Engineering topics

Pratt, Stephen F.

Publications and source records attributed to Pratt, Stephen F..

7 records

NASA NTRS1993

The effects of atmospheric pressure on infrared reflectance spectra of Martian analogs

The use of terrestrial samples as analogs of Mars soils are complicated by the Martian atmosphere. Spectral features due to the Martian atmosphere can be removed from telescopic spectra of Mars and ISM spectra of Mars, but this does not account for any spectral differences resulting from atmospheric pressure or any interactions between the atmosphere and the surface. We are examining the effects of atmospheric pressure on reflectance spectra of powdered samples in the laboratory. Contrary to a previous experiment with granite, no significant changes in albedo or the Christiansen feature were observed from 1 bar pressure down to a pressure of 8 micrometers Hg. However, reducing the atmospheric pressure does have a pronounced affect on the hydration features, even for samples retained in a dry environment for years.

Bishop, Janice L.↗

NASA NTRS1991

Spectral signature of oxidized pyroxenes - Implications to remote sensing of terrestrial planets

The effect of the structural Fe(3+) or disseminated ferric oxides in oxidized ferromagnesian silicates on the reflectance spectral profiles of the remnant Fe(2+) ions in oxidized silicates was investigated. Results of spectral measurements in the visible NIR region, performed on several well-characterized pyroxenes representative of different structural types and compositions, were correlated with data obtained from the Mossbauer spectra of the oxidation products. The measurements made it possible to determine the relative proportions of Fe(2+) and Fe(3+) ions present in the oxidized pyroxenes and provided information on the amorphous ferric oxide phases present in the oxidation products. The results also suggest a mechanism for producing the nanophase hematite popularly considered to be responsible for the features observed around 0.62 and 0.87 micron in the remotely sensed spectra of Mars.

Straub, D'arcy W.↗

NASA NTRS1991

The perplexing continuum slope of Mars: Effects of thin ferric coatings and viewing geometry

The experiment discussed here was designed to constrain interpretations of variations in continuum slope variations which define several spectral annuli on the flanks of Olympus Mons, observed in the Imaging Spectrometer (IMS) data. The IMS Olympus Mons data reveal that the rings, seen as alternating brighter and darker reflectance in Viking data, correspond to annuli of alternating shallower and steeper continuum slope. At least three factors contributing to continuum slope are identified: ferric coating thickness, viewing geometry, and surface texture. Because the Olympus Mons spectral annuli were observed at nearly constant backscatter geometries in the ISM data, with only slight viewing variations due to the volcanoe's flank slopes, the difference of continuum slope between annuli probably cannot be explained by viewing geometry alone. This suggests that the variation of some fundamental surface characteristics, such as ferric dust/rind thickness or surface texture, is the cause of the Olympus Mons special annuli observed in the ISM imaging spectrometer data.

Fischer, Erich M.↗

NASA NTRS1991

Reflectance spectra of Fe(2+)-Mg(2+) disordered pyroxenes: Implications to remote-sensed spectra of planetary surfaces

The reflectance spectra of Fe(2+)-Mg(2+) disordered orthopyroxenes are relevant to surfaces of terrestrial planets onto which basaltic magma has been extruded. If cooling rates of basalt lava flows were fast, equilibrium iron intersite partitioning may not have been achieved so that abnormal enrichments of Fe(2+) ions in M1 sites would occur. The two intense pyroxene Fe(2+) site CF bands in the 1 micron and 2 micron regions would continue to dominate the the reflectance spectra so that the pyroxene composition and structure type would be readily identified in telescopic spectral profiles. However, abnormal intensification of the Fe(2+)/M1 site CF band at 1.20 microns could lead to the false identification of olivine in remote sensed spectra because in pyroxene-olivine mixtures the inflection around 1.20 microns is the only spectral feature for detecting the presence of olivine. The identification of iron-bearing plagioclase feldspars, too, would be obscured by the pyroxene Fe(2+)/M1 site CF band at 1.20 microns. Such interference would be a major problem if in situ reflectance spectra could be measured on the surface of Venus where ambient temperatures are as high as 475 C. Disordering of Fe(2+) and Mg(2+) ions comparable to that in the orthopyroxenes used in this spectral chemical study might be expected in low Ca pyroxenes occurring on the Venusian surface. Researchers conclude that Fe(2+)/M1 site spectral features need to be carefully assessed in remote-sensed spectra before deductions are made about the presence of olivine on planetary surfaces.

Burns, Roger G.↗

NASA NTRS1991

Color heterogeneity of the surface of Phobos - Relationships to geologic features and comparison to meteorite analogs

Color ratio images created from multispectral observations of Phobos are analyzed in order to characterize the spectral properties of Phobos' surface, to assess their spatial distributions and relationships with geologic features, and to compare Phobos' surface materials with possible meteorite analogs. Data calibration and processing is briefly discussed, and the observed spectral properties of Phobos and their lateral variations are examined. Attention is then given to the color properties of different types of impact craters, the origin of lateral variations in surface color, the relation between the spatial distribution of color properties and independently identifiable geologic features, and the relevance of color variation spatial distribution to the origin of the grooves.

Murchie, Scott L.↗

NASA NTRS1990

Deconvolution of mineral absorption bands - An improved approach

Although visible and near IR reflectance spectra contain absorption bands that are characteristic of the composition and structure of the absorbing species, deconvolving a complex spectrum is nontrivial. An improved approach to spectral deconvolution is presented that accurately represents absorption bands as discrete mathematical distributions and resolves composite absorption features into individual absorption bands. The frequently used Gaussian model of absorption bands is shown to be inappropriate for the Fe(2+) electronic transition absorptions in pyroxene spectra. A modified Gaussian model is derived using a power law relationship of energy to average bond length. The modified Gaussian model is shown to provide an objective and consistent tool for deconvolving individual absorption bands in the more complex orthopyroxene, clinopyroxene, pyroxene mixtures, and olivine spectra.

Sunshine, Jessica M.↗

NASA NTRS1987

Deconvolution of spectra for intimate mixtures

Visible to near infrared reflectance spectra of macroscopic mixtures have been shown to be linear combinations of the reflections of the pure mineral components in the mixture. However, for microscopic mixtures the mixing systematics are in general nonlinear. The systematics may be linearized by conversion of reflectance to single scattering albedo (w), where the equations which relate reflectance to w depend on the method of data collection. Several proposed mixing models may be used to estimate mineral abundances from the reflectance spectra of intimate mixtures. These models are summarized and a revised model is presented. A noniterative (linear) least squares approach was used for curve fitting and the data, measured as bi-directional reflectance with incidence and emergence angles of 30 and 0 deg were converted to w by a simplified version of Hapke's equation for bi-directional reflectance. This model was tested with two mixture series composed of 45 to 75 micron particles: an anorthite-enstatite series and an olivine-magnetite series. The data indicate that the simplified Hapke's equation may be used to convolve reflectance spectra into mineral abundances if appropriate endmembers are known or derived from other techniques. For surfaces that contain a significant component of very low albedo material, a somewhat modified version of this technique will need to be developed. Since the abundances are calculated using a noniterative approach, the application of this method is especially efficient for large spectral data sets, such as those produced by mapping spectrometers.

Mustard, John F.↗