Search NASASearch

Engineering topics

Raggam, J.

Publications and source records attributed to Raggam, J..

Radar stereomapping techniques and application to SIR-B images of Mt. Shasta

One of the goals of the SIR-B experiment was the definition of optimum radar incidence and intersection angles for radargrammetric stereoscopy by comparing the results from three separate data-reduction methods. To this end three overlapping images of the prime radargrammetric site (Mt. Shasta in northern California) were obtained, fewer than anticipated. This paper describes the mathematical basis for radar stereomapping, along with preliminary results from one of the methods (using a so-called 'analytical' stereoplotter) for the Mt. Shasta site. Height coordinate errors range from 60 to 170 m depending on the density (number per ground area) of ground control points used.

Leberl, F. W.

Multiple incidence angle SIR-B experiment over Argentina Stereo-radargrammetric analysis

Four overlapping Shuttle Imaging Radar-B (SIR-B) radar images were obtained across southern Argentina; these form a total of six stereo models with intersection angles ranging from 5 to 23 deg. This data set is uniquely suited for experimental evaluation of some basic assumptions on stereo-radargrammetry. Each stereo model was measured on a specially programmed photogrammetric analytical plotter; the resulting coordinates of ground points were compared with those from maps. It is concluded that accuracies are lower than expected at the larger stereo-intersection angles, amounting to about + or 60 m in each coordinate direction. This might be explained by limitations of the quality of stereofusion caused by look angle differences and specular point migration, backscatter differences due to different incidence angles, differences in azimuth directions, and image noise and speckle.

Leberl, F.

Space Shuttle radargrammetry results

Preliminary results on the radargrammetric processing of SIR-A and SIR-B data are presented. Radargrammetric processing was applied to images of the Trinity National Forest in Northern California, the islands of Cephalonia, Ithaka, and Sardegna, Mt. Shasta, and Cordon La Grasa, Argentina. The preliminary processing of the SIR-A and SIR-B data has produced digital elevation models, stereo models, and a contour map.

Leberl, F.

Developing tools for digital radar image data evaluation

The refinement of radar image analysis methods has led to a need for a systems approach to radar image processing software. Developments stimulated through satellite radar are combined with standard image processing techniques to create a user environment to manipulate and analyze airborne and satellite radar images. One aim is to create radar products for the user from the original data to enhance the ease of understanding the contents. The results are called secondary image products and derive from the original digital images. Another aim is to support interactive SAR image analysis. Software methods permit use of a digital height model to create ortho images, synthetic images, stereo-ortho images, radar maps or color combinations of different component products. Efforts are ongoing to integrate individual tools into a combined hardware/software environment for interactive radar image analysis.

Domik, G.

On stereo viewing of SAR images

Stereo viewing is indispensable for the measurement of homologue points in two overlapping images and the subsequent reconstruction of the three-dimensional topographic relief. Aspects of stereo viewing geometry are discussed along with problems of radar stereoscopy, taking into account stereo evaluation with an exaggeration factor, the viewability of real images, and radar stereoscopic computations. Attention is given to the definition of radar stereoscopic exaggeration, questions of image simulation, and the accuracy obtained with parallax measurements in radar images. An evaluation with a large set of about 40 radar stereo models demonstrates that same-side arrangements provide good stereo viewability. This result was confirmed for aircraft radar with look angles off-nadir of 60-80 deg and intersection angles between 0.2 deg and 23 deg, and for satellite radar (Seasat) with look angles of 20 deg and interaction angles of 1.2 deg - 4.8 deg.

Leberl, F. W.

SIR-B cartography and stereo topographic mapping

The SIR-B mapping experiment which will evaluate the utility of SAR images taken singularly, in pairs, and in combination with other data sets for cartographic, topographic, and thematic mapping, and determine the optimum configuration of a SAR system for future mapping mission is outlined. SIR-B is the first orbital imaging radar mission which will incorporate maintenance of geometric image fidelity along with careful calibration and documentation of internal timing and frequency parameters. This along and and the multiple incidence angle images of the same target which are necessary for stereoscopy and topographic mapping, make it the ideal opportunity for cartographic experimentation. It is emphasized that comprises a significant part of the overall experiment objectives.

Kobrick, M.

Sea ice motion measurements from Seasat SAR images

Data from the Seasat synthetic aperture radar (SAR) experiment are analyzed in order to determine the accuracy of this information for mapping the distribution of sea ice and its motion. Data from observations of sea ice in the Beaufort Sea from seven sequential orbits of the satellite were selected to study the capabilities and limitations of spaceborne radar application to sea-ice mapping. Results show that there is no difficulty in identifying homologue ice features on sequential radar images and the accuracy is entirely controlled by the accuracy of the orbit data and the geometric calibration of the sensor. Conventional radargrammetric methods are found to serve well for satellite radar ice mapping, while ground control points can be used to calibrate the ice location and motion measurements in the cases where orbit data and sensor calibration are lacking. The ice motion was determined to be approximately 6.4 + or - 0.5 km/day. In addition, the accuracy of pixel location was found over land areas. The use of one control point in 10,000 sq km produced an accuracy of about + or 150 m, while with a higher density of control points (7 in 1000 sq km) the location accuracy improves to the image resolution of + or - 25 m. This is found to be applicable for both optical and digital data.

Leberl, F.

Stereo side-looking radar experiments

The application of side-looking radar images in geoscience fields can be enhanced when using overlapping image strips that are viewed in stereo. A question concerns the quality of stereo radar. This quality is described evaluating stereo viewability and using the concept of vertical exaggeration with sets of actual radar images. A conclusion is that currently available stereo radar data are not optimized, that therefore a better quality can be achieved if data acquisition is appropriately arranged, and that the actual limitations of stereo radar are still unexplored. Previously announced in STAR as N83-29489

Leberl, F.

Stereo side-looking radar experiments

The application of side-looking radar images in geoscience fields can be enhanced when using overlapping image strips that are viewed in stereo. A question concerns the quality of stereo radar. This quality is described evaluating stereo viewability and using the concept of vertical exaggeration with sets of actual radar images. A conclusion is that currently available stereo radar data are not optimized, that therefore a better quality can be achieved if data acquisition is appropriately arranged, and that the actual limitations of stereo radar are still unexplored.

Leberl, F.