Engineering topics

Qi, Xianghui

Publications and source records attributed to Qi, Xianghui.

5 records

DOE OSTI2024

Assessing microbial systems and process configurations for improved ethanol production from sugary stovers by integrating soluble sugars and holocellulose

Here, this study evaluated microbial systems and technological approaches to configure the whole slurry co-fermentation process for ethanol biosynthesis from a novel stover system rich in sugars. Two approaches, namely separate and simultaneous hydrolysis and co-fermentation (SHCF and SSCF, respectively), were investigated using Escherichia coli monoculture and E. coli-yeast coculture. The SSCF with E. coli monoculture produced 32.75 g/L ethanol, representing only 44.87% yield, which left 65.13 g/L of total sugars unconverted and exhibited limited xylose consumption. Subsequently, a coculture-based SHCF significantly enhanced sugar consumption, leading to increase in ethanol yield and concentration to 66.94% and 48.86 g/L, respectively. Nevertheless, xylose utilization remained minimal due to the preference for glucose and the inhibitory effects of certain compounds. Thereafter, modification of the medium composition by supplementing betaine and sodium metabisulfite improved ethanol production to 53.18 g/L by reducing the toxic effects of inhibitors. Finally, a dual-phase SSCF (DP-SSCF) was explored by allowing the consumption of sugars from the pretreated slurry in the first phase, followed by concurrent cellulose hydrolysis and utilization of the resulting glucose in the second phase. This strategy increased ethanol titer to 63.14 g/L, with 84.3% yield and 0.88 g/L/h productivity.

09 BIOMASS FUELS↗

DOE OSTI2023

Towards the sustainable conversion of corn stover into bioenergy and bioproducts through biochemical route: Technical, economic and strategic perspectives

Corn stover (CS) is one of the most abundant agricultural wastes and is ubiquitous around the world that is left over after grain harvest and accounts for 47–50% dry mass of the total grain yield. The global CS yield is 1661.25 million tons/year, which is 27.2% of the total agricultural waste. CS consists of about 34.5% stems, 32.3% leaves, 14.3% husks, 12.3% cobs and 6.6% flowers, with up to 45% cellulose, 30% hemicellulose and 20% lignin. Further, due to its favorable economic and environmental potential, CS is considered an ideal raw material for producing biofuels and biobased chemicals, which can largely be divided into carbohydrate and lignin platforms. However, the techno-economic perspectives of CS-based biorefineries have remained questionable due to the inadequate supply chain logistics, lack of cost-effective conversion technologies, limited scale-up of the product-specific technologies, and lower competitiveness in the market compared to their counterparts, such as sugar and starch-based biorefineries. While CS is converted by thermochemical and biochemical approaches, the latter is considered to be more sustainable for its selective conversion under mild conditions using microorganisms. This review aimed to critically discuss the latest research and developments on the biochemical conversion of CS into biofuels and chemicals. In particular, this paper covers the market potential of biofuels and chemicals to which CS can make a significant contribution, technological developments in the microbial conversion of CS, major biofuels and chemicals produced from CS-derived carbohydrates and lignin, and the technoeconomic perspectives of CS-based biorefinery.

09 BIOMASS FUELS↗

DOE OSTI2023

Rechargeable metal-metal alkaline batteries: Recent advances, current issues and future research strategies

Over the past few decades, remarkable advancement has been attained in the field of rechargeable metal–metal alkaline batteries (RABs). In terms of safety, energy density, charge-discharge capacity, and long-term storage capability, metal-metal RABs (e.g., Ni–Zn, Ni–Fe, Ni–Bi, Ni–MH, Ag–Zn, Co–Zn, Cu–Zn, and Bi–Zn systems) are contemplated as the promising energy storage devices for the applications in electric vehicles (EVs), hybrid EVs, grid-scale energy storage, as well as various implantable and wearable electronic devices. Especially, Ni-MH batteries become competitive with Li-ion batteries for EVs and hybrid EVs applications due to their high tolerance against mechanical abuse, stability under wide temperature ranges, and considerable charge/discharge capacity. Meanwhile, earlier works reviewed only specific topics, so, as a rapidly growing research topic, providing a deep understanding on metal–metal RABs is timely and worthwhile. So here, in this work, we discuss the electrochemistry of all metal-metal RABs, then full cell designing with their performance will be discussed thoroughly. Further, issues associated with the existing metal–metal RABs and corresponding improvement approaches will be provided for future advances in high-performance and reliable metal-metal RABs.

25 ENERGY STORAGE↗

DOE OSTI2022

Biocatalytic gateway to convert glycerol into 3-hydroxypropionic acid in waste-based biorefineries: Fundamentals, limitations, and potential research strategies

Microbial conversion of bioenergy-derived waste glycerol into value-added chemicals has emerged as an important bioprocessing technology due to its eco-friendliness, feasible technoeconomics, and potential to provide sustainability in biodiesel and bioethanol production. Glycerol is an abundant liquid waste from bioenergy plants with a projected volume of 6 million tons by 2025, accounting for about 10% of biodiesel and 2.5% of bioethanol yields. 3-Hydroxypropionic acid (3-HP) is a major product of glycerol bioconversion, which is the third largest biobased platform compound with expected market size and value of 3.6 million tons/year and USD 10 billion/year, respectively. Despite these biorefinery values, 3-HP biosynthesis from glycerol is still at an immature stage of commercial exploitation. The main challenges behind this immaturity are the toxic effects of 3-HPA on cells, the distribution of carbon flux to undesirable pathways, low tolerance of cells to glycerol and 3-HP, co-factor dependence of enzymes, low enzyme activity and stability, and the problems of substrate inhibition and specificity of enzymes. To address these challenges, it is necessary to understand the fundamentals of glycerol bioconversion and 3-HP production in terms of metabolic pathways, related enzymes, cell factories, midstream process configurations, and downstream 3-HP recovery, as discussed in this review critically and comprehensively. It is equally important to know the current challenges and limitations in 3-HP production, which are discussed in detail along with recent research efforts and remaining gaps. Finally, possible research strategies are outlined considering the recent technological advances in microbial biosynthesis, aiming to attract further research efforts to achieve a sustainable and industrially exploitable 3-HP production technology. Here, by discussing the use of advanced tools and strategies to overcome the existing challenges in 3-HP biosynthesis, this review will attract researchers from many other similar biosynthesis technologies and provide a common gateway for their further development.

59 BASIC BIOLOGICAL SCIENCES↗

DOE OSTI2022

High-level co-production of 3-hydroxypropionic acid and 1,3-propanediol from glycerol: Metabolic engineering and process optimization

3-Hydroxypropionic acid (3-HP) and 1,3-propanediol (1,3-PDO) are value-added chemicals with versatile applications in the chemical, pharmaceutical, and food industries. Nevertheless, sustainable production of 3-HP and 1,3-PDO is often limited by the lack of efficient strains and suitable fermentation configurations. We report attempts have been made to improve the co-production of both metabolites through metabolic engineering of Escherichia coli and process optimization. First, the 3-HP and 1,3-PDO co-biosynthetic pathways were recruited and optimized in E. coli, followed by coupling the pathways to the transhydrogenase-mediated cofactor regeneration systems that increased cofactor availability and product synthesis. Next, pathway rebalancing and block of by-product formation significantly improved 3-HP and 1,3-PDO net titer. Subsequently, glycerol flux toward 3-HP and 1,3-PDO synthesis was maximized by removing metabolic repression and fine-tuning the glycerol oxidation pathway. Lastly, the combined fermentation process optimization and two-stage pH-controlled fed-batch fermentation co-produced 140.50 g/L 3-HP and 1,3-PDO, with 0.85 mol/mol net yield.

1,3-propanediol↗