Engineering topics

Rack, H. J.

Publications and source records attributed to Rack, H. J..

5 records

NASA NTRS1989

Aging effects on the fracture toughness of SiC whisker reinforced 2XXX aluminum alloys

The effect of aging (at 150 C) time on the fracture toughness behavior of a 2XXX alloy (Al-3.55Cu-1.29Mg-0.01Fe-trace Mn) reinforced with 5 vol pct F-8 SiC whiskers was investigated by measuring hardness and electrical conductivity followed by fracture toughness tests on center-cracked specimens. The ageing time-hardening response plots showed that, independent of whisker orientation, the initial rapid increase in hardness was followed by a more gradual increase, with a broad hardness peak between 32 and 128 hrs of aging. Coincident with the hardness changes, the electrical conductivity initially decreased, reached a minimum, and then increased at aging times beyond 32 hrs. Examination by SEM indicated that the initial increase in hardness and decrease in conductivity was due to the GPB zone formation, while the subsequent increase in electrical conductivity and decrease in hardness (overaging) was due to S nucleation and growth.

Ratnaparkhi, P. L.↗

NASA NTRS1988

Fracture criteria for discontinuously reinforced metal matrix composites

Summarized is the progress achieved during the period September 16, 1987 to August 15, l988 on NASA Grant NAG1-724, Fracture Criteria for Discontinuously Reinforced Metal Matrix Composites. Appended are copies of three manuscripts prepared under NASA funding during the performance period.

Rack, H. J.↗

NASA NTRS1988

Fracture criteria for discontinuously reinforced metal matrix composites

The effect of sample configuration on the details of initial crack propagation in discontinuously whisker reinforced aluminum metal matrix composites was investigated. Care was taken to allow direct comparison of fracture toughness values utilizing differing sample configurations and orientations, holding all materials variables constant, e.g., extrusion ration, heat treatment, and chemistry.

Rack, H. J.↗

NASA NTRS1988

Light-weight, high-performance metal matrix composites

Recent years have seen the development of a wide range of light-weight, high-performance aluminum powder metallurgy composites that combine both standard (6061 and 2124) and specialty matrix compositions (Al-Mg-Cu-Li and Al-Fe-Ce) with a wide variety of discontinuous reinforcements (Al2O3, B4C, and SiC). This paper reviews the fabrication and damage tolerance performance of these light-weight, high-performance composites. Particular attention is given to developing a general framework for understanding the interrelationship existing between microstructure, thermomechanical processing and ductility/fracture toughness behavior in these composite systems.

Rack, H. J.↗

NASA NTRS1988

P/M aluminum metal matrix composites

Development of lightweight, high specific stiffness engineered materials has been the long term goal of many investigators. Recently, this quest has focused on discontinuously reinforced aluminum metal matrix composites. This paper reviews the fabrication of powder metallurgy discontinuously reinforced metal matrix composites. Emphasis is given to the differences in heat treatment response reported between unreinforced and reinforced powder metallurgy materials. It is proposed that these observations can be rationalized by considering the effects of pre-existing heterogeneous nucleation sites, i.e., the dislocation substructure developed during rapid cooling of discontinuously reinforced aluminum metal matrix composites, on precipitation in reinforced aluminum alloys.

Rack, H. J.↗