Search NASA⌕ Search

Engineering topics

R. J. Smith

Publications and source records attributed to R. J. Smith.

X-Ray Amorphous Sulfur-Bearing Phases in Sedimentary Rocks of Gale Crater, Mars

The Curiosity rover in Gale crater is investigating a mineral transition observed from orbit—an older “clay unit” to a younger “sulfate unit”—hypothesized to reflect the aridification of Mars' climate. Below this transition, the rover detected crystalline Ca-sulfates with minor Fe-sulfates but also found that some fraction of a rock's bulk SO 3 is often in the poorly constrained X-ray amorphous component. Here, we characterize the abundances and compositions of the X-ray amorphous sulfur-bearing phases in 19 drilled samples using a mass balance approach, and in a subset of 5 samples using evolved SO 2 gas measured using the SAM instrument. We find that ∼20–90 wt% of a sample's bulk SO 3 is in the X-ray amorphous state and that X-ray amorphous sulfur-bearing phase compositions are consistent with mixtures of Mg-S, Fe-S, and possibly Ca-S phases, likely sulfates or sulfites. These phases reside in the bedrock, perhaps as cementing agents deposited with detrital sediments or during early diagenesis, and in diagenetic alteration halos deposited after lithification during late diagenesis. The likely presence of highly soluble Mg-sulfates in the rocks suggests negligible fluid flow through the bedrock post-Mg-sulfate deposition. The X-ray amorphous sulfur-bearing phases probably became amorphous through dehydration in the current Martian atmosphere or inside the CheMin instrument. X-ray amorphous sulfur-bearing materials likely contribute to orbital spectral detections of sulfates, and so our results help form multiple hypotheses to be tested in the sulfate unit and are important for understanding the evolution of the Martian surface environment at Gale crater.

R. J. Smith↗

Characterizing Martian X-ray Amorphous Materials through Terrestrial Analogs

X-ray amorphous materials (i.e., lacking long-range crystallographic order) have been identified on the martian surface from orbit and in-situ. Initial models of orbital IR spectral data identified volcanic glasses [e.g., 1], but subsequent interpretations suggested that amorphous silicates are dominantly secondary in nature and formed from water-rock interactions [e.g., 2-4]. ThermalIR spectra from the Mini-Thermal Emission Spectrometer on the Spirit rover show evidence for the amorphous secondary product opaline silica[e.g., 5].X-ray diffraction (XRD) measurements by the CheMin instrument on the Mars Science Laboratory rover have identified 20-70 wt.% amorphous materials in every sample analyzed in Gale crater to date [e.g., 6]. Mass balance calculations using CheMin results and bulk elemental measurements by the Alpha Particle X-ray Spectrometer suggest the amorphous component in Gale crater is variably enriched in Si, Fe, and S[e.g., 7,8].The compositions are not consistent with pure volcanic glass, indicating water must have been involved in the formation of amorphous materials in Gale crater. We seek to better constrain the conditions under which amorphous materials on Mars formed by studying the composition and short-range atomic order of amorphous materials in terrestrial analog environments via XRD and transmission electron microscopy (TEM).

E. B. Rampe↗