Search NASA⌕ Search

Engineering topics

Pruett, C. D.

Publications and source records attributed to Pruett, C. D..

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2004

Temporal Large-Eddy Simulation

In 1999, Stolz and Adams unveiled a subgrid-scale model for LES based upon approximately inverting (defiltering) the spatial grid-filter operator and termed .the approximate deconvolution model (ADM). Subsequently, the utility and accuracy of the ADM were demonstrated in a posteriori analyses of flows as diverse as incompressible plane-channel flow and supersonic compression-ramp flow. In a prelude to the current paper, a parameterized temporal ADM (TADM) was developed and demonstrated in both a priori and a posteriori analyses for forced, viscous Burger's flow. The development of a time-filtered variant of the ADM was motivated-primarily by the desire for a unifying theoretical and computational context to encompass direct numerical simulation (DNS), large-eddy simulation (LES), and Reynolds averaged Navier-Stokes simulation (RANS). The resultant methodology was termed temporal LES (TLES). To permit exploration of the parameter space, however, previous analyses of the TADM were restricted to Burger's flow, and it has remained to demonstrate the TADM and TLES methodology for three-dimensional flow. For several reasons, plane-channel flow presents an ideal test case for the TADM. Among these reasons, channel flow is anisotropic, yet it lends itself to highly efficient and accurate spectral numerical methods. Moreover, channel-flow has been investigated extensively by DNS, and a highly accurate data base of Moser et.al. exists. In the present paper, we develop a fully anisotropic TADM model and demonstrate its utility in simulating incompressible plane-channel flow at nominal values of Re(sub tau) = 180 and Re(sub tau) = 590 by the TLES method. The TADM model is shown to perform nearly as well as the ADM at equivalent resolution, thereby establishing TLES as a viable alternative to LES. Moreover, as the current model is suboptimal is some respects, there is considerable room to improve TLES.

Pruett, C. D.↗
NASA NTRS2002

Properties of the Residual Stress of the Temporally Filtered Navier-Stokes Equations

The development of a unifying framework among direct numerical simulations, large-eddy simulations, and statistically averaged formulations of the Navier-Stokes equations, is of current interest. Toward that goal, the properties of the residual (subgrid-scale) stress of the temporally filtered Navier-Stokes equations are carefully examined. Causal time-domain filters, parameterized by a temporal filter width 0 less than Delta less than infinity, are considered. For several reasons, the differential forms of such filters are preferred to their corresponding integral forms; among these, storage requirements for differential forms are typically much less than for integral forms and, for some filters, are independent of Delta. The behavior of the residual stress in the limits of both vanishing and in infinite filter widths is examined. It is shown analytically that, in the limit Delta to 0, the residual stress vanishes, in which case the Navier-Stokes equations are recovered from the temporally filtered equations. Alternately, in the limit Delta to infinity, the residual stress is equivalent to the long-time averaged stress, and the Reynolds-averaged Navier-Stokes equations are recovered from the temporally filtered equations. The predicted behavior at the asymptotic limits of filter width is further validated by numerical simulations of the temporally filtered forced, viscous Burger's equation. Finally, finite filter widths are also considered, and a priori analyses of temporal similarity and temporal approximate deconvolution models of the residual stress are conducted.

Pruett, C. D.↗
NASA NTRS1993

Analysis of direct numerical simulation data of a Mach 4.5 transitional boundary-layer flow

This paper describes the creation, by temporal direct numerical simulation and the analysis based on the Reynolds stress transport equations, of a high-quality data set that represents the laminar-turbulent transition of a high-speed boundary-layer flow. Following Pruett and Zang (1992), and with the help of algorithmic refinements, the evolution of an axial, Mach 4.5 boundary-layer flow along a hollow cylinder is simulated numerically. Favre-averaged Reynolds stress transport equations are derived in generalized curvilinear coordinates and are then specialized to the cylindrical geometry at hand. Reynolds stresses and various turbulence quantities, such as turbulent kinetic energy and turbulent Mach number, are calculated from the numerical data at various stages of the transition process. The kinetic energy 'budgets' are constructed from the transport equations. Various contributing terms for the evolution of kinetic energy, like the rates of production and dissipation, transport, and diffusion, are presented. The compressible dissipation rate is small in comparison with the solenoidal dissipation rate for all times. The pressure-dilatation term is of the same order of magnitude as the compressible dissipation rate.

Dinavahi, Surya P. G.↗
NASA NTRS1993

On the accurate prediction of the wall-normal velocity in compressible boundary-layer flow

A method for predicting the wall-normal velocity in compressible boundary layer flow is presented which is the extension of the fully implicit, spectral collocation method developed by Pruett and Streett (1991). The spectrally accurate method under consideration is capable of extracting the wall-normal velocity from the transformation from the physical plane to a computational plane, without interpolation, leaving the continuity equation free as a check on the quality of the solution. When used in conjunction with a highly accurate spectral collocation method for the compressible boundary-layer equations, the method gives a discrete solution which satisfies the continuity equation nearly to machine precision.

Pruett, C. D.↗
NASA NTRS1992

Transition region modeling for compressible flow

The ongoing effort at NASA Langley Research Center aimed at developing transitional zone models for Reynolds-averaged Navier-Stokes calculations is described. Results from three models that we have examined - two zero-equation models and a two-equation model of the k-omega type - are presented for high-speed flows. The use of analytical and computational tools to provide guidance and to provide the transitional flow-field data bases necessary to develop such models is discussed. Some results from validation of these tools are given; qualitative comparisons between modeled and theoretical/computational representations of the transitional zone are provided.

Chang, C.-L.↗
NASA NTRS1992

Direct numerical simulation of laminar breakdown in high-speed, axisymmetric boundary layers

Temporal direct numerical simulation of laminar breakdown via subharmonic secondary instability in high-speed axisymmetric boundary layers has been accomplished using a highly accurate, fully explicit algorithm which combines spectral collocation and high-order compact-difference techniques. Numerical test cases confirm that subharmonic secondary instability is confirmed to be a viable path to transition in high-speed boundary-layer flow. Secondary instability is shown to account for peaks in the Reynolds stresses at or near the critical layer which are not possible from the second-mode primary instability alone. Reynolds stresses spatially reconstructed from the temporal model via the Gaster transformation show a 'spreading angle' of about 12 deg, in qualitative agreement with experimental findings. The rate of broadening of the Reynolds stress peak is a strongly nonlinear phenomenon which cannot be reproduced by secondary instability theory.

Pruett, C. D.↗
NASA NTRS1992

Direct numerical simulation of laminar breakdown in high-speed, axisymmetric boundary layers

The compressible Navier-Stokes equations are solved using spectral collocation and high-order compact-difference techniques to simulate the laminar breakdown in high-speed, axisymmetric boundary-layer flow. Mach 4.5 flow along a hollow cylinder and Mach 6.8 flow along a sharp cone are considered. Data obtained replicate two previously unexplained phenomena, namely, the appearance of so-called 'rope-like waves' and 'the precursor transition effect', in which transitional flow originates near the critical layer well upstream of the transition location at the wall. The numerical data also reveal that neither of these effects can be explained, even qualitatively, by linear stability theory alone. It is shown that rope-like appearance arises from secondary instability. Certain features of the precursor transition effect also emerge from secondary instability but its nature is revealed to be fundamentally nonlinear.

Pruett, C. D.↗
NASA NTRS1991

On the nonlinear stability of a high-speed, axisymmetric boundary layer

The stability of a high-speed, axisymmetric boundary layer is investigated using secondary instability theory and direct numerical simulation. Parametric studies based on the temporal secondary instability theory identify subharmonic secondary instability as a likely path to transition on a cylinder at Mach 4.5. The theoretical predictions are validated by direct numerical simulation at temporally-evolving primary and secondary disturbances in an axisymmetric boundary-layer flow. At small amplitudes of the secondary disturbance, predicted growth rates agree to several significant digits with values obtained from the spectrally-accurate solution of the compressible Navier-Stokes equations. Qualitative agreement persists to large amplitudes of the secondary disturbance. Moderate transverse curvature is shown to significantly affect the growth rate of axisymmetric second mode disturbances, the likely candidates of primary instability. The influence of curvature on secondary instability is largely indirect but most probably significant, through modulation of the primary disturbance amplitude. Subharamonic secondary instability is shown to be predominantly inviscid in nature, and to account for spikes in the Reynolds stress components at or near the critical layer.

Pruett, C. D.↗
NASA NTRS1991

A spectral collocation method for compressible, non-similar boundary layers

An efficient and highly accurate algorithm based on a spectral collocation method is developed for numerical solution of the compressible, two-dimensional and axisymmetric boundary layer equations. The numerical method incorporates a fifth-order, fully implicit marching scheme in the streamwise (timelike) dimension and a spectral collocation method based on Chebyshev polynomial expansions in the wall-normal (spacelike) dimension. The spectral collocation algorithm is used to derive the nonsimilar mean velocity and temperature profiles in the boundary layer of a 'fuselage' (cylinder) in a high-speed (Mach 5) flow parallel to its axis. The stability of the flow is shown to be sensitive to the gradual streamwise evolution of the mean flow and it is concluded that the effects of transverse curvature on stability should not be ignored routinely.

Pruett, C. D.↗
NASA NTRS1981

An innovative air data system for the Space Shuttle Orbiter - Data analysis techniques

The Shuttle Entry Air Data System (SEADS) is an experimental system designed to supply research quality air data and to meet Orbiter operational air data requirements throughout entry. SEADS incorporates no mechanical devices but is based on the concept that the fuselage proper, whether symmetrical or not, can be instrumented so as to function both as a pitot-static probe and as a differential pressure flow direction sensor. Specifically SEADS consists of 20 flush orifices, each routed to a pair of absolute pressure transducers. A computational technique has been developed capable of extracting air data parameters solely from surface pressure measurements. The digital filtering algorithm implemented in SEADS is the natural adaptation to air data sensing of a technology widely used in navigation, guidance, and control systems.

Pruett, C. D.↗
NASA NTRS1981

Comparison of forward fuselage to Space Shuttle Orbiter flight pressure data to wind tunnel and analytical results in the hypersonic Mach number range

The Space Transportation System (STS) test program is unique in that it combines flight testing with operational flights using the first operational orbital vehicle (OV-102). The Space Shuttle Orbiter was instrumented to obtain various types of flight data. The instrumentation, designated Development Flight Instrumentation (DFI) includes pressure transducers, thermocouples, calorimeters, and accelerometers. A comparison is conducted between orbiter DFI forward fuselage flight pressure data obtained from OV-102 during the STS-1 reentry, and ground facility data obtained utilizing a 0.04 scale Orbiter forebody model. The comparisons are used to validate the existing experimental data base, optimize the pressure modeling technique, and make possible the refinement of error analysis relative to both. The obtained results indicate, in general, good agreement between flight and ground-based data.

Bradley, P. F.↗