Search NASA⌕ Search

Engineering topics

Rae, W. H., Jr.

Publications and source records attributed to Rae, W. H., Jr..

Recent research on V/STOL test limits at the University of Washington aeronautical laboratory

The occurence of flow breakdown during the wind tunnel testing of a powered V/STOL aircraft was studied. Flow breakdown is the low forward speed test limit in a solid wall wind tunnel and is characterized by a vortex which forms on the floor and walls of the wind tunnel thereby failing to simulate free air conditions. The flow is caused by the interaction of the model wake and tunnel boundary layer and affects the model's aerodynamic characteristics in such fashion as to negate their reliability as correctable wind tunnel data. The low speed test limit was examined using a model that possessed a discretely concentrated powered lift system using a pair of lift jets. The system design is discussed and the tests and results which show that flow breakdown occurs at a velocity ratio of approximately 0.20 are reported.

Shindo, S.↗

Low-speed test limit of V/STOL model located vertically off-center

A vertically off-centered V/STOL model - a 2-ft-diam three-bladed aluminum propeller operating in a rotor mode - is tested in an 8 by 12 ft wind tunnel with and without ground plane along with an associated 3 by 4.5 ft test section insert. The objective was to assess the effect of the vertically off-centered model on the low-speed test limit. The aerodynamic data of the model at a constant negative angle of attack (-3 deg) are recorded at selected tunnel dynamic pressures to provide adequate data points to define the model lift variation with respect to the tip speed ratio. The adverse effect of the rotor low-speed test limit is observed in the form of lift change with respect to the tip speed ratio. A major conclusion is that for rotors tested with a ground plane or in the vicinity of the floor, the ratio of distance between floor and model to rotor radius defines the low-speed test limits.

Shindo, S.↗

Some comments on V/STOL wind tunnel testing in the transition flight region

Flow breakdown and flow distortion are discussed as the two limitations to wind tunnel testing of V/STOL models at speeds within or near the transition region. It is shown that a very large wind tunnel would be most useful for research into basic aerodynamic phenomena associated with V/STOL aircraft. The large tunnel will not be able to meet the requirements of all the desired testing of V/STOL models, and smaller existing tunnels will continue to be used. There is need for more work, both experimental and theoretical, to bring about a more correct use of the smaller wind tunnels. The large tunnel would be a most useful tool in this work.

Rae, W. H., Jr.↗