithm so it can run in real time. In this innovation, a parameterized class of avoidance trajectories is specified, and then the optimal trajectory is found by searching over the parameters. The class of trajectories is selected as bang-off-bang as motivated by optimal control theory. That is, an avoiding spacecraft first applies full acceleration in a constant direction, then coasts, and finally applies full acceleration to stop. The parameter optimization problem can be solved offline and stored as a look-up table of values. Using a look-up table allows the algorithm to run in real time. Given a colliding spacecraft, the properties of the collision geometry serve as indices of the look-up table that gives the optimal trajectory. For multiple colliding spacecraft, the set of trajectories that avoid all spacecraft is rapidly searched on-line. The optimal avoidance trajectory is implemented as a receding-horizon model predictive control law. Therefore, at each time step, the optimal avoidance trajectory is found and the first time step of its acceleration is applied. At the next time step of the control computer, the problem is re-solved and the new first time step is again applied. This continual updating allows the RCA algorithm to adapt to a colliding spacecraft that is making erratic course changes.
Scharf, Daniel↗
Formation-Initialization Algorithm for N Spacecraft
A paper presents an algorithm to initialize a formation of N distributed spacecraft in deep space.
Ploen, Scott↗
Controlling Attitude of a Solar-Sail Spacecraft Using Vanes
A paper discusses a concept for controlling the attitude and thrust vector of a three-axis stabilized Solar Sail spacecraft using only four single degree-of-freedom articulated spar-tip vanes. The vanes, at the corners of the sail, would be turned to commanded angles about the diagonals of the square sail. Commands would be generated by an adaptive controller that would track a given trajectory while rejecting effects of such disturbance torques as those attributable to offsets between the center of pressure on the sail and the center of mass. The controller would include a standard proportional + derivative part, a feedforward part, and a dynamic component that would act like a generalized integrator. The controller would globally track reference signals, and in the presence of such control-actuator constraints as saturation and delay, the controller would utilize strategies to cancel or reduce their effects. The control scheme would be embodied in a robust, nonlinear algorithm that would allocate torques among the vanes, always finding a stable solution arbitrarily close to the global optimum solution of the control effort allocation problem. The solution would include an acceptably small angle, slow limit-cycle oscillation of the vanes, while providing overall thrust vector pointing stability and performance.
Mettler, Edward↗
Attitude Control for a Solar-Sail Spacecraft
A report discusses the attitude-control system of a proposed spacecraft that would derive at least part of its propulsion from a solar sail. The spacecraft would include a bus module containing three or more reaction wheels, a boom attached at one end to the bus module and attached at its other end to a two-degree-of-freedom (DOF) gimbal at the nominal center of mass of a sail module. Each DOF of the gimbal could be independently locked against rotation or allowed to rotate freely. By using the reaction wheels to rotate the bus when at least one gimbal DOF was in the free state, the center of mass (CM) of the spacecraft could be shifted relative to the center of pressure (CP) on the solar sail. The resulting offset between the CM and CP would result in a solar torque, which could be used to change the attitude of the spacecraft. The report discusses numerous aspects of the dynamics and kinematics of the spacecraft, along with the relationships between these aspects and the designs of such attitude-control- system components as sensors, motors, brakes, clutches, and gimbals.
Mettler, Edward↗