Search NASA⌕ Search

Engineering topics

Prakash, Abhinav

Publications and source records attributed to Prakash, Abhinav.

8 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Optical and microstructural studies of erbium-doped TiO 2 thin films on silicon, SrTiO 3 , and sapphire

Rare-earth ion doped oxide thin films integrated on silicon substrates provide a route toward scalable, chip-scale platforms for quantum coherent devices. Erbium-doped TiO 2 is an attractive candidate: the Er 3+ optical transition is compatible with C-band optical fiber communications, while TiO 2 is an insulating dielectric compatible with silicon process technology. Through structural and optical studies of Er-doped TiO 2 thin films grown via molecular beam deposition on silicon, SrTiO 3 , and sapphire substrates, we have explored the impact of polycrystallinity and microstructure on the optical properties of the Er emission. Comparing polycrystalline TiO 2 (rutile)/Si with single-crystalline TiO 2 (rutile)/r-sapphire and polycrystalline TiO 2 (anatase)/Si with single-crystalline TiO 2 (anatase)/SrTiO 3 , we observe that the inhomogeneous linewidth (Γ inh ) of the most prominent peak in the Er spectrum (the Y 1 –Z 1 transition, 1520 and 1533 nm in rutile and anatase TiO 2 ) is significantly narrower in the polycrystalline case. This implies a relative insensitivity to extended structural defects and grain boundaries in such films (as opposed to, e.g., point defects). We show that the growth of an undoped, underlying TiO 2 buffer on Si can reduce Γ inh by a factor of 4–5. Expectedly, Γ inh also reduces with decreasing Er concentrations: we observe a ∼2 order of magnitude reduction from ∼1000 ppm Er to ∼10 ppm Er. Γ inh then gets limited to a residual value of ∼5 GHz that is insensitive to further reduction in the Er concentration. Based upon the above results, we argue that the optical properties in these thin films are limited by the presence of high “grown-in” point defect concentrations.

Chemical elements↗
DOE OSTI2021

Metallic line defect in wide-bandgap transparent perovskite BaSnO 3

A line defect with metallic characteristics has been found in optically transparent BaSnO 3 perovskite thin films. The distinct atomic structure of the defect core, composed of Sn and O atoms, was visualized by atomic-resolution scanning transmission electron microscopy (STEM). When doped with La, dopants that replace Ba atoms preferentially segregate to specific crystallographic sites adjacent to the line defect. The electronic structure of the line defect probed in STEM with electron energy-loss spectroscopy was supported by ab initio theory, which indicates the presence of Fermi level–crossing electronic bands that originate from defect core atoms. These metallic line defects also act as electron sinks attracting additional negative charges in these wide-bandgap BaSnO 3 films.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Self-Assembled Periodic Nanostructures Using Martensitic Phase Transformations

We describe a novel approach for the rational design and synthesis of self-assembled periodic nanostructures using martensitic phase transformations. We demonstrate this approach in a thin film of perovskite SrSnO 3 with reconfigurable periodic nanostructures consisting of regularly spaced regions of sharply contrasted dielectric properties. The films can be designed to have different periodicities and relative phase fractions via chemical doping or strain engineering. The dielectric contrast within a single film can be tuned using temperature and laser wavelength, effectively creating a variable photonic crystal. Our results show the realistic possibility of designing large-area self-assembled periodic structures using martensitic phase transformations with the potential of implementing "built-to-order" nanostructures for tailored optoelectronic functionalities.

77 NANOSCIENCE AND NANOTECHNOLOGY↗
DOE OSTI2020

Electronic structure and small-hole polarons in YTiO 3

As a prototypical Mott insulator with ferromagnetic ordering, YTiO 3 (YTO) is of great interest in the study of strong electron correlation effects and orbital ordering. Here we report the first molecular beam epitaxy (MBE) growth of YTO films, combined with theoretical and experimental characterizations of the electronic structure and charge transport properties. The obstacles of YTO MBE growth are discussed and potential routes to overcome them are proposed. DC transport and Seebeck measurements on thin films and bulk single crystals identify p-type Arrhenius transport behavior with an activation energy of ~0.17 eV in thin films, consistent with the energy barrier for small hole polaron migration from hybrid density functional theory calculations. Hard x-ray photoelectron spectroscopy measurements show the lower Hubbard band at 1.1 eV below the Fermi level, whereas a Mott-Hubbard band gap of ~1.5 eV is determined from photoluminescence measurements. These findings provide critical insight into the electronic band structure of YTO and related materials.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Precursor selection in hybrid molecular beam epitaxy of alkaline-earth stannates

One of the challenges of oxide molecular beam epitaxy (MBE) is the synthesis of oxides containing metals with high electronegativity (metals that are hard to oxidize). The use of reactive organometallic precursors can potentially address this issue. To investigate the formation of radicals in MBE, we explored three carefully chosen metal-organic precursors of tin for SnO 2 and BaSnO 3 growth: tetramethyltin (TMT), tetraethyltin (TET), and hexamethylditin (HMDT). All three precursors produced single-crystalline, atomically smooth, and epitaxial SnO 2 (101) films on r-Al 2 O 3 (101¯2) in the presence of oxygen plasma. The study of growth kinetics revealed reaction-limited and flux-limited regimes except for TET, which also exhibited a decrease in the deposition rate with increasing temperature above ~800 °C. Contrary to these similarities, the performance of these precursors was dramatically different for BaSnO 3 growth. TMT and TET were ineffective in supplying adequate tin, whereas HMDT yielded phase-pure, stoichiometric BaSnO 3 films. Significantly, HMDT resulted in phase-pure and stoichiometric BaSnO 3 films even without the use of an oxygen plasma (i.e., with molecular oxygen alone). Furthermore, these results are discussed using the ability of HMDT to form tin radicals and therefore assisting with Sn → Sn 4+ oxidation reaction. Structural and electronic transport properties of films grown using HMDT with and without oxygen plasma are compared. This study provides guideline for the choice of precursors that will enable the synthesis of metal oxides containing hard-to-oxidize metals using reactive radicals in MBE.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Machine learning analysis of perovskite oxides grown by molecular beam epitaxy

Reflection high-energy electron diffraction (RHEED) is a ubiquitous in situ molecular beam epitaxial (MBE) characterization tool. Although RHEED can be a powerful means for crystal surface structure determination, it is often used as a static qualitative surface characterization method at discrete intervals during a growth. A full analysis of RHEED data collected during the entirety of MBE growths is made possible using principle component analysis (PCA) and $\textit{k}$-means clustering to examine significant boundaries that occur in the temporal clusters grouped from RHEED data and identify statistically significant patterns. This process is applied to data from homoepitaxial SrTiO 3 growths, heteroepitaxial SrTiO 3 grown on scandate substrates, BaSnO 3 films grown on SrTiO 3 substrates, and LaNiO 3 films grown on SrTiO 3 substrates. We report this analysis may provide additional insights into the surface evolution and transitions in growth modes at precise times and depths during growth, and that video archival of an entire RHEED image sequence may be able to provide more insight and control overgrowth processes and film quality.

36 MATERIALS SCIENCE↗