Search NASA⌕ Search

Engineering topics

Rahman, A

Publications and source records attributed to Rahman, A.

A SiC NMOS Linear Voltage Regulator for High-Temperature Applications

The first SiC integrated circuit linear voltage regulator is reported. The voltage regulator uses a 20-V supply and generates an output of 15 V, adjustable down to 10 V. It was designed for loads of up to 2 A over a temperature range of 25-225 degrees C. It was, however, successfully tested up to 300 degrees C. The voltage regulator demonstrated load regulations of 1.49% and 9% for a 2-A load at temperatures of 25 and 300 degrees C, respectively. However, the load regulation is less than 2% up to 300 degrees C for a 1-A load. The line regulation with a 2-A load at 25 and 300 degrees C was 17 and 296 mV/V, respectively. The regulator was fabricated in a Cree 4H-SiC 2-mu m experimental process and consists of 1000, 32/2-mu m NMOS depletion MOSFETs as the pass device, an integrated error amplifier with enhancement MOSFETs, and resistor loads, and uses external feedback and compensation networks to ensure operational integrity. It was designed to be integrated with high-voltage vertical power MOSFETs on the same SiC substrate. It also serves as a guide to future attempts for voltage regulation in any type of integrated SiC circuitry.

Valle-Mayorga, JA↗

Comparative Studies on Temperature Dependent I-V Characteristics of Al/(p)CdTe and Ni/(n)CdS Schottky Junctions and Their PV Effect

Temperature dependent I-V characteristics of vacuum evaporated Al/(p)CdTe and Ni/(n)CdS Schottky junctions and their photovoltaic effects have been studied and compared. Different junction parameters such as ideality factors, barrier heights, Richardson's constant, short-circuit current density, fill factor, PV efficiency etc. were determined from their I-V characteristics. These parameters were found to change significantly on variation of temperature. The structures showed the change of PV effect. Efficiency found were 2.84% for Al/(p)CdTe and 4.44% for Ni hydro/(n)CdS. Polycrystalline nature, and continuous and ordered structure with bigger grain sizes of the CdS film shows more PV conversion efficiency in making Ni/(n)CdS junction as compare to Al/(p)CdTe junction. However these values were found to vary with doping concentration, and in hydrogen treated samples in both cases.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Optical and Electrical Properties of Al/(p)Bi{sub 2}S{sub 3} Schottky Junction

Thin film Al/(p)Bi{sub 2}S{sub 3} Schottky junctions were prepared by vacuum evaporation under pressure 10{sup -6} Torr. The p-type Bi{sub 2}S{sub 3} thin films with acceptor concentration (3.36-7.33)x10{sup 16}/cm{sup 3} were obtained by evaporating 'In' along with Bi{sub 2}S{sub 3} powder and then annealing the films at 453K for 5 hours. Different junction-parameters such as ideality factor, barrier height, effective Richardson's constant, short-circuit current, etc. were determined from I-V characteristics. The junctions exhibited rectifying I-V characteristics and also photovoltaic effect. Ideality factor was found to decrease with the increase of temperature. Proper doping, annealing, and hydrogenation are necessary to reduce the series resistance so as to achieve high carrier efficiency. More works are being carried out in this direction.

36 MATERIALS SCIENCE↗