Engineering topics

Posen, Sam [Fermilab]

Publications and source records attributed to Posen, Sam [Fermilab].

6 records

DOE OSTI2026

Cryogenic RF characterization of the MAGO cavity for high-frequency gravitational-wave detection

Superconducting radio-frequency (SRF) cavities are promising resonant sensors for gravitational-wave detection in the kHz-MHz frequency range. We report the cryogenic RF characterization of a prototype superconducting niobium cavity with an unconventional geometry designed for narrow electromagnetic mode separation. Following an adapted surface preparation procedure, cryogenic tests were performed at Fermilab and DESY at temperatures down to 2 K. Mechanical tuning at room temperature achieved a mode splitting of approximately 11 kHz at cryogenic temperature. High electromagnetic quality factors consistent with previous prototype cavities were measured. The measurements further revealed phase transfer characteristics relevant for stable low-level RF control as well as indications of mode coupling potentially caused by one-point multipacting. In addition, first cryogenic measurements of the mechanical eigenmodes yielded mechanical quality factors significantly below commonly assumed theoretical values. These results demonstrate the successful application of established SRF preparation and characterization techniques to a non-standard resonator geometry and provide important experimental input for the development of future SRF-based gravitational-wave detectors.

Dokuyucu, Can [DESY]↗

DOE OSTI2026

Microstructural Characterization of Nb$_3$Sn Thin Films Using FIB Tomography

The accelerating gradient of N b3Sn superconducting radiofrequency (SRF) cavities is currently limited, and the underlying cause remains an open question in the field. One leading hypothesis attributes this limitation to the presence of tin-deficient regions within the N b3Sn coating, which can suppress the superheating field. Due to the relatively large coherence length of N b3Sn, defects near the surface may significantly interact with the RF field. However, these subsurface defects have proven difficult to characterize. This research aims to investigate the structure and distribution of subsurface Sn deficient regions to better understand their influence on cavity performance. We employ focused ion beam (FIB) tomography to analyze the subsurface microstructure of N b3Sn thin films. This technique enables threedimensional reconstruction of both the tin distribution and the grain structure within the film. By correlating Sn content with grain structure, we find that Sn deficient regions are more prevalent that previously thought. However, the Sn deficient regions are consistently located below the surface of the film where RF fields are strongly attenuated by supercurrent screening and are likely not a limiting factor for cavity performance

Viklund, Eric [Fermilab]↗

DOE OSTI2026

Analysis of vapor diffusion Nb$^{3}$Sn coating at Fermilab: Minimizing impurities using TOF-SIMS

Nb₃Sn demonstrates steady advancements nowadays offering reduced power cost in superconducting radio-frequency cavities due to its high critical temperature, quality factor, and achieved accelerating gradient. However, theoretical estimates of its radio-frequency parameters have not been achieved due to several potentially limiting mechanisms: tin spots, patchy regions, defects, thermal impedance, and impurities. While some of these limitations have been intensively studied, impurity analysis in Nb$_3$Sn coatings have received less attention. We report an investigation of impurities in several vapor-diffused Nb₃Sn coated samples using time-of-flight secondary ion mass spectroscopy (TOF-SIMS) and show allowable impurity levels in view of superconducting cavity performance. Challenges and lessons learned in maintaining clean Nb$_3$Sn coatings are also discussed.

Tagdulang, Nikki [Fermilab]↗

DOE OSTI2025

A Dark Photon Dark Matter Search with a Widely-Tunable SRF Cavity

The SERAPH (SupERconducting Axion and Paraphoton Haloscope) experiment is a family of superconducting haloscopes being developed by the Superconducting Quantum Materials and Systems (SQMS) Center to search for wavelike dark matter. This presentation will focus on preliminary results from our dark photon dark matter search using a widely-tunable SRF cavity operating between 4-7 GHz, nicknamed the “plunger cavity.” I will present the cavity design and characterization, analyze the impact of microphonics on system performance and haloscope sensitivity, and describe our tuning methodology for this Q~10^8 cavity. The presentation will cover our haloscope analysis approach and discuss sensitivity limits achieved within this frequency range. Finally, I will outline lessons learned from this first search, implications for future axion searches, and proposed improvements for subsequent SERAPH experiments.

Cervantes, Raphael [Fermilab]↗

DOE OSTI2025

A Dark Photon Dark Matter Search with a Widely-Tunable SRF Cavity

The SERAPH (SupERconducting Axion and Paraphoton Haloscope) experiment is a family of superconducting haloscopes being developed by the Superconducting Quantum Materials and Systems (SQMS) Center to search for wavelike dark matter. This presentation will focus on preliminary results from our dark photon dark matter search using a widely-tunable SRF cavity operating between 4-7 GHz, nicknamed the "plunger cavity." I will present the cavity design and characterization, analyze the impact of microphonics on system performance and haloscope sensitivity, and describe our tuning methodology for this Q~10^8 cavity. The presentation will cover our haloscope analysis approach and discuss sensitivity limits achieved in this frequency range. Finally, I will outline lessons learned from this first search, implications for future axion searches, and proposed improvements for subsequent SERAPH experiments.

Cervantes, Raphael [Fermilab]↗

DOE OSTI2025

Development of the first 1 GHz niobium-tin quarter-wave cavity

Niobium-Tin (Nb3Sn) is a promising alternative to pure niobium for low-beta ion accelerators due to low RF losses even at high frequencies. At 4.5 K, the expected Bardeen-Cooper-Schrieffer resistance of Nb3Sn is a few nano-Ohms at 1 GHz, with two orders of magnitude improvement compared to pure niobium. The low Nb3Sn RF losses allow the use of higher frequency, much smaller cavities while maintaining 4.5 K operation that is compatible with cryocoolers. This work aims to demonstrate the feasibility of coating a high-frequency 1 GHz, compact quarter-wave cavity. The development of this cavity has the potential to transform low-beta ion accelerators through size reductions and by enabling the replacement of large helium cryoplants with small plug-in cryocoolers. We have designed, built, and tested a 1GHz Nb3Sn coated quarter-wave cavity. Nb3Sn coating has been performed once by vapor diffusion at Fermilab. Cryogenic cold tests show a quality factor of ~1E9 at low accelerating electric fields or ~7 times higher than the theoretical limit for pure niobium at 1GHz. This first coating does not yet meet our quality factor or gradient goals; however, we plan to continue to develop this cavity.

Zhou, Yang [Argonne]↗