Engineering topics

Qiu, Chongpeng

Publications and source records attributed to Qiu, Chongpeng.

2 records

DOE OSTI2024

Frequency‐Locked Wireless Multifunctional Surface Acoustic Wave Sensors

Abstract Surface acoustic waves (SAWs) have shown great potential for developing sensors for structural health monitoring (SHM) and lab‐on‐a‐chip (LOC) applications. Existing SAW sensors mainly rely on measuring the frequency shifts of high‐frequency (e.g., >0.1 GHz) resonance peaks. This study presents frequency‐locked wireless multifunctional SAW sensors that enable multiple wireless sensing functions, including strain sensing, temperature measurement, water presence detection, and vibration sensing. These sensors leverage SAW resonators on piezoelectric chips, inductive coupling‐based wireless power transmission, and, particularly, a frequency‐locked wireless sensing mechanism that works at low frequencies (e.g., <0.1 GHz). This mechanism locks the input frequency on the slope of a sensor's reflection spectrum and monitors the reflection signal's amplitude change induced by the changes of sensing parameters. The proof‐of‐concept experiments show that these wireless sensors can operate in a low‐power active mode for on‐demand wireless strain measurement, temperature sensing, and water presence detection. Moreover, these sensors can operate in a power‐free passive mode for vibration sensing, with results that agree well with laser vibrometer measurements. It is anticipated that the designs and mechanisms of the frequency‐locked wireless SAW sensors will inspire researchers to develop future wireless multifunctional sensors for SHM and LOC applications.

Bo, Luyu↗

DOE OSTI2021

The preparation and properties of polyurethane foams reinforced with bamboo fiber sources in China

Abstract Polyurethane (PU) foams reinforced with bamboo fiber sources in China, i.e. , bamboo fiber, bamboo α -cellulose fiber, and bamboo nanocellulose fiber, were prepared and their physico-mechanical properties were analyzed in this work. The bamboo fiber sources and PU foams were characterized by Fourier transform infrared spectroscopy (FTIR), Scanning electron microscope (SEM), Thermal gravimetric analysis (TGA) and universal compression testing. The results indicated that the hydroxyl groups on the fiber surfaces were enhanced by removing non-celluloses in the preparation of α -cellulose and nanocellulose. With the addition of small particle size α -cellulose and nanocellulose, the cell sizes of PU foams were reduced due to more nucleating agents being introduced. The FTIR spectra confirmed that the bamboo fiber sources were involved in the foaming reaction. The PU foams with bamboo fiber sources had a higher thermal stability than neat foam, and they were satisfactory enough to be used as insulation. PU foams reinforced with 5% bamboo fiber, 3% α -cellulose fiber and 3% nanocellulose fiber had better physico-mechanical performance than other foams. The reinforcement performance of 3% bamboo α -cellulose fiber on PU foam was comparable with that of high-cost nanocellulose. Accordingly, bamboo α -cellulose fiber was demonstrated to be a promising candidate to reinforce PU foam, which could be used in the reinforcement of foam insulation.

Qiu, Chongpeng↗