Search NASA⌕ Search

Engineering topics

Pondick, Joshua V.

Publications and source records attributed to Pondick, Joshua V..

4 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

A Gapped Phase in Semimetallic T d -WTe 2 Induced by Lithium Intercalation

The Weyl semimetal WTe 2 has shown several correlated electronic behaviors, such as the quantum spin Hall effect, superconductivity, ferroelectricity, and a possible exciton insulator state, all of which can be tuned by various physical and chemical approaches. A new electronic phase in WTe 2 induced by lithium intercalation is discovered. The new phase exhibits an increasing resistivity with decreasing temperature and its carrier density is almost two orders of magnitude lower than the carrier density of the semimetallic T d phase, probed by in situ Hall measurements as a function of lithium intercalation. The theoretical calculations predict the new lithiated phase to be a potential charge density wave (CDW) phase with a bandgap of ≈0.14 eV, in good agreement with the in situ transport data. The new phase is structurally distinct from the initial T d phase, characterized by polarization-angle-dependent Raman spectroscopy, and large lattice distortions close to 6% are predicted in the new phase. This finding of a new gapped phase in a 2D semimetal demonstrates electrochemical intercalation as a powerful tuning knob for modulating electron density and phase stability in 2D materials.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Thickness-dependent phase transition kinetics in lithium-intercalated MoS 2

The phase transitions of two-dimensional (2D) materials are key to the operation of many devices with applications including energy storage and low power electronics. Nanoscale confinement in the form of reduced thickness can modulate the phase transitions of 2D materials both in their thermodynamics and kinetics. Here, using in situ Raman spectroscopy we demonstrate that reducing the thickness of MoS 2 below five layers slows the kinetics of the phase transition from 2H- to 1T'-MoS 2 induced by the electrochemical intercalation of lithium. In this study, we observe that the growth rate of 1T' domains is suppressed in thin MoS 2 supported by SiO 2 , and attribute this growth suppression to increased interfacial effects as the thickness is reduced below 5 nm. In this study, the suppressed kinetics can be reversed by placing MoS 2 on a 2D hexagonal boron nitride ( h BN) support, which readily facilitates the release of strain induced by the phase transition. Additionally, we show that the irreversible conversion of intercalated 1T'-MoS 2 into Li2S and Mo is also thickness-dependent and the stability of 1T'-MoS 2 is significantly increased below five layers, requiring a much higher applied electrochemical potential to break down 1T'-MoS 2 into Li 2 S and Mo nanoclusters.

36 MATERIALS SCIENCE↗
DOE OSTI2020

cm 2 -Scale Synthesis of MoTe 2 Thin Films with Large Grains and Layer Control

Owing to the small energy differences between its polymorphs, MoTe 2 can access a full spectrum of electronic states from the 2H semiconducting state to the 1T' semimetallic state and from the T d Weyl semimetallic state to the superconducting state in the 1T' and T d phase at low temperature. Thus, it is a model system for phase transformation studies as well as quantum phenomena such as the quantum spin Hall effect and topological superconductivity. Careful studies of MoTe 2 and its potential applications require large-area MoTe 2 thin films with high crystallinity and thickness control. Here, we present cm 2 -scale synthesis of 2H-MoTe 2 thin films with layer control and large grains that span several microns. Layer control is achieved by controlling the initial thickness of the precursor MoO x thin films, which are deposited on sapphire substrates by atomic layer deposition and subsequently tellurized. Despite the van der Waals epitaxy, the precursor–substrate interface is found to critically determine the uniformity in thickness and grain size of the resulting MoTe 2 films: MoTe 2 grown on sapphire show uniform films while MoTe 2 grown on amorphous SiO 2 substrates form islands. Furthermore, this synthesis strategy decouples the layer control from the variabilities of growth conditions for robust growth results and is applicable to growing other transition-metal dichalcogenides with layer control.

2D materials↗