Search NASA⌕ Search

Engineering topics

Prasad, J. V. R.

Publications and source records attributed to Prasad, J. V. R..

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2019

Extraction of Dynamic Inflow Models for Coaxial and Tandem Rotors from CFD Simulations

The dynamic inflow coupling with rotor/body dynamics is crucial in the analysis of stability and control law design for helicopters. Over the past several decades, finite-state inflow models for single rotor configurations in hover, forward flight, and maneuver have developed (Ref.1-3). By capturing the interference effects between rotors, the extension of pressure potential finite state inflow model has promising result for coaxial rotor configuration (Ref.4-6). Recently, the focus of the dynamic inflow modeling has shifted to tandem rotor configurations (Ref.7, 8). The development of the dynamic inflow models for tandem rotor configuration still have some limitations due to the lack of knowledge of rotor-to-rotor interference, and rotor-wake interference. Experimental methods, and computational fluid dynamics methods are commonly used to understand the rotor performance and rotor airload variations, and measure or predict inflow velocity distributions at the rotor desk. The inflow distributions are subsequently used to improve the dynamic inflow models. Tandem rotor configurations have been studied experimentally and computationally for several decades (Ref.9-12). Sweet (Ref.10) observed that a tandem rotor with 76-percent-radius overlap required 14% more induced power at hovering condition, relative to an isolated rotor of equivalent disk area. Sweet also found that, above a shaft-to-shaft distance of 1.03 diameter, the performance of the tandem rotor was nearly the same as two isolated rotors. The objective of the present study is to apply computational fluid dynamics simulations of tandem rotors for the extraction of dynamic inflow models. The extended methodology is first validated by comparing the computed induced power against test data. Subsequently inflow distributions and wake structures are analyzed.

Extraction of Dynamic Inflow Models↗
NASA NTRS2009

Methodologies for Adaptive Flight Envelope Estimation and Protection

This paper reports the latest development of several techniques for adaptive flight envelope estimation and protection system for aircraft under damage upset conditions. Through the integration of advanced fault detection algorithms, real-time system identification of the damage/faulted aircraft and flight envelop estimation, real-time decision support can be executed autonomously for improving damage tolerance and flight recoverability. Particularly, a bank of adaptive nonlinear fault detection and isolation estimators were developed for flight control actuator faults; a real-time system identification method was developed for assessing the dynamics and performance limitation of impaired aircraft; online learning neural networks were used to approximate selected aircraft dynamics which were then inverted to estimate command margins. As off-line training of network weights is not required, the method has the advantage of adapting to varying flight conditions and different vehicle configurations. The key benefit of the envelope estimation and protection system is that it allows the aircraft to fly close to its limit boundary by constantly updating the controller command limits during flight. The developed techniques were demonstrated on NASA s Generic Transport Model (GTM) simulation environments with simulated actuator faults. Simulation results and remarks on future work are presented.

Tang, Liang↗
NASA NTRS1992

Adequacy of modeling turbulence and related effects on helicopter response

'Blade-fixed' atmospheric turbulence encountered by a helicopter substantially differs from body-fixed (i.e., fuselage) turbulence, because the rotational velocity moves the blade station fore and aft through the turbulence. The present closed-form solution of a frequency-time spectrum for the dominant vertical turbulence velocity at arbitrary blade station defines in what way and in what degree the rotational velocity affects rotor-disk turbulence frequency and temporal characteristics. Blade-flapping response to blade- and body-fixed turbulence is also presented over a range of turbulence-scale length and advance ratio.

George, V. V.↗
NASA NTRS1992

Some issues on modeling atmospheric turbulence experienced by helicopter rotor blades

The atmospheric turbulence velocities seen by nonrotating aircraft components and rotating blades can be substantially different. The differences are due to the spatial motion of the rotor blades, which move fore and aft through the gust waves. Body-fixed atmospheric turbulence refers to the actual atmospheric turbulence experienced by a point fixed on a nonrotating aircraft component such as the aircraft's center of gravity or the rotor hub, while blade-fixed atmospheric turbulence refers to the atmospheric turbulence experienced by an element of the rotating rotor blade. An example is presented, which, though overly simplified, shows important differences between blade- and body-fixed rotorcraft atmospheric turbulence models. All of the information necessary to develop the dynamic equations describing the atmospheric turbulence velocity field experienced by an aircraft is contained in the atmospheric turbulence velocity correlation matrix. It is for this reason that a generalized formulation of the correlation matrix describing atmospheric turbulence that a rotating blade encounters is developed. From this correlation matrix, earlier treated cases restricted to a rotor flying straight and level directly into the mean wind can be recovered as special cases.

Costello, Mark↗
NASA NTRS1992

Methodology development for evaluation of selective-fidelity rotorcraft simulation

This paper addressed the initial step toward the goal of establishing performance and handling qualities acceptance criteria for realtime rotorcraft simulators through a planned research effort to quantify the system capabilities of 'selective fidelity' simulators. Within this framework the simulator is then classified based on the required task. The simulator is evaluated by separating the various subsystems (visual, motion, etc.) and applying corresponding fidelity constants based on the specific task. This methodology not only provides an assessment technique, but also provides a technique to determine the required levels of subsystem fidelity for a specific task.

Lewis, William D.↗
NASA NTRS1992

Helicopter response to atmospheric turbulence

A new time-domain method for simulating cyclostationary turbulence as seen by a translating and rotating blade element has recently been developed for the case of one-dimensional spectral distribution. This paper extends the simulation method to the cases of two- and three-dimensional spectral distributions and presents validation results for the two-dimensional case. The statistics of an isolated rigid blade flapping response to turbulence are computed using a two-dimensional spectral representation of the von Karman turbulence model, and the results are compared with those obtained using the conventional space-fixed turbulence analysis. The new turbulence simulation method is used for predicting the Black Hawk helicopter response to atmospheric turbulence.

Riaz, J.↗
NASA NTRS1991

A new method for simulating atmospheric turbulence for rotorcraft applications

Simulation of atmospheric turbulence as seen by a rotating blade element involves treatment of cyclostationary processes. Conventional filtering techniques do not lend themselves well to the generation of such turbulence sample functions as are required in rotorcraft flight dynamics simulation codes. A method to generate sample functions containing second-order statistics of mean and covariance is presented. Compared to ensemble averaging involving excessive computer time, the novelty is to exploit cycloergodicity and thereby, replace ensemble averaging by averaging over a single-path sample function of long duration. The method is validated by comparing its covariance results with the analytical and ensemble-averaged results for a widely used one-dimensional turbulence approximation.

Prasad, J. V. R.↗
NASA NTRS1991

On the adequacy of modeling turbulence and related effects on helicopter response

The present closed-form solution of a frequency-time spectrum for the dominant vertical turbulence velocity at an arbitrary blade station accounts for the instantaneous turbulence-energy transfer due to rotational velocity from the low-frequency to the high-frequency region, with the occurrence of several spectral peaks and split peaks. Comparisons of blade-flapping response to blade- and body-fixed turbulence is also presented, over a range of turbulence-scale length and advance ratios. Attention is given to the use of cyclostationary turbulence and blade-response frequency-time spectra to simultaneously predict temporal and frequency characteristics. Rotational velocity substantially affects response statistics in low-altitude, low advance-ratio flight.

George, V. V.↗
NASA NTRS1989

Two-time scale stabilization of a flexible arm with output feedback

An approach is presented to designing a control system with output feedback for a lightweight flexible arm. A two-time-scale dynamic model is obtained which allows the adoption of a composite control strategy. First a slow control can be designed for the slow (rigid) subsystem, and then a fast stabilizing control for the fast (flexible) subsystem. The problem of the lack of full state measurements connected with the fast control design is solved. An output-feedback, low-order dynamic compensator whose optimal gains are computed by a convergent numerical algorithm is designed. A more robust design can be achieved if a loop transfer recovery procedure is introduced. The design procedure is tested by means of nonlinear simulation, and the results are discussed.

Siciliano, Bruno↗
NASA NTRS1988

Helicopter stability and control modeling improvements and verification on two helicopters

A linearized model of helicopter flight dynamics is developed which includes the flapping, lead-lag, and dynamic inflow degrees of freedom (DOF). The model is a combination of analytical terms and numerically determined stability derivatives, and is used to investigate the importance of the rotor DOF to stability and control modeling. The results show that the rotor DOF can have a significant impact on some of the natural modes in a linear model. The flap and dynamic inflow DOF show the greatest influence. Flapping exhibits strong coupling to the body, dynamic inflow, and to lead-lag to a lesser extent. Dynamic inflow tends to damp the high-frequency flapping modes, and reduces the damping on coupled body-flap motion. Dynamic inflow also couples to the flapping motion to produce complex roots. With body-flap and lag regressing modes as exceptions, the results show essentially similar behavior for most modes of articulated and hingeless rotor helicopters.

Schrage, D. P.↗
NASA NTRS1988

An approximate loop transfer recovery method for designing fixed-order compensators

A method for designing fixed-order dynamic compensators for multivariable time invariant linear systems is presented which is based on the minimization of a linear quadratic performance index. The present formulation is performed in an output feedback setting which uses an observer cononical form to represent the compensator dynamics. Techniques for penalizing the plant and compensator states and for selecting the distribution on initial conditions such that the loop transfer matrix approximates that of a full-state feedback design have been developed. The effectiveness of the method is demonstrated using the examples of the pointing of a flexible structure and a helicopter flight control problem.

Calise, Anthony J.↗