Engineering topics

Rault, Didier F. G.

Publications and source records attributed to Rault, Didier F. G..

12 records

NASA NTRS1996

Aerothermodynamic Analysis of Commercial Experiment Transporter (COMET) Reentry Capsule

An aerothermodynamic analysis of the Commercial Experiment Transporter (COMET) reentry capsule has been performed using the laminar thin-layer Navier-Stokes solver Langley Aerothermodynamic Upwind Relaxation Algorithm. Flowfield solutions were obtained at Mach numbers 1.5, 2, 5, 10, 15, 20, 25, and 27.5. Axisymmetric and 5, 10, and 20 degree angles of attack were considered across the Mach-number range, with the Mach 25 conditions taken to 90 degrees angle of attack and the Mach 27.5 cases taken to 60 degrees angle of attack. Detailed surface heat-transfer rates were computed at Mach 20 and 25, revealing that heating rates on the heat-shield shoulder ,can exceed the stagnation-point heating by 230 percent. Finite-rate chemistry solutions were performed above Mach 10, otherwise perfect gas computations were made. Drag, lift, and pitching moment coefficients are computed and details of a wake flow are presented. The effect of including the wake in the solution domain was investigated and base pressure corrections to forebody drag coefficients were numerically determined for the lower Mach numbers. Pitching moment comparisons are made with direct simulation Monte Carlo results in the more rarefied flow at the highest Mach numbers, showing agreement within two-percent. Thin-layer Navier-Stokes computations of the axial force are found to be 15 percent higher across the speed range than the empirical/Newtonian based results used during the initial trajectory analyses.

Wood, William A.↗

NASA NTRS1995

Application of Direct Simulation Monte Carlo to Satellite Contamination Studies

A novel method is presented to estimate contaminant levels around spacecraft and satellites of arbitrarily complex geometry. The method uses a three-dimensional direct simulation Monte Carlo algorithm to characterize the contaminant cloud surrounding the space platform, and a computer-assisted design preprocessor to define the space-platform geometry. The method is applied to the Upper Atmosphere Research Satellite to estimate the contaminant flux incident on the optics of the halogen occultation experiment (HALOE) telescope. Results are presented in terms of contaminant cloud structure, molecular velocity distribution at HALOE aperture, and code performance.

Rault, Didier F. G.↗

NASA NTRS1994

Direct simulation Monte Carlo prediction of on-orbit contaminant deposit levels for HALOE

A three-dimensional version of the direct simulation Monte Carlo method is adapted to assess the contamination environment surrounding a highly detailed model of the Upper Atmosphere Research Satellite. Emphasis is placed on simulating a realistic, worst-case set of flow field and surface conditions and geometric orientations for the satellite in order to estimate an upper limit for the cumulative level of volatile organic molecular deposits at the aperture of the Halogen Occultation Experiment. A detailed description of the adaptation of this solution method to the study of the satellite's environment is also presented. Results pertaining to the satellite's environment are presented regarding contaminant cloud structure, cloud composition, and statistics of simulated molecules impinging on the target surface, along with data related to code performance. Using procedures developed in standard contamination analyses, along with many worst-case assumptions, the cumulative upper-limit level of volatile organic deposits on HALOE's aperture over the instrument's 35-month nominal data collection period is estimated at about 13,350 A.

Woronowicz, Michael S.↗

NASA NTRS1993

A systems approach to a DSMC calculation of a control jet interaction experiment

This study deals with the development of a methodology for numerically simulating the interaction of a reaction control system (RCS) jet with a low-density external flow. A European Space Agency (ESA) experiment was chosen as a test case since it provided experimental data that could validate some of the numerical results. The initial approach was to focus on several subproblems having direct relevance to the full interaction problem. This enabled different numerical methods to be separately investigated and validated for each part of the interaction problem. In this manner, the best methodology for solving the full interaction problem was developed. The subproblems considered in this study included typical RCS nozzle and plume flows, a flat plate at zero incidence, and the flow past the experimental test model without the control jet firing. Once these calculations were completed, a simulation was performed with a control jet operating at a relatively low density. The results from this latter simulation provided qualitative insight into the complex interaction process.

Tartabini, Paul V.↗

NASA NTRS1993

Aerodynamics of Shuttle Orbiter at high altitudes

The high-altitude/high-Knudsen number aerodynamics of the Shuttle Orbiter are computed from Low-Earth Orbit down to 100 km using three-dimensional direct simulation Monte Carlo and free molecule codes. Results are compared with Blanchard's latest Shuttle aerodynamic model, which is based on in-flight accelerometer measurements, and bridging formula models. Good comparison is observed, except for the normal force and pitching moment coefficients. The present results were obtained for a generic Shuttle geometry configuration corresponding to a zero deflection for all control surfaces.

Rault, Didier F. G.↗

NASA NTRS1993

On predicting contamination levels of HALOE optics aboard UARS using direct simulation Monte Carlo

A three-dimensional version of the direct simulation Monte Carlo method is adapted to assess the contamination environment surrounding a highly detailed model of the Upper Atmosphere Research Satellite. Emphasis is placed on simulating a realistic, worst-case set of flowfield and surface conditions and geometric orientations in order to estimate an upper limit for the cumulative level of volatile organic molecular deposits at the aperture of the Halogen Occultation Experiment. Problems resolving species outgassing and vent flux rates that varied over many orders of magnitude were handled using species weighting factors. Results relating to contaminant cloud structure, cloud composition, and statistics of simulated molecules impinging on the target surface are presented, along with data related to code performance. Using procedures developed in standard contamination analyses, the cumulative level of volatile organic deposits on HALOE's aperture over the instrument's 35-month nominal data collection period is estimated to be about 2700A.

Woronowicz, Michael S.↗

NASA NTRS1993

Aerodynamic characteristics of Magellan spacecraft in Venus upper atmosphere

The aerodynamic flight characteristics of the Magellan spacecraft in the Venus atmosphere are computed at a nominal altitude of 140 km over a wide range of incidence angles and roll angles. Computational methods are described which can be used to simulate flowfields in the transition and free molecular domains over vehicles of arbitrarily complex geometry. Values of the drag, lift, and transverse forces and of the pitch, yaw, and roll moments are given for incidence angles of -60 to 60 deg and roll angles of 0 to 360 deg. Transitional flow effects are quantified and shown to be small, but not negligible and should be accounted for if high accuracy is required.

Rault, Didier F. G.↗

NASA NTRS1993

Spacecraft contamination investigation by direct simulation Monte Carlo - Contamination on UARS/HALOE

A three-dimensional version of the direct simulation Monte Carlo method is adapted to study the contamination environment surrounding a highly detailed model of the Upper Atmosphere Research Satellite, with the ultimate goal of estimating the cumulative level of molecular deposits on critical optical surfaces of the Halogen Occultation Experiment. Emphasis is placed on describing the development of preprocessing codes that simplify the incorporation of geometry and outgassing data into the main run code. A novel use of parallel processing software allows use of multiple processors to solve different regions of the overall flowfield. Initial results relating to contaminant cloud structure, cloud composition, and statistics of simulated molecules impinging on the Halogen Occultation telescope's aperture plane are presented, along with data related to code performance.

Rault, Didier F. G.↗

NASA NTRS1993

Efficient Three-Dimensional Direct Simulation Monte Carlo for Complex Geometry Problems

The simulation of flowfields in the transition flow regime is notoriously difficult with high demands on computer resources (CPU time and storage) and user expertise/labor. This paper describes a new, efficient code which has been developed to simulate high Knudsen number flowfields in three dimensions about bodies of arbitrarily complex geometry. The algorithm has been tested over a wide range of conditions, from free molecular to near-continuum flow regimes, for slender and blunt bodies, for re-entry vehicles and spacecraft. A series of validation tests have been conducted using both wind-tunnel measurements and flight data.

Rault, Didier F. G.↗

NASA NTRS1993

Direct Monte Carlo Simulations of Hypersonic Viscous Interactions Including Separation

Results of calculations obtained using the direct simulation Monte Carlo method for Mach 25 flow over a control surface are presented. The numerical simulations are for a 35-deg compression ramp at a low-density wind-tunnel test condition. Calculations obtained using both two- and three-dimensional solutions are reviewed, and a qualitative comparison is made with the oil flow pictures highlight separation and three-dimensional flow structure.

Moss, James N.↗

NASA NTRS1992

Aerodynamic characteristics of a hypersonic viscous optimized waverider at high altitudes

The present paper addresses the applicability of the basic concept of waveriding at high altitudes, and the extent to which the large viscous forces degrade the aerodynamic performance of waveriders. The waverider under consideration was designed using a continuum flow methodology. It is shown that the lift-to-drag ratio of high-altitude/high-Knudsen-number waveriders can be expected to be significantly lower than their low altitude/low Knudsen number counterparts. The aerodynamic performance of a representative waverider which was optimized for a 90-km, Mach-25 application is studied for altitudes ranging from 97 km to 145 km and incidence angles of 0 to 30 deg. Typical values of the lift-to-drag ratio were computed to be in the range of 0 to 0.3. Friction forces are mostly responsible for this poor performance. Friction forces account for more than 93 percent of the drag and significantly reduce lift.

Rault, Didier F. G.↗

NASA NTRS1992

Procedure for Adapting Direct Simulation Monte Carlo Meshes

A technique is presented for adapting computational meshes used in the G2 version of the direct simulation Monte Carlo method. The physical ideas underlying the technique are discussed, and adaptation formulas are developed for use on solutions generated from an initial mesh. The effect of statistical scatter on adaptation is addressed, and results demonstrate the ability of this technique to achieve more accurate results without increasing necessary computational resources.

Woronowicz, Michael S.↗