Search NASA⌕ Search

Engineering topics

Randolph, James E.

Publications and source records attributed to Randolph, James E..

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2004

Enabling exploration with small radioisotope power systems

The purpose of this report is to provide an initial reference document to support further definition of science community needs for small-RPS flight systems. It describes the most recent results of the ongoing NASA/DOE studies, and provides information for review by potential users that might take advantage of these types of power systems. This is extremely important since any future decision to proceed with the development of such units will require a strong identified need from the space science community and a well-defined set of power and operational requirements. NASA and DOE intend to use this document as a basis for soliciting information on additional small-RPS-enabled mission concepts, along with their respective power and operational requirements. This report is a first step in fleshing out a roadmap for potential future development and acquisition.

Shirley, James H.↗
NASA NTRS1995

An Update on the FIRE (Solar Probe) Mission

A joint U.S.-Russian mission to the sun named FIRE is currently being planned. The mission consists of two spacecraft, one U.S. built and the other Russian built. Both spacecraft will be launched from a single vehicle, separate after launch, travel to Jupiter for a gravity assist that will maneuver the spacecraft into highly elliptical polar orbits about the sun. The U.S. spacecraft will have a perihelion of 4 Rs and the Russian 10 Rs. A full complement of in situ fields and particles instruments are planned for both spacecraft to measure acceleration mechanisms and other characteristics of the solar wind. The strawman payloads and expected science return will be discussed.

FIRE Mission↗
NASA NTRS1995

Solar Probe Technology Challenges

A mission close to the sun is only possible if new spacecraft technologies can be developed and incorporated into a state-of-the-art spacecraft concept. The perihelion goal of 4 solar radii requires a shielded spacecraft that can tolerate the 3000 suns solar flux while maintaining the electronics components at room temperature. In addition, the shield surface should sublimate at a rate of less than 3 mg/s at perihelion. Many shield configuration designs have been studied and the most promising is a parabolic shape that functions as both a shield and a large high gain antenna. The shield material chosen for this design is a carbon-carbon material with highly emissive surface properties. A mission requirement for a high telecommunications power stems from the expected interference when attempting to transmit data through the solar corona. It is expected that the large carbon-carbon shield/antenna will have a large power gain even at high temperatures and will return adequate telemetry at the X-band radio frequency chosen for the Solar Probe mission. Other key technology needs include a non-nuclear power subsystem that can function in the extreme environments of the mission from Earth to Jupiter and onward to a 4 solar radii perihelion.

Solar↗
NASA NTRS1992

Solar system 'fast mission' trajectories using aerogravity assist

Initial analyses of the aerogravity assist (AGA) delivery technique to solar system targets (and beyond) has been encouraging. Mission opportunities are introduced that do not exist with typical gravity assist trajectories and current launch capabilities. The technique has the most payoff for high-energy missions such as outer planet orbiters and flybys. The goal of this technique is to reduce the flight duration significantly and to eliminate propulsion for orbit insertion. The paper will discuss detailed analyses and parametric studies that consider launch opportunities for missions to the sun, Saturn, Uranus, Neptune, and Pluto using AGA at Venus and Mars.

Randolph, James E.↗
NASA NTRS1992

NASA and international studies of the Solar Probe Mission

A review is presented summarizing the history and current status of the studies of the Solar Probe Mission by NASA and other space agencies. The technology and scientific challenges of the mission are addressed in these studies and can be met with current instrument and technology capabilities. The specific set of experiments recommended by a scientific advisory group to the NASA study for integration into the design concept is discussed.

Randolph, James E.↗
NASA NTRS1991

A thermal shield concept for the Solar Probe mission

The Solar Probe spacecraft will travel to within 4 solar radii of the sun's center while performing a variety of fundamental experiments in space physics. Exposure to 2900 earth suns (400 W/sq cm) at perihelion imposes severe thermal and material demands on a solar shield system designed to protect the payload that will reside within the shield's shadow envelope or umbra. The design of the shield subsystem is a thermal/materials challenge requiring new technology development. While currently in the preproject study phase, anticipating a 1995 project start, shield preliminary design efforts are currently underway. This paper documents the current status of the mission concept, the materials issues, the configuration concept for the shield subsystem, the current configuration studies performed to date, and the required material testing to provide a database to support a design effort required to develop the shield subsystem.

Miyake, Robert N.↗
NASA NTRS1991

The NASA Solar Probe mission - In situ determination of interplanetary out-of-the ecliptic and near-solar dust environments

The NASA Solar Probe mission will be one of the most exciting dust missions ever flown and will lead to a revolutionary advance in our understanding of dust within our solar system. Solar Probe will map the dust environment from the orbit of Jupiter (5 AU), to within 4 solar radii of the sun's center. The region between 0.3 AU and 4 Rs has never been visited before, so the ten days that the spacecraft spends during each (of the two) orbit is purely exploratory in nature. Solar Probe will also reach heliographic latitudes as high as about 15 to 28 deg above (below) the ecliptic on its trajectory inbound (outbound) to (from) the sun. This, in addition to the ESA/NASA Ulysses mission, will help determine the out-of-the-ecliptic dust environment. A post-perihelion burn will reduce the satellite orbital period to 2.5 years about the sun. A possible extended mission would allow data reception for two more revolutions, mapping out a complete solar cycle. Because the near-solar dust environment is not well understood (or is controversial at best), and it is very important to have better knowledge of the dust environment to protect Solar Probe from high velocity dust hits, we urgently request the scientific community to obtain further measurements of the nearsolar dust properties.

Tsurutani, Bruce T.↗
NASA NTRS1990

Hypersonic maneuvering to provide planetary gravity assist

This paper examines the potential of aeroassist maneuvers at Mars for missions to the sun and to Pluto, using a high-lift/drag vehicle such as the waverider to perform an atmospheric 'fly-around' of Mars, in order to rotate the planetocentric velocity vector, thus adding to the rather small rotation due to gravity alone. A fly-around in one direction or the other can place the aphelion or the perihelion of the resulting orbit at the Mars distance, for missions toward the sun or toward Pluto, respectively. The parameters of such maneuvers are given as a function of earth launch velocity.

Mcronald, Angus D.↗