Search NASA⌕ Search

Engineering topics

Raitses, Y

Publications and source records attributed to Raitses, Y.

At least 19 records

Quantitative imaging of carbon dimer precursor for nanomaterial synthesis in the carbon arc

Delineating the dominant processes responsible for nanomaterial synthesis in a plasmaenvironment requires measurements of the precursor species contributing to the growth ofnanostructures. We performed comprehensive measurements of spatial and temporal profiles ofcarbon dimers in sub-atmospheric-pressure carbon arc by laser-induced fluorescence.Measured spatial profiles of carbon dimers coincide with the growth region of carbon nanotubes (Fang et al2016 Carbon 107 273-80) and vary depending on the arc operation mode, which is determinedby the discharge current and the ablation rate of the graphite anode. The carbon dimer density profileexhibits large spatial and time variations due to motion of the arc core. A comparison of theexperimental data with the 2D simulation results of self-consistent arc modeling shows a goodagreement. The model predicts well the main processes determining spatial profiles of carbondimers.

arc discharge↗

Feedback control of an azimuthal oscillation in the E Multiplication-Sign B discharge of Hall thrusters

Feedback control of a low-frequency azimuthal wave known as a 'rotating spoke' in the E Multiplication-Sign B discharge of a cylindrical Hall thruster was demonstrated. The rotating spoke is an m = 1 azimuthal variation in density, electron temperature, and potential that rotates at about 10% of the local E Multiplication-Sign B electron rotation speed. It causes increased electron transport across the magnetic field and is suspected to be an ionization wave. Feedback control of this wave required special consideration because, although it causes a rotating azimuthal variation in the current density to the anode, it does not show up as a signal in the total thruster discharge current. Therefore, an extra source of information was needed to track the oscillation, which was addressed by using a special anode that was split azimuthally into four segments. The current to each segment oscillates as the rotating spoke passes over it, and feedback is accomplished by resistors connected in series with each anode segment which causes the voltage on a segment to decrease in proportion to the current through that segment. The feedback resulted in the disappearance of a coherent azimuthal wave and a decrease in the time-averaged total discharge current by up to 13.2%.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Cross-field electron transport induced by a rotating spoke in a cylindrical Hall thruster

Rotating spoke phenomena have been observed in a variety of Hall thruster and other E x B devices. It has been suggested that the spoke may be associated with the enhancement of the electron cross-field transport. In this paper, the current conducted across the magnetic field via a rotating spoke has been directly measured for the first time in the E x B discharge of a cylindrical Hall thruster. The spoke current was measured using a segmented anode. Synchronized measurements with a high speed camera and a four-segment anode allow observation of the current as a function of time and azimuthal position. Upwards of 50% of the total current is conducted through the spoke, which occupies a quarter of the Hall thruster channel area. To determine the transport mechanism, emissive and Langmuir probes were installed to measure fluctuating plasma potential, electron density, and temperature. A perturbed, azimuthal electric field and density are observed to oscillate in-phase with the rotating spoke. The resulting drift current is found to enhance electron transport with a magnitude equal to the spoke current to within margins of error.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

A comparison of emissive probe techniques for electric potential measurements in a complex plasma

The major emissive probe techniques are compared to better understand the floating potential of an electron emitting surface in a plasma. An overview of the separation point technique, floating point technique, and inflection point in the limit of zero emission technique is given, addressing how each method works as well as the theoretical basis and limitations of each. It is shown that while the floating point method is the most popular, it is expected to yield a value {approx}1.5T{sub e}/e below the plasma potential due to a virtual cathode forming around the probe. The theoretical predictions were checked with experiments performed in a 2 kW annular Hall thruster plasma (n{sub e} {approx} 10{sup 9}-10{sup 10} cm{sup -3}and T{sub e} {approx} 10-50 eV). The authors find that the floating point method gives a value around 2T{sub e}/e below the inflection point method, which is shown to be a more accurate emissive probe technique than other techniques used in this work for measurements of the plasma potential.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Magnetically insulated baffled probe for real-time monitoring of equilibrium and fluctuating values of space potentials, electron and ion temperatures, and densities

By restricting the electron-collection area of a cold Langmuir probe compared to the ion-collection area, the probe floating potential can become equal to the space potential, and thus conveniently monitored, rather than to a value shifted from the space potential by an electron-temperature-dependent offset, i.e., the case with an equal-collection-area probe. This design goal is achieved by combining an ambient magnetic field in the plasma with baffles, or shields, on the probe, resulting in species-selective magnetic insulation of the probe collection area. This permits the elimination of electron current to the probe by further adjustment of magnetic insulation which results in an ion-temperature-dependent offset when the probe is electrically floating. Subtracting the floating potential of two magnetically insulated baffled probes, each with a different degree of magnetic insulation, enables the electron or ion temperature to be measured in real time.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Laser induced fluorescence measurements of the cylindrical Hall thruster plume

An investigation of a fully cylindrical Hall thruster was performed using laser induced fluorescence (LIF) to measure ion velocity profiles in the plume. The measurements confirm a previously reported 9% increase in the exhaust energy when the cathode keeper draws an excess current (overrun mode). Furthermore, the velocity directions in the plume remain relatively unchanged for the cusped and direct magnetic field configuration in both overrun and nonoverrun modes. Previously reported plume narrowing in the overrun mode was confirmed and found to be due to the shift of the acceleration and ionization regions toward the anode. The electric field inferred from the LIF measurements allowed calculation of the electron ExB drift. Close to the centerline of the thruster, electrons drift azimuthally with velocity decreasing away from the centerline, thus creating shear. This shear can be a source of plasma instabilities and influence electron transport. Further away from the centerline, electrons drift in the opposite direction with their velocity increasing with increasing radius. In that region, electrons rotate without shear.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Transition in electron transport in a cylindrical Hall thruster

Through the use of high-speed camera and Langmuir probe measurements in a cylindrical Hall thruster, we report the discovery of a rotating spoke of increased plasma density and light emission which correlates with increased electron transport across the magnetic field. As cathode electron emission is increased, a sharp transition occurs where the spoke disappears and electron transport decreases. This suggests that a significant fraction of the electron current might be directed through the spoke.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Mechanism of carbon nanostructure synthesis in arc plasma

Plasma enhanced techniques are widely used for synthesis of carbon nanostructures. The primary focus of this paper is to summarize recent experimental and theoretical advances in understanding of single-wall carbon nanotube (SWNT) synthesis mechanism in arcs, and to describe methods of controlling arc plasma parameters. Fundamental issues related to synthesis of SWNTs, which is a relationship between plasma parameters and SWNT characteristics are considered. It is shown that characteristics of synthesized SWNTs can be altered by varying plasma parameters. Effects of electrical and magnetic fields applied during SWNT synthesis in arc plasma are explored. Magnetic field has a profound effect on the diameter, chirality, and length of a SWNT synthesized in the arc plasma. An average length of SWNT increases by a factor of 2 in discharge with magnetic field and an amount of long nanotubes with the length above 5 {mu}m also increases in comparison with that observed in the discharge without a magnetic field. In addition, synthesis of a few-layer graphene in a magnetic field presence is discovered. A coupled model of plasma-electrode phenomena in atmospheric-pressure anodic arc in helium is described. Calculations indicate that substantial fraction of the current at the cathode is conducted by ions (0.7-0.9 of the total current). It is shown that nonmonotonic behavior of the arc current-voltage characteristic can be reproduced taking into account the experimentally observed dependence of the arc radius on arc current.

36 MATERIALS SCIENCE↗

Breakdown of a Space Charge Limited Regime of a Sheath in a Weakly Collisional Plasma Bounded by Walls with Secondary Electron Emission

A new regime of plasma-wall interaction is identified in particle-in-cell simulations of a hot plasma bounded by walls with secondary electron emission. Such a plasma has a strongly non-Maxwellian electron velocity distribution function and consists of bulk plasma electrons and beams of secondary electrons. In the new regime, the plasma sheath is not in a steady space charge limited state even though the secondary electron emission produced by the plasma bulk electrons is so intense that the corresponding partial emission coefficient exceeds unity. Instead, the plasma-sheath system performs relaxation oscillations by switching quasiperiodically between the space charge limited and non-space-charge limited states.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Local Scrape-Off Layer Control Using Biased electrodes in NSTX

An experiment was designed to test the theory that biased electrodes can affect the local scrape-off layer (SOL) width by creating a strong radial ExB drift [Cohen, R.H. and Ryutov, D.D, Nucl. Fusion 37, 621 (1997)]. These electrodes were located near the outer midplane in the SOL of the National Spherical Torus Experiment (NSTX). The electrodes were biased at up to {+-} 100 Volts, and the radial profile of the plasma between them was measured by an array of Langmuir probes. The biasing caused large changes in the local SOL profiles at least qualitatively consistent with this theory.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Effects of enhanced cathode electron emission on Hall thruster operation

Interesting discharge phenomena are observed that have to do with the interaction between the magnetized Hall thruster plasma and the neutralizing cathode. The steady-state parameters of a highly ionized thruster discharge are strongly influenced by the electron supply from the cathode. The enhancement of the cathode electron emission above its self-sustained level affects the discharge current and leads to a dramatic reduction in the plasma divergence and a suppression of large amplitude, low frequency discharge current oscillations usually related to an ionization instability. These effects correlate strongly with the reduction in the voltage drop in the region with the fringing magnetic field between the thruster channel and the cathode. The measured changes in the plasma properties suggest that the electron emission affects the electron cross-field transport in the thruster discharge. These trends are generalized for Hall thrusters of various configurations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗