Search NASA⌕ Search

Engineering topics

Power, J

Publications and source records attributed to Power, J.

Photocathode emission studies: Dark current and Schottky-enabled photo-electrons in a high-field RF gun

We report on dark current and Schottky-enabled photoemission from a copper photocathode surface. Field-emitted dark current is a major gradient-limiting factor in RF cavities. Field emission is generally attributed to geometrical projections on the bulk surface whose field enhancement factor ({beta}) and the emitting area (A{sub e}) can be extracted from the Fowler-Nordheim (FN) plot. Measurements were made at Tsinghua S-band RF gun facility in two separate experiments. Using the traditional FN formula for RF fields we discovered that field enhancement factor ({beta}) alone cannot explain the full data set. Instead, we found that a low work function at some sites is required. In addition, surface analysis of the cathode after the experiment shows that geometric {beta} indicated would be < 10. Thus we conclude that low work function sites with a small {beta} are responsible for dark current emission and subsequent breakdown in high-gradient structures. The origin of these sites is unclear but could be due to defects or impurities.

43 PARTICLE ACCELERATORS↗

Start-to-end beam dynamics simulation of double triangular current profile generation in Argonne Wakefield Accelerator

Double triangular current profile (DT) gives a high transformer ratio which is the determining factor of the performance of collinear wakefield accelerator. This current profile can be generated using the emittance exchange (EEX) beam line. Argonne Wakefield Accelerator (AWA) facility plans to generate DT using the EEX beam line. We conducted start-to-end simulation for the AWA beam line using PARMELA code. Also, we discuss requirements of beam parameters for the generation of DT.

43 PARTICLE ACCELERATORS↗

Dielectric Wakefield Accelerator to drive the future FEL Light Source.

X-ray free-electron lasers (FELs) are expensive instruments and a large part of the cost of the entire facility is driven by the accelerator. Using a high-energy gain dielectric wake-field accelerator (DWA) instead of the conventional accelerator may provide a significant cost saving and reduction of the facility size. In this article, we investigate using a collinear dielectric wakefield accelerator to provide a high repetition rate, high current, high energy beam to drive a future FEL x-ray light source. As an initial case study, a {approx}100 MV/m loaded gradient, 850 GHz quartz dielectric based 2-stage, wakefield accelerator is proposed to generate a main electron beam of 8 GeV, 50 pC/bunch, {approx}1.2 kA of peak current, 10 x 10 kHz (10 beamlines) in just 100 meters with the fill factor and beam loading considered. This scheme provides 10 parallel main beams with one 100 kHz drive beam. A drive-to-main beam efficiency {approx}38.5% can be achieved with an advanced transformer ratio enhancement technique. rf power dissipation in the structure is only 5 W/cm{sup 2} in the high repetition rate, high gradient operation mode, which is in the range of advanced water cooling capability. Details of study presented in the article include the overall layout, the transform ratio enhancement scheme used to increase the drive to main beam efficiency, main wakefield linac design, cooling of the structure, etc.

36 MATERIALS SCIENCE↗

Two Channel Dielectric-Lined Rectangular High Transformer Ratio Accelerator Structure Experiment

Current status of a two-channel cm-scale rectangular dielectric lined wakefield accelerator structure is described. This structure is installed at the Argonne Wakefield Accelerator facility (AWA), and is presently being evaluated. The device has a transformer ratio of {approx}12.5:1. When driven by a {approx}50 nC single drive bunch it is expected to obtain {approx}6 MV/m acceleration gradient. Related issues are discussed.

43 PARTICLE ACCELERATORS↗

Design of an electro-optical sampling experiment at the AWA facility.

The free space electro-optical (EO) sampling technique is a powerful tool for analyzing the longitudinal charge density of an ultrashort e-beam. In this paper, we present (i) experimental results for a laser-based mock-up of the EO experiment [1] and (ii) a design for a beam-based, single-shot, EO sampling experiment using the e-beam from the Argonne Wakefield Accelerator (AWA) RE photoinjector. For the mock-up, a tabletop terahertz experiment is conducted in the AWA laser room. The mock-up uses an IR beam incident on <110> ZnTe crystal to produce a THz pulse via optical rectification. Detection is based on the cross correlation between the THz field and the probe IR laser field in a second <110> ZnTe crystal.

43 PARTICLE ACCELERATORS↗