Search NASA⌕ Search

Engineering topics

Qiaoyun Hu

Publications and source records attributed to Qiaoyun Hu.

Variability of Lidar-Derived Particle Properties Over West Africa Due to Changes in Absorption: Towards an Understanding

Measurements performed in western Africa (Senegal) during the SHADOW field campaign are analyzed to show that spectral dependence of the imaginary part of the complex refractive index (CRI) of dust can be revealed by lidar-measured particle parameters. Observations in April 2015 provide good opportunity for such study, because, due to high optical depth of the dust, exceeding 0.5, the extinction coefficient could be derived from lidar measurements with high accuracy and the contribution of other aerosol types, such as biomass burning, was negligible. For instance, in the second half of April 2015, AERONET observations demonstrated a temporal decrease in the imaginary part of the CRI at 440 nm from approximately 0.0045 to 0.0025. This decrease is in line with a change in the relationship between the lidar ratios (the extinction-to-backscattering ratio) at 355 and 532 nm (S(355) and S(532)). For instance in the first half of April, S(355)∕S(532) is as high as 1.5 and the backscatter Angstrom exponent, A(β), is as low as −0.75, while after 15 April S(355)/S(532)=1.0 and A(β) is close to zero. The aerosol depolarization ratio δ(532) for the whole of April exceeded 30 % in the height range considered, implying that no other aerosol, except dust, occurred. The performed modeling confirmed that the observed S(355)∕S(532) and Aβ values match the spectrally dependent imaginary part of the refractive index as can be expected for mineral dust containing iron oxides. The second phase of the SHADOW campaign was focused on evaluation of the lidar ratio of smoke and estimates of its dependence on relative humidity (RH). For five studied smoke episodes the lidar ratio increases from 44±5 to 66±7 sr at 532 nm and from 62±6 to 80±8 sr at 355 nm, when RH varied from 25 % to 85 %. Performed numerical simulations demonstrate that observed ratio S(355)∕S(532), exceeding 1.0 in the smoke plumes, can indicate an increase in the imaginary part of the smoke particles in the ultraviolet (UV) range.

Lidar-Derived Particle Properties↗

Constraining global aerosol emissions using POLDER/PARASOL satellite remote sensing observations

We invert global black carbon (BC), organic carbon (OC) and desert dust (DD) aerosol emissions from POLDER/PARASOL spectral aerosol optical depth (AOD) and aerosol absorption optical depth (AAOD) using the GEOS-Chem inverse modeling framework. Our inverse modeling framework uses standard a priori emissions to provide a posteriori emissions that are constrained by POLDER/PARASOL AODs and AAODs. The following global emission values were retrieved for the three aerosol components: 18.4 Tg/yr for BC, 109.9 Tg/yr for OC and 731.6 Tg/yr for DD for the year 2010. These values show a difference of +166.7 %, +184.0 % and −42.4 %, respectively, with respect to the a priori values of emission inventories used in “standard” GEOS-Chem runs. The model simulations using a posteriori emissions (i.e., retrieved emissions) provide values of 0.119 for global mean AOD and 0.0071 for AAOD at 550 nm, which are +13.3 % and +82.1 %, respectively, higher than the AOD and AAOD obtained using the a priori values of emissions. Additionally, the a posteriori model simulation of AOD, AAOD, single scattering albedo, Ångström exponent and absorption Ångström exponent show better agreement with independent AERONET, MODIS and OMI measurements than the a priori simulation. Thus, this study suggests that using satellite-constrained global aerosol emissions in aerosol transport models can improve the accuracy of simulated global aerosol properties.

chemical transport model (CTM) simulations↗

TPSAS-NF1676L-34010-DND

We invert global black carbon (BC), organic carbon (OC) and desert dust (DD) aerosol emissions from POLDER/PARASOL spectral aerosol optical depth (AOD) and aerosol absorption optical depth (AAOD) using the GEOSChem inverse modelling framework. Our inverse modeling framework uses standard a priori emissions to provide a posteriori emissions that are constrained by POLDER/PARASOL AODs and AAODs. Our satellite-derived global aerosol emission database indicates an increase of BC and OC, while a decrease of DD with respect to the a priori emission inventories used in standard GEOS-Chem runs. The model simulations using a posteriori emissions (i.e. retrieved emissions) provide new estimate of global aerosol extinction and absorption constrained by observations. Additionally, the a posteriori model simulation of AOD, AAOD, single scattering albedo, Angstrom exponent, and absorption Angstrom exponent show better agreement with independent AERONET, MODIS, and OMI measurements than the a priori simulation. Thus, this study suggests that using satellite-constrained global aerosol emissions in aerosol transport models can improve the accuracy of simulated global aerosol properties and have potential to better understanding global aerosol effects on climate and human health.

Cheng Chen↗