Engineering topics

Rao, Mohan D.

Publications and source records attributed to Rao, Mohan D..

4 records

NASA NTRS1991

Damping Of Vibrations In Graphite/Epoxy Structures

Report describes study of vibration-damping properties, in air and vacuum, of graphite/epoxy composite structural members joined by adhesives. Determines vibration-damping effects of specimens representative of members and joints of truss, particularly after gases and moisture trapped during manufacture released in vacuum. Damping ratios measured under free and forced vibrations and before and after outgassing in vacuum. Effects of end-support conditions and high and low temperatures on damping also measured.

Crocker, Malcolm J.↗

NASA NTRS1990

An improved method to determine vibration damping of materials and structural components

The present, improved frequency-domain technique for vibration-damping estimation involves the fitting of a 'best curve' for the measured frequency-response data near a resonance by means of a least-squares error criterion. The damping ratio and the undamped natural frequency are then computed using the coefficients of the rational fraction polynomial that had been determined on the basis of the curve-fitting technique. Attention is given to the results of this method's application to damping measurements for graphite-reinforced epoxy composites. The results obtained are superior to those of the 'half-power points' method.

Rao, Mohan D.↗

NASA NTRS1989

Measurement of damping of graphite epoxy composite materials and structural joints

The damping capacity of graphite epoxy materials and structural joints was evaluated. The damping ratio of different composite specimens and bonded joints were systematically evaluated under normal atmospheric conditions and in a vacuum environment. Free and forced vibration test methods were employed for measuring the damping ratios. The effect of edge support conditions on the damping value of a composite tube specimen was studied by using a series of experiments performed on the specimen with different edge supports. It was found that simulating a free-free boundary conditions by having no constraints at the ends gives the lowest value of the material damping of the composite. The accuracy of the estimation of the damping ratio value was improved by using a curve-fitting technique on the response data obtained through measurement. The effect of outgassing (moisture desorption) on the damping capacity was determined by measuring the damping ratio of the tube specimen in a vacuum environment before and after outgassing had occurred. The effects of high and low temperatures on the damping was also investigated by using a series of experiments on tube and beam specimens. An analytical model to study the vibrations of a bonded lap joint system was formulated. Numerical results were generated for different overlap ratios of the system. These were compared with experimental results. In order to determine the influence of bonded joints on the material damping capacity, experiments were conducted on bonded lap-jointed and double-butt-jointed specimens. These experimental results were compared with simple beam specimens with no joints.

Crocker, Malcolm J.↗

NASA NTRS1986

A study of the damping capacity of graphite epoxy composites in a vacuum

The damping properties of a graphite epoxy composite material (used in the construction of the Hubble Space Telescope) are measured under a variety of conditions in a vacuum chamber to simulate conditions in space. An improved method is proposed which utilizes several points of the response curve near a resonance to estimate the damping ratio and the undamped resonance frequency. The damping of a graphite epoxy tube is monitored for four weeks to study moisture desorption and temperature effects. A significant variation is observed in the damping ratio with temperature.

Rao, Mohan D.↗